Spectra Analysis of a Novel Ti-Doped LiAlO2 Single Crystal

LiAlO2 single crvstals doped with Ti at concentration 0.2at.% are grown by the Czochralskl technique with dimensions φ42×55mm. Ti ions in the crystal are quadrivalence proven by comparing the absorption and fluorescence spectra of pure LiAlO2 and Ti： LiAlO2. After air and Li-rich atmosphere annealing, the absorption peaks in the range of 600-800nm disappear. We conclude that 682 and 756nm absorption peaks are attributed to the VLi and Vo absorptions, respectively： The peaks at 716nm and 798nm may stem from the VLi^＋ and absorptions. The colour-centre model can be applied to explain the experimental phenomena. Ti^4＋-doping produces more lithium vacancies in the LiAlO2 crystal. The intensities of [LiO4] and the associated bonds remain unchanged, which improves the anti-hydrolyzation and thermal stability of LiAlO2 crystals.     

类铜离子的电子碰撞参数及其规律

用准相对论扭曲波方法系统地计算了Ｂａ、Ｎｄ、Ｇｄ、Ｙｂ、Ａｕ、Ｐｂ类铜离子组态能级之间的电子碰撞激发强度Ω（ｎｌ－ｎｌ），３≤ｎ≤７，４≤ｎ≤７，同时给出了高能极限的碰撞强度和外推到阈值的碰撞强度，用最小二乘样条方法拟合了全能域碰撞强度及热平均速率系数。对于一个激发过程，用１０个参数可以得到碰撞电子在任意能量下的碰撞强度以及任意温度下的速率系数。     

γ-LiAlO2晶体生长、改性和热学性质研究

采用快速提拉法生长出了透明、完整的γ-LiAlO2晶体,但是晶体的高熔点和易挥发性限制了γ-LiAlO2晶体质量.采用气相传输平衡法(vapor transport equilibration technique,VTE)工艺对晶体改性,半高宽(FWHM)值从116.9arcsec降至44.2arcsec,继续升高VTE处理温度至1300℃,FWHM值反而升高至55.2arcsec.快速提拉法生长出来晶体,[100]方向和[001]方向的热膨胀系数分别为17.2398×10-6/K,10.7664×10-6/K.经过三步VTE处理后[100]和[001]方向热膨胀系数降至16.6539×10-6/K和10.1784×10-6/K.     

喷气式Z箍缩等离子体辐射软X射线能谱的研究

研制了一台五通道ROSS-FILTER-PIN软X射线能谱仪，能谱范围为0.28—1.56keV.它由5个连续能段组成，每个能段的起止边由罗斯滤片对(ROSS-FILTERS)的L或K吸收边确定.罗斯滤片对的厚度通过优化计算得到，为了使每个通道的灵敏区外响应(即所测能段外响应)与通道总响应之比最小，在滤片对的第二滤片上镀上了一定厚度的第一滤片材料；为了缩减滤片表面积以增强低能滤片的抗冲击能力及方便滤片加工，能谱仪采用了小探测面积的PIN探测器(1mm²).借助此能谱仪，测量得到了喷气式Z箍缩(Z-pinch)等离子体辐射软X射线能谱的分布，并研究了软X射线产额随箍缩状况的变化趋势. 关键词： Z箍缩等离子体 罗斯滤片 软X射线能谱     

Photoluminescence characteristics of ZnTiO3: Bi nanocrystals

The photoluminescence properties of the Bi³⁺ in sol-gel derived ZnTiO₃ nanocrystals have been investigated. An ultra-violet emission at 360 nm and a visible emission band at 506 nm have been observed, originating from two kinds of emission centers. The former is ascribed to the ³P₁-¹S₀ transition of Bi³⁺ and the latter to the recombination of the electrons with the photo-generated holes trapped in the zinc vacancies. In all cases the latter contribution is predominant.     

Hierarchical structures in a turbulent pipe flow

A hierarchical structure (HS) analysis (β-test and γ-test) is applied to a fully developed turbulent pipe flow. Velocity signals are measured at two cross sections in the pipe and at a series of radial locations from the pipe wall. Particular attention is paid to the variation of turbulent statistics at wall units 10<y⁺<3000. It is shown that at all locations the velocity fluctuations satisfy the She–Leveque hierarchical symmetry (Phys. Rev. Lett. 72 (1994) 336). The measured HS parameters, β and γ, are interpreted in terms of the variation of fluid structures. Intense anisotropic fluid structures generated near the wall appear to be more singular than the most intermittent structures in isotropic turbulence and appear to be more outstanding compared to the background fluctuations; this yields a more intermittent velocity signal with smaller γ and β. As turbulence migrates into the logarithmic region, small-scale motions are generated by an energy cascade and large-scale organized structures emerge which are also less singular than the most intermittent structures of isotropic turbulence. At the center, turbulence is nearly isotropic, and β and γ are close to the 1994 She–Leveque predictions. A transition is observed from the logarithmic region to the center in which γ drops and the large-scale organized structures break down. We speculate that it is due to the growing eddy viscosity effects of widely spread turbulent fluctuations in a similar way as in the breakdown of the Taylor vortices in a turbulent Couette–Taylor flow at high Reynolds numbers.     

POROSITY CALCULATION OFMIXTURES OF FIBROUS PARTICLES

The initial forming of fiber blend to high green density, i.e. the packing of fibrous particles, is important to the reinforcement of composite materials. It is very useful to develop a general predictive method for the optimum selection of particle mixtures for the property control of ceramic or composite products. This paper presents such a mathematical model developed on the basis of the similarity analysis between the spherical and non-spherical particle packings and assesses its applicability to the packing of fibrous particles with discrete and/or continuous length distributions. The results indicate that the model can predict this packing system well and hence provide an effective way to solve various packing problems in the composite materials processing.     

HT—6M闭环反馈平衡控制系统

本文描述HT-6M托卡马克装置闭环反馈平衡控制系统的结构组成,通过对各个环节的简化,得到了有效实用的数学模型,进而分析了系统稳态和动态性能。实验结果表明,该系统运行可靠;并且,将等离子体环水平位移控制在2mm以内。     

液态铅的电阻率

采用精确的结构因数实验数据和Ｂｅｈａｖｉ模型赝势，用Ｚｉｍａｎ理论计算了液态铅的电阻率．计算结果和实验数据符合很好．讨论了Ｚｉｍａｎ理论对液态铅的适用性以及适合于液态铅的赝势的特征．