Influence of focusing depth on the microfabrication of waveguides inside silica glass by femtosecond laser direct writing

We studied the influence of focusing depth on the index change threshold and damage threshold of silica glass irradiated by a focused 120 fs laser beam. Both thresholds increased with the focusing depth. The aspect ratio of the waveguide cross section can be selected by changing the focusing depth. A 5 mm long waveguide was written at the depth of 2100 μm, which was single mode at 632.8 nm and exhibited propagation loss of 0.56 dB/cm. The refractive index change was calculated to be ∼2.47×10^-3. The influence of the focusing depth should be considered in multi-layer devices as shown in the fabrication of a 3×3 waveguide array. PACS 42.62.-b; 42.82.Et; 81.05.Kf     

c轴定向氮化铝薄膜的制备

利用电子回旋共振 (ECR)微波增强化学气相沉积法 (PECVD)并使用氮气 (N2 ) ,氩气 (Ar)和AlCl3蒸气作为气源在直径为 6 .35cm的 (10 0 )单晶硅片表面制备了c轴定向氮化铝 (AlN)薄膜 ,并使用X射线衍射仪及其X射线特征能谱和扫描电镜 (SEM)分析了薄膜特征 ,研究了微波功率、基板温度和N2 流量对薄膜c轴定向的影响 ,得到了c轴偏差角小于 5°的高质量大面积AlN薄膜。     

一维应变压缩下TC4钛合金绝热剪切研究

 利用内径为57 mm的压缩气炮，在撞击速度为0.2~1.2 km/s（相应的靶中压力为3~15 GPa）范围内进行对称碰撞实验，以研究TC4（Ti-Al6-V4）钛合金在一维应变冲击压缩条件下的绝热剪切现象。对回收得到的受冲击样品，在扫描电镜（SEM）下进行细观金相分析。结果指出，一维应变冲击压缩条件下，TC4钛合金中绝热剪切带产生的对称碰撞速度阈值为500 m/s（相当于样品中的压力为5.87 GPa）；主剪切带与冲击方向约为45°角，带上有圆形和椭圆形两种孔洞且随碰撞速度的增大而增多和长大，这是典型的韧性损伤特征。随碰撞速度增大，产生与主剪切带成15°角的支剪切带。这些与理论预言相符。X射线能谱分析结果指出，剪切带内材料发生了(α+β)→β相的转变，是典型的相变带。剪切带的温度估算与实验提供的信息吻合。     

Specular reflectance of cold-rolled aluminum surfaces

The specular reflectance of cold-rolled aluminum surface is studied using a fiber optic system. An approximation for the determination of surface roughness is presented.     

Investigation on ultrafast thrid—order optical nonlinearity of metal（dmit）2／mnt）2 Charge transfer complexes

We have investigated the transient third-order optical nonlinearity of the solutions of Metal(dmit)2/(mnt)2 salts in acetone by employing femtosecond optical Kerr gate measurement at 830nm wavelength.An order of enhancement on the second-order hyperppolarizability is found for the above salts with central atoms of Cu and Ni.We have suggested an explanation for the enhancement based on the extension of electronic conjugation by the entring Cu or Ni atom.     

Thickness decrease of a grafted polyelectrolyte membrane exposed to shear flow

The effect of the shear flow on the thickness change of a polyelectrolyte membrane grafted onto a glass substrate was directly investigated with a flow cell combined with a confocal laser scanning microscope. The membrane thickness decreased proportionally to an increase in the shear stress of the flow when the shear rate exceeded a critical value of 1 s^?1. The higher the ionic strength was of the fluid, the greater the thinning effect was. The correlation between the critical shear rate and the relaxation of the polymer in the gel membrane was examined. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 2808–2815, 2003     

软x射线近贴显微技术

软x射线近贴显微技术不但可使活的生物样品成象,分辨率高于光学显微镜,而且人为的样品准备程序在该技术中都可避免。本文描述了用高功率激光打靶产生的等离子体作为软x射线源而进行的近贴显微研究,并得到了分辨率好于1μm的结果。     

Miniature InGaAsP/InP phase modulator for integrated opto-electronics

Miniature, etching ridge InGaAsP/InP Phase Modulator with highly efficient phase shifting efficiency of 60°/V.mm and 43°/V.mm for TE and TM modes, respectively, and 3 dB bandwidth of 650 MHz at 1.52 μm are reported. It is well suited for integrated opto-electronics. Some functions depending on bandwidth of the devices are discussed.     

乙醇增敏光泽精－H_2O_2－Pb（Ⅱ）化学发光体系的研究及应用

本文研究了Ｈ＿２Ｏ＿２氧化光泽精发光反应及乙醇的敏化作用，发现加入乙醇可使铅催化Ｈ＿２Ｏ＿２，氧化光泽精的发光强度有较大幅度的增强；铅量在３×１０￣（－７）～８×１０￣（－５）ｇ／ｍＬ。范围内与发光强度成正比．方法检出限为０．１０μｇ／ｍＬ；对含４μｇ／ｍＬＰｂ（Ⅱ）１１次重复测定，其ＲＳＤ为２．３％．对３２种常见的阴阳离子进行了干扰实验，表明方法具有较好的选择性。本法应用于水样及沉积物标样中痕量铅的测定，结果良好。     

劳动力供给带弹性的Solow模型

本文给出了在劳动力供给带弹性条件下的Ｓｏ１ｏｗ增长模型，给出了经济增长的黄金律和均衡处资本稳定性的证明，并且与不带弹性的Ｓｏｌｏｗ模型作了比较．