INHOMOGENEOUS FLUCTUATION DISTRIBUTION IN THE OUTPUT OF STOCHASTIC RESONANCE SYSTEMS AND ITS APPLICATION

Inputting a periodic signal mixed with white noise into a bistable system, we find that the fluctuation distribution in the time series of the output is strongly inhomogeneous. In certain phase part fluctuation is very low under the stochastic resonance condition, and consequently, the signal-to-noise ratio (SNR) there is much higher than that of the input. This mechanism can be used to design a nonlinear receiver to extract the signed from noise with SNR three times higher than the largest SNR obtained so far by the optimal linear filter.     

无溶剂固相研磨法合成乙酰丙酮铝

以无机铝盐、乙酰丙酮(Hacac)为原料,固体碱为反应促进剂,室温下固相研磨合成了乙酰丙酮铝.考察了碱的用量及种类、物料摩尔比、研磨时间对产率的影响,并和经典方法作了对比,固相研磨法产率较高(90%以上).目标产物用红外、热重进行了表征,结果与标准谱图一致.最佳工艺条件为n(A l3+)∶n(Hacac)=10∶40,固体碱适量,室温研磨1 h.     

Copper-Catalyzed Enantioselective Synthesis of α-Hydroxyamine Using Monodentate Phosphoramidites

Development of new methods for the introduction of a nitrogen atom to a carbonyl group is still the most important synthetic target. Cu-catalyzed addition of organozinc reagents to α,β-unsaturated carbonyl compounds has been the subject of intensive investigation.[1] Moreover, trapping of the intermediate Zn-enolates has been achieved using nitrosobenzene. To demonstrate the feasibility of developing enantioselective variants of these tandem C-C bond formations,α,β-unsaturated substrates a～d was subjected to standard reaction conditions using Feringa's (L1*, L2*) and our own phosphoramidite ligands (L3*, L4*). In this reaction, medium to high levels of enantioselectivities were observed.     

用AFM研究DL-缬氨酸晶体的结构及其表面分子的排列

利用原子力显微镜(AFM)成像技术来观察DL-缬氨酸晶体表面分子的规则排列, 研究表明对映体分子在DL-缬氨酸晶体中相互配对排列, 每个晶胞单元中包含两个对映体分子, 属于具有中心对称结构 群, 整个晶体是消旋的. 通过原子力显微镜对DL-缬氨酸晶体表面重复单元的测量结果与X衍射数据对比, 发现用AFM观察到的DL-缬氨酸晶体中分子表面形貌的规整排列的距离, 同X衍射得出的三斜晶系晶胞参数数据基本一致, 由此判定该晶体属于三斜晶系而不是单斜晶系. 探讨了利用纳米技术的研究手段在分子水平研究生命起源中的手性问题, 在确定的晶面上通过分子周期性结构排列规律, 对DL-缬氨酸晶体表面分子进行手性识别.     

SYNTHESIS, SPECTRA AND ELECTROCHEMICAL PROPERTIES OF OXYGEN ADDUCTS OF TETRAKIS(2-ANILINOPYRIDINATO) DIRHODIUM COMPLEXES

Two oxygen adducts of different geometric isomers of the tetrakis(μ-2-anilinopyridinato) dirhodium unit, Rh_2(ap)_4~+, have been synthesized and characterized. Rh_2(ap)_4O_2(4,0) is the oxygen adduct 1 of 4, 0 isomer; and Rh_2(ap)_4O_2(2, 2) is the oxygen adduct 2 of 2, 2 isomer. The ESR spectra of both oxygen adducts show that there is a characteristic signal of a superoxide ion, g=2.03. The 4, 0 isomer with different axial ligands gives the order of A_Ⅱ values; O_2~-≈ClO_4~-相似文献   

焙烧温度对复合储氧材料性能的影响

自上世纪80年代初期以来,稀土铈氧化物(CeO2)作为一种储氧材料已在汽车三效催化剂(TWC)中得到了广泛应用。众所周知,CeO2在富氧和富燃条件下有储氧和释放氧的功能,CeO2在缺氧条件下可通过Ce4 转化成Ce3 而释放出氧气,在富氧条件下Ce3 又可氧化成Ce4 而吸收氧,即2CeO2(Ce2O3 1/2     

抗坏血酸为还原剂制备Se纳米线(英)

0IntroductionOne鄄dimensionalnanostructuressuchasnanowires,nanorods,ornanotubeshavebeenthesub鄄jectofintensiveresearchduetotheirpotentialuseasactivecomponentsorinterconnectsinfabricatingnanoscaleelectronicorelectromechanicaldevices[1].Theyalsorepresentane…     

乙酸促进邻甲基苯磺酸铜选择性催化醛与乙酸酐合成偕二乙酸酯反应

在室温无溶剂条件下,考察了乙酸促进邻甲基苯磺酸铜催化一系列芳香醛或脂肪醛与乙酸酐生成相应的偕二乙酸酯反应.结果表明,在乙酸存在条件下,邻甲基苯磺酸铜用量仅需占醛的0.3%(摩尔比)就能使反应在较短时间内完成.反应结束后,邻甲基苯磺酸铜经简单相分离可多次重复使用,催化活性无明显下降.     

超稠油供氢水热裂解改质降黏研究

通过超稠油水热裂解反应前后黏度、沥青质、硫质量分数等性质的变化，研究了超稠油进行水热裂解的主要影响因素及规律。结果表明，超稠油中含有一定量的硫是地层注蒸汽温度下进行水热裂解反应的前提。温度和时间对反应有很大影响。供氢剂中四氢萘对超稠油水热裂解影响最大。四氢萘供氢剂与硫酸镍催化剂复配使用对超稠油水热裂解有协同效应。水热裂解物理模拟实验表明,胜利单家寺油田超稠油通过供氢催化水热裂解降黏率可达70%以上。胶质、沥青质、硫质量分数降低，H/C原子比提高，超稠油得到一定程度的改善。     

高温固硫物相硫铝酸钙的生成过程研究

利用XRD、SEM和KZDL 4M型快速智能测硫仪对硫铝酸钙的形成过程及添加剂对其生成过程的影响进行了研究，探讨了硫铝酸钙的生成与分解反应机理及添加剂对其生成与分解反应的影响。结果表明，1150℃～1450℃能生成硫铝酸钙，同时伴存12CaO7Al2O3，温度高于1350℃时，硫铝酸钙发生分解生成3CaO·Al2O3； MgO在一定程度上利于硫铝酸钙的形成；Fe2O3在较低温下能促进硫铝酸钙的形成，高温下则促进其分解；而SiO2能有效抑制CaSO4的高温分解，却不利于硫铝酸钙的生成。