High-power high-stability Q-switched green laser with intracavity frequency doubling of diode-pumped composite ceramic Nd:YAG laser

We successfully obtain high-average-power high-stability Q-switched green laser based on diode-side-pumped composite ceramic Nd:YAG in a straight plano-concave cavity. The temperature distribution in composite ceramic Nd:YAG crystal is numerically analyzed and compared with that of conventional Nd:YAG crystal. By use of a composite ceramic Nd:YAG rod and a type-II high gray track resistance KTP (HGTR-KTP) crystal, a green laser with an average output power of 165 W is obtained at a repetition rate of 25 kHz, with a diode-to-green optical conversion of 14.68%, and a pulse width of 162 ns. To the best of our knowledge, both the output power and optical-to-optical efficiency are the highest values for green laser systems with intracavity frequency doubling of this novel composite ceramic Nd:YAG laser to date. The power fluctuation at around 160 W is lower than 0.3% in 2.5 hours.     

投稿须知北大核心CSCD

1．投稿著作所有列名作者皆同意在投稿文章经本刊刊登后,其著作财产权即转让与《强激光与粒子束》编辑部,但作者仍保有著作人身权,并保有本著作未来自行集结、教学等个人使用之权利。论文发表前作者需和编辑部签署《著作权让与合同》。本刊审稿周期为一般为90天,在此期间请勿一稿两投;签署《著作权让与合同》后一稿两投将追究法律责任。超过6个月没有审稿结果,作者可白行处理。     

无私奉献 鞠躬尽瘁 ——沉痛悼念常务副主编陈衍珍教授

中国化学会《电化学》期刊常务副主编、厦门大学化学化工学院陈衍珍教授因病医治无效,不幸于2015年12月25日溘然辞世. 这一突如其来的噩耗,犹如晴空霹雳,顿使《电化学》编委会、编辑部以及厦门大学电化学研究所全体同仁、师生愕然失色,悲恸不已,百感交集,哀思重重. 往昔如昨,其音容笑貌,恍若眼前.     

Low-loss terahertz waveguide with InAs-graphene-SiC structure

We demonstrate a low-loss terahertz waveguide based on the InAs-graphene-SiC structure. By analyzing the terahertz waveguide proposed in this paper, we can obtain that it is the characteristic of a low transmission loss coefficient(αloss≈0.55 dB/m) for fundamental mode(LP01) when the incident frequency is larger than 3.0 THz. The critical radii of the inside and outside cylinders have been found for the high-quality transmission. The large inside radius and the high transmission frequency result in a flat transmission loss coefficient curve. As a strictly two-dimensional material, the double graphene surface rings perform better to improve the quality of transmission mode. These results provide a new idea for the research of the long-distance THz waveguide.     

投稿须知

1.投稿著作所有列名作者皆同意在投稿文章经《强激光与粒子束》(简称《强》刊)刊登后,其著作财产权即转让给《强激光与粒子束》编辑部,但作者仍保有著作人身权,并保有本著作未来自行集结、教学等个人使用之权利。论文发表前作者需和编辑部签署《著作权让与合同》。本刊审稿周期为3个月,在此期间请勿一稿多投;签署《著作权让与合同》后一稿多投将追究法律责任。     

Growth and characterization of superconducting Ca1-xNaxFe2As2 single crystals by NaAs-flux method

High-quality superconducting Ca$_{1-x}$Na$_x$Fe$_2$As$_2$ single crystals have been successfully grown by the NaAs-flux method, with sodium doping level $x = 0.4$-0.64. The typical sizes of these crystals are more than 10 mm in $ab$-plane and $\sim 0.1$ mm along $c$-axis in thickness. X-ray diffraction, resistance and magnetization measurements are carried out to characterize the quality of these crystals. While no signature of magnetic phase transitions is detected in the normal state, bulk superconductivity is found for these samples, with a sharp transition at $T_{\rm c}$ ranging from 19.8 K ($x = 0.4$) to 34.8 K ($x = 0.64$). The doping dependences of the $c$-axis parameter and $T_{\rm c}$ are consistent with previous reports, suggesting a possible connection between the lattice parameters and superconductivity.     

无工质微波推力器推力测量实验

基于经典的电磁学理论, 本文建立了一套新概念空间推进装置-----无工质微波推力器系统, 这套装置可以直接把微波辐射能转换为推力而不需要任何推进介质. 与传统的空间推进装置不同, 该系统可以避免携带庞大的推进剂储箱并消除羽流对航天飞行器的污染. 该系统由集成在一起的圆台微波谐振腔、 微波源和负载组成, 其中微波源产生的微波辐射能被输入到圆台微波谐振腔内并形成纯驻波与电磁压强梯度, 从而沿圆台微波谐振腔轴线方向形成净推力. 本文根据随遇平衡原理, 通过克服推力器本身的自重和刚性阻力, 成功地测量出无工质微波推力器产生的净推力. 结果表明: 基于经典电磁学理论建立的无工质微波推进系统可以产生净推力; 当微波源输出2.45 GHz, 80---2500 W的微波功率时, 推力器产生的推力分布在70---720 mN范围内, 测量总误差小于12%.     

三七中Cu、Pb和Cd含量的不确定度评定

采用电感耦合等离子体-原子发射光谱法测定三七中Cu、Pb和Cd,对影响测定结果的不确定度来源进行了分析,在此基础上评定了分析结果的不确定度。研究表明,样品的重复性和校准曲线的拟合是影响不确定度的主要原因。     

电感耦合等离子体-质谱法测定工业硅中的痕量硼和磷

建立电感耦合等离子体-质谱法(ICP-MS)测定工业硅中痕量B和P的分析方法.采用HF-HNO3混合酸处理样品,对仪器工作参数进行优化,以Rh为校正内标,有效克服了基体效应及多元素分子离子干扰.分析结果表明,方法的检出限为:B为2.0μg·L-1、P为8.5μg · L-1,B和P的加标回收率分别为:97.2％-103.6％、95.2 ％-102.8％,精密度分别为2.6％、3.5％.方法可准确、快速测定工业硅中痕量元素B和P.     

两种消解法测定烟用接装纸中铬、铅和镉的比较

采用两种不同的样品消解法消解烟用接装纸样品,并采用电感耦合等离子体-发射光谱仪测定了其中的3种有害元素铬、铅和镉的含量,通过几组样品的测定结果对比,证明两种样品前处理方法均可用于实际样品测定.