Preparation and Eh--pH diagrams of Fe(II)--Fe(III) green rust compounds; hyperfine interaction characteristics and stoichiometry of hydroxy-chloride, -sulphate and -carbonate

Fe(II)--Fe(III) hydroxy-chloride, -sulphate and -carbonate were prepared by oxidation of a ferrous hydroxide precipitate in anion-containing aqueous solutions. The compounds are characterized by monitoring the redox potential E_h and the pH of stochiometric suspension vs time with the appropriate concentration ratios. X-ray diffraction allows us to characterize the crystal structure by distinguishing “green rust one” (GR1) from “green rust two” (GR2). Since green rusts (GRs) are of a pyroaurite-sjögrenite-like structure, i.e., consisting of intercalated foreign anions and water molecules in the interlayers between the brucite-like layers of Fe(OH)₂, their chemical formulae can be determined from the Mössbauer spectra. Three quadrupole doublets are observed: D₁ and D₂ correspond to a ferrous state with isomershift IS of about 1.27 mm s^-1 and quadrupole splittings QS of about 2.85 and 2.60 mm s^-1, respectively, whereas D₃ corresponds to a ferric state with IS and QS of about 0.4 mm s^-1. The hyperfine parameters of these doublets are similar from one green rust to another but their intensity ratios vary considerably. Finally, E_h and pH equilibrium diagrams of the Fe species in the presence of chloride, sulphate and carbonate anions contained within the water solution are drawn and the thermodynamic conditions of existence and degrees of oxidation of green rusts are discussed.     

类铜离子的电子碰撞参数及其规律

用准相对论扭曲波方法系统地计算了Ｂａ、Ｎｄ、Ｇｄ、Ｙｂ、Ａｕ、Ｐｂ类铜离子组态能级之间的电子碰撞激发强度Ω（ｎｌ－ｎｌ），３≤ｎ≤７，４≤ｎ≤７，同时给出了高能极限的碰撞强度和外推到阈值的碰撞强度，用最小二乘样条方法拟合了全能域碰撞强度及热平均速率系数。对于一个激发过程，用１０个参数可以得到碰撞电子在任意能量下的碰撞强度以及任意温度下的速率系数。     

The Assessment of Reservation Prices of an Intermediate R&D Result and Patent Reward Under Oligopolistic Competitive Behaviour

One of the shortcomings of R&D evaluation is a lack of emphasis on analytical assessment of the value of an on-going R&D project. This paper addresses the problem concerning the distributive aspect of access to superior knowledge. Decision tree analysis and probability models appear to be appropriate tools for assessing the values of an intermediate result and patent reward of a firm's R&D decision in an environment of perfect information and oligopolistic competition. The assessed values are used as minimum prices acceptable to the firm when the knowledge is disseminated to the public. This paper will attempt to resolve this problem through the determination of the appropriate values of the reservation price of the first-stage invention in terms of the final reward and of a patent reward for which the inventor is willing to apply.     

线状锗等离子体X射线线谱的时间分辨测量

用自行研制的X射线条纹晶体谱仪首次测量了线状锗等离子体的X射线时间分辨谱。给出了类Ne-锗L线共振线的时间演化过程,并用类Ne-锗L线共振线与其双电子俘获伴线的相对强度比粗估了锗等离子体的电子温度及其随时间的变化,实验给出了X光激光增益区介质的电子温度为400～760eV,同时给出了电子温度保持相对恒定的时间不小于90ps(电子温度变化小于2％)。     

Experimental modelling of high frequency circuits at low audio frequencies part I

At microwave frequencies, frequent use is made in circuit design of the electrical properties of short lengths of resistively terminated transmission line. It will be shown in the following contribution that circuits based on high frequency distributed lines can usefully be modelled at low audio frequencies using lumped element lines.     

On the optimum set of polarization measurements for the scattering of two indentical fermions to determine the helicity amplitudes

The polarization asymmetries related to usual polarizations combine at least 4 different helicity amplitudes. The introduction of ±45° inclined transverse polarizations allows us to obtain the complete set of new polarization asymmetries combining only up to 3 helicity amplitudes. There are no further polarization asymmetries depending on a smaller number of helicity amplitudes. These expressions are most economical to determine the helicity amplitudes from observed data. Some of them are suitable to study especially the spin-flip effects. We give a complete Table of all such polarization asymmetries.     

A correspondence principle connecting IBVPs of wave propagation and heat conduction

A wave-heat correspondence principle is established by utilizing previous operational relations of van der Pol and Bremmer. By the suggested procedure, heat conduction problems can be solved by using an auxiliary wave-propagation problem in conjunction with the correspondence principle. A check on this procedure was provided by solving a mixed BVP of transient heat flow. The present correspondence principle is particularly useful in dealing with IBVPs involving wedge-shaped domains, and characteristic lengths.     

Bank-office Process Management in the Financial Services: a Simulation Approach Using a Model Generator

For the last ten years or so, developments in simulation software and methodology have been focused in two areas: (1) automating the model-building process; and (2) interfacing with other techniques and systems. That both academic and commercial research continues to be carried out in these areas is evidence of the continued popularity of the simulation technique. The most popular application areas where simulation modelling is used include manufacturing (engineering and process), warehousing and communications; not surprisingly, research and developments have therefore been concentrated in these areas. This paper describes the development of a simulation model generator for a different application area, that of clerical office processing of paper and documents for financial service companies. It outlines the reasons why there is a need for such a model generator and discusses the initial design requirements. The paper goes on to detail the developments and re-defined criteria required as the model generator brief changes as a result of practical applications.