Fast Liquid Phase Epitaxial Growth for Perovskite Single Crystals

Semiconductors grown by the solution-processed method have shown low-cost,facile fabrication process and comparable performance.However,there are many reasons why it is difficult to achieve high quality films.For example,lattice constant mismatch is one of the problems when photovoltaic devices made of organ metallic perovskites.In this work,MAPbBr^{MA=CH3NH3^+}perovskites single crystals grown on the surface of MAPbBr2.5 CI0.5 perovskites single crystals via liquid epitaxial growth method is demonstrated.It is found that when the lattice constants of the two perovskite single crystals are matched,another crystal can be grown on the surface of one crystal by epitaxial growth.The whole epitaxy growth process does not require high heating temperature and long heating time.X-ray diffraction method is used to prove the lattice plane of the substrate and the epitaxial grown layer.A scanning electron microscope is used to measure the thickness of the epitaxial layer.Compared with perovskite-based photodetectors without epitaxial growth layer,perovskite-based photodetectors with epitaxial growth layer have lower dark current density and higher optical responsibility.     

Et2Zn-mediated stoichiometric C(sp)-H silylation of 1-alkynes and chlorosilanes

A first example of an Et₂Zn mediated silylation of 1-aklynes is reported. A series of functional groups are tolerated in this reaction. Mechanistic studies support Zn alkynilides as intermediates in the reaction. This reaction protocol provides a practical method for the preparation of alkynylsilanes and expands the application of organometallic zinc in organic synthesis.     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

杂多酸催化合成乙酸乙酯

回流吸附法制备的负载型12-钨磷酸(HPW/C)是合成乙酸乙酯的高效催化剂。最佳反应条件下乙醇转化率达96％,酯化选择性100％。催化剂的高活性是由于HPW在活性炭上高度分散,使活性位增多,有效酸量增大。HPW/C还具有热稳定性高和不易流失等优点。     

LD泵浦Nd∶LuVO4/Cr4+∶YAG被动调Q激光器

采用大功率半导体激光器端面泵浦Nd∶LuVO4晶体，利用Cr4+∶YAG晶体作为可饱和吸收元件，实现了1.06 μm激光的被动调Q运转.在泵浦功率为19.1 W时，获得最高平均输出功率为4.58 W，脉冲宽度为84 ns，单脉冲能量为36.6 μJ以及峰值功率为436.2 W的激光脉冲.     

迈克尔逊干涉仪中补偿板与干涉条纹

通过分析缺失补偿板的迈克尔逊干涉仪中的附加光程差,推出干涉条纹满足的方程式,并用计算机模拟了动镜移动过程中变化的干涉条纹,与实验结果相一致.     

β-Si3N4电子结构和光学性质的第一性原理研究

采用基于密度泛函的平面波赝势方法(PWP)和广义梯度近似(GGA),计算了β相氮化硅(β-Si3N4)的电子结构和光学性质,得到的晶格常数、能带结构等均与实验结果较好符合.进一步还研究了β-Si3N4的光吸收系数以及禁带宽度随外压力的变化规律,为β-Si3N4材料在高压条件下的应用提供了理论参考.     

Single-mode rib polymer waveguides and electro-optic polymer waveguide switches

Mode-matching and effective index methods are used to analyze single-mode operation of optical rib polymer waveguides. Their single-mode waveguiding conditions are determined. Single-mode rib waveguides fabricated from guest–host polyetherketone are presented. The estimated propagation loss of straight rib-waveguides is 0.7 dB/cm at 1.55 μm. Furthermore, by using the mode field-transfer matrix method, 2×2 and 4×4 polymer Mach–Zehnder interference switch operating at 1.55 μm wavelength has been designed based on optical multi-mode interference.     

Electronic structure of the diaquabis(hydrogen malato) copper(II) crystal

Summary The electronic absorption and e.s.r. spectra of a crystal of the title compound [Cu(H₂O)₂ (C₄H₅O₅)₂] were recorded and experimental results are discussed quantitatively, using ligand field theory and the radial wave function of bound Cu^II. The electronic structure of the compound is consistent with its crystal structure.     

Solid-state Electrochemistry of Gadolinium Hexacyanoferrate Modified Electrode and Electrocatalytic Properties of Gadolinium Hexacyanoferrate

A new electroactive polynuclear inorganic compound of rare earth metal, gadolinium hexacyanoferrate (GdHCF), was prepared and characterized using the techniques of FTIR spectroscopy, thermogravimetric analysis (TG), UV-Vis spectrometry, X-ray photoelectron spectroscopy (XPS), ICP atomic emission spectroscopy, and EDX. The results of ICP atomic emission spectroscopy, EDX, and TGA indicated that the prepared GdHCF sample had a stoichiometry of NaGdFe(CN)₆·12H₂O (when GdHCF was prepared in NaCl solution). The FTIR spectrum of GdHCF showed that there were two types of water molecules in the structure of GdHCF: one was the interstitial water (5 H₂O), which resulted from the association of water due to H-bonding, and the other was water coordinated with Gd (7 H₂O). The results obtained using XPS showed that the oxidation state of Fe and Gd in the GdHCF sample was +2 and +3, respectively. GdHCF was immobilized on the surface of spectroscopically pure graphite (SG) electrode forming the GdHCF/SG electrode, and the solid-state electrochemistry of the resultant electrode was studied using cyclic voltammetry. The cyclic voltammetric results indicated that the GdHCF/SG electrode exhibited a pair of well-defined and stable redox peaks with the formal potential of E^0′=(197±3) mV. The effects of the concentration of the supporting electrolyte on the electrochemical characteristics of GdHCF were studied, and the results showed that the value of E^0′ increased linearly with the activity of the cationic ion of the supporting electrolyte (lga_Na⁺), with a slope of 54.1 mV, which may become a novel method for determining the activity of Na⁺ in solution. Further experimental results indicated that GdHCF had electrocatalytic activities toward the oxidation of dopamine (DA) and ascorbic acid (AA), and the electrocatalytic current increased linearly with the concentration of DA (or AA) in the range of 1.0–10.0 mmol·L^?1 (for DA) or 0.5–20.0 mmol·L^?1 (for AA).