铑配合物催化丁烯氢甲酰化性能的研究

制备了一系列铑配合物,并对其催化丁烯氢甲酰化的催化性能进行了研究.在1-丁烯的反应中,RhCl(PPh3)3和trans-RhCl(CO)(PPh3)2的反应速度很慢,而RhH(CO)(PPh3)3、Rh(CO)2(acac)和 Rh(CO)(acac)(PPh3)三者反应速度都很快.而不同丁烯原料氢甲酰化的反应速度也各不相同,反应速度依次为1-丁烯》2-丁烯》异丁烯.     

凝胶-燃烧法合成YAG∶Eu3+纳米荧光材料的结构和发光性能

Y₃Al₅O₁₂∶Eu nanophosphors were synthesized by a gel combustion method. The structure of phosphors was characterized by XRD and FTIR. YAG phase came to occur when YAG∶Eu precursors were sintered at 800 ℃, although the phase was mainly amorphous. The organic groups pyrolyzed completely and pure YAG phase was obtained in the samples sintered at 900 ℃. In the formation of YAG phase, no intermediate phases such as YAP and YAM were detected. Both ⁵D₀ → ⁷F₁ orange and ⁵D₀ → ⁷F₂ red emission could be observed for all the sintered samples. However, the emission of amorphous samples was greatly different from that of crystalline ones. The former was mainly ⁵D₀→ ⁷F₂ red emission, but the latter was ⁵D₀ → ⁷F₁ orange emission. As sintering temperature rises, the ratio of orange to red for phosphors increases. Eu could be doped up to 8% in YAG host lattice, and fluorescence quenching was absent. It indicated that the gel combustion synthesis method can increase emission intensity and quenching concentration due to a good distribution of Eu³⁺ activators in Y₃Al₅O₁₂ matrix.     

微水相中改性Ultrastable-Y分子筛固定化脂肪酶拆分(R,S)-2-辛醇

采用改性Ultrastable-Y分子筛固定化P. expansum PED-03脂肪酶(PEL), 利用固定化PEL在微水相中对(R,S)-2-辛醇进行拆分. 结果表明, 改性Ultrastable-Y分子筛固定化PEL所催化的拆分反应的转化率(c)和对映体过量值(e.e.)以及对映体选择性(E)均得到大幅度提高. 介质类型和体系含水量对酶促拆分反应有较大的影响. 在以正己烷为溶剂, 含水量为0.8%的体系中, 于50 ℃反应24 h的转化率(c)可达到理论值的97.68%, 对映体过量值(e.e.)可达到98.75%. 改性Ultrastable-Y分子筛固定化PEL催化效率高、立体选择性强, 且催化性能稳定, 在(R,S)-2-辛醇的酶法拆分方面具有良好的应用前景.     

Pt碘乙二胺配合物的DFT和DV-Xα研究

利用密度泛函DFT/LANL2DZ和DV-Xα，对两种Pt(IV)碘配合物trans，cis-[Pt (OAc)_2I_2(en)] (A)，trans，cis-[Pt(OH)_2I_2(en)] (B)及它们的光照产物 [Pt(OAc)_2(OH)I(en)] (C)，[Pt(OH)_3I(en)] (D)完成了几何优化；计算了配合 物能级、光谱、前线轨道组成、电荷布居等性质。计算结果能解释有关的实验现象 。     

WATER STATES IN SBR BASED WATER SWELLING RUBBER

Water swelling rubber (WSR) was prepared by reaction blending SBR andsodium polyacrylate (PAANa). The existing states of water in the WSR was studied bymeans of DSC and TG. It was found that water exists in three states: nonfreezing water,bound freezable water and free water. The relationships between water states and structureof PAANa were investigated. The results showed that the amount of non-freezing waterwas related to total water content, and the ratio of non-freezing water versus -COONagroups on PAANa (mol/mol) was about 4. However, total water content slightly affectedthe content of bound freezable water and remarkably affected the amount of free waer.     

La0.8Sr0.2Ga0.8Mg0.2O2.8的电化学性质及其在SOFC中的应用

采用凝胶浇注法制备具有较高氧离子电导率的固体电解质La0.8Sr0.2Ga0.8Mg0.2O2.8粉料.X射线衍射结果表明,于1400℃焙烧后即形成了钙钛矿结构,无杂相存在.探讨了粉料压制坯体的致密化和导电性能在1450℃下与烧结时间的关系,发现烧结时间为18h时其相对密度达98.3%,而在24h的情况下,样品具有最佳的氧离子导电性.采用Ni-Ce0.8Gd0.2O1.9作为阳极,La0.8Sr0.2Ga0.6Ni0.4O2.7作为阴极,组装了平板型固体氧化物燃料电池(SOFC).阳极和阴极分别通入含3%H2O的氢气和空气,750℃时的开路电压为1.04V,最大输出功率密度(P)达252mW/cm2(U=0.48V,J=525mA/cm2).     

二茂铁硫醇自组装膜的电化学行为及其离子对效应

详细了研究１０－二基铁－１－癸硫醇（ＨＳＣ１０Ｆｃ）在金基底上形成的自组装单分子膜的电化学行为,发现ＨＳＣ１０Ｆｃ在金基底上形成稳定的自组装膜,并且在０．１ｍｏｌ／Ｌ的ＨＣｌＯ４溶液中表现出可逆的氧化还原行为,但其氧化还原峰的峰形和峰位极易溶液中阴离子种类和浓度的影响,考察了二茂铁自组装膜及通过后置换形成的二茂铁硫醇／十二烷基硫醇混合膜在混合电解液中的电化学行为,直接比较了两种不同阴离子与二茂铁阳     

耐晒大红BBN与表面活性剂双组分光催化降解

以表面活性剂十六烷基三甲基溴化铵(CTAB)和难溶有机颜料耐晒大红BBN(简称BBN)为双组分降解底物, 以TiO2为光催化剂, 研究双组分底物的光催化降解的快慢及规律, 双组分降解的相互影响, 初步建立双组分和催化剂之间的作用模型. 结果表明, pH值及底物的浓度对双组分体系的降解都有显著影响, 碱性条件更适合体系的降解, 在中性(pH=6.8)环境中两种底物的降解效果明显高于单组分的降解. 在碱性条件下(pH=9.2), 加入BBN使CTAB的降解速率略有下降. CTAB的浓度对BBN褪色速率影响较大, 当CTAB 的浓度为1 cmc 时, BBN和CTAB的降解速率都达到最快. BBN在TiO2表面吸附性强, 且被优先降解.     

光致变色冠醚部花菁染料的合成及其逆光致变色性

作者用含冠醚结构单元的2-甲基-苯并噻唑季铵盐与取代水物醛缩合得到了五个光致变色冠醚部化菁化合物。这些新的冠醚化合物具有逆光致变色性质, 较稳定的结构是开环部花菁式。     

ＳRN 1 反应及某些SET引发的链式反应的新进展

本文综述了近几年来 S_(RN)1反应及某些 SET 引发的链式反应的研宄进展。包括四方面,即有机杂环化合物的 S_(RN)1反应;在 S_(RN)1反应中作为亲核试剂的各种有机负离子;金属离子对 S_(RN)1反应的催化作用以及 S_(RN)1在合成应用方面的进展。