C12-s-C12•2Br和C12En混合水溶液的胶团化行为

季铵盐二聚表面活性剂C12 s C12•2Br（s=2、3、4、6）和非离子表面活性剂C12E10或C12E23在水溶液中生成混合胶团.其临界胶团总浓度cmcT值介于二元复配体系中各组分的临界胶团浓度和之间.当添加少量非离子型表面活性剂（在水溶液中的摩尔分数α2=0.1）时,混合胶团中C12E10或C12E23的摩尔分数均已超过0.35;随着溶液中非离子型表面活性剂含量的增大,混合胶团中逐渐以C12E10或C12E23成分为主.     

无外加催化剂条件下芳香醛与活性亚甲基化合物的缩合反应和迈克尔加成反应

在DMF溶剂中,不外加催化剂使芳香醛(1)与2,2-二甲基-1,3-二氧六环-4,6-二酮(2)发生缩合反应生成2,2-二甲基-5-芳亚甲基-1,3-二氧六环-4,6-二酮(3a～f)。在同样条件下,芳香醛与5,5-二甲基-1,3-环己二酮(4)则发生缩合和迈克尔加成反应生成2,2’-芳亚甲基双(3-羟基-5,5-二甲基-2-环己烯-1-酮)(5a～h)。用单晶X-射线分析法确定了产物5b的晶体结构。     

HPLC of amino acids and oligopeptides by pre-column fluorescence derivatization with N-hydroxysuccinimidyl-α-(9-phenanthrene)-acetate

Summary A sensitive LC method for the detection of amino acids and oligopeptides with pre-column fluorescence derivatization has been developed. Glycine, glycylglycine, triglycine, glutathione, glutamic acid, and cysteine were separated on a reversed-phase C₁₈ column with methanol-water-triethylamine eluent, derivatization and chromatographic conditions were optimized. The six derivatives were eluted in 20 min with good reproducibility. The relative standard derviations (n=6) at an analytical concentration of 2×10⁻⁶ M are <5%. Detection limits (signal-to-noise ratio=3) for the six derivatives are 23–68 fmol.     

Transition metal complexes of the Schiff bases derived from S-alkyldithiocarbazate with 2-pyridinecarboxaldehyde N-oxide—I. Synthesis, properties and structure of four-coordinate copper(II) complexes

Two new Schiff bases (SMPDH and SBPDH) of S-methyl- and S-benzyl-dithiocarbazate with 2-pyridinecarboxaldehyde N-oxide were prepared and confirmed by elemental analyses and IR spectra. Four copper(II) complexes of the above two Schiff base ligands with imidazole and pyridine were obtained and characterized spectroscopically. The crystal structure of [Cu(SMPD)ImH]ClO₄ was determined by X-ray diffraction analysis. The geometry of the copper atoms in these complexes is square planar with an unsymmetrical environment.     

P(i-BuNCH2CH2)3N: an efficient ligand for the direct alpha-arylation of nitriles with aryl bromides

A new catalyst system for the synthesis of alpha-aryl-substituted nitriles is reported. The bicyclic triaminophosphine P(i-BuNCH(2)CH(2))(3)N (1b) serves as an efficient and versatile ligand for the palladium-catalyzed direct alpha-arylation of nitriles with aryl bromides. Using ligand 1b, ethyl cyanoacetate and primary as well as secondary nitriles are efficiently coupled with a wide variety of aryl bromides possessing electron-rich, electron-poor, electron-neutral, and sterically hindered groups.     

Analysis of Five Pharmacologically Active Compounds from Rhodiola for Natural Product Drug Discovery with Capillary Electrophoresis

A rapid capillary electrophoresis method for the separation of five natural pharmacologically active compounds from extracted Rhodiola, namely salidroside, tyrosol, rhodionin, gallic acid and ethyl gallate has been developed. The separation of five natural pharmacologically active compounds was carried out in a fused-silica capillary with 14 mM boric acid, 30 mM SDS and 2.5% acetonitrile, adjusted to pH 10.7 with NaOH. Applied potential was 21kV. The temperature of the capillary was maintained at 25 °C by the instrument thermostating system, with the correlation coefficients of 0.9805–0.9989 for migration time, and relative standards of < 3.52% for peak areas. The established method is rapid and reproducible for the separation of five natural pharmacologically compounds from extracts of Rhodiola with satisfactory results.     

Synthesis and magnetic properties of the one-dimensional linear chain structure cyano-bridged complex [Cu(teta)(H2O)2][Cu(teta) Fe(CN)6]ClO4·2H2O (teta=5,7,7,12,14,14-hexamethyl-1,4,8,11-tetraazacylotetradecane)

Reaction of either K₃[Fe(CN)₆] or K₄[Fe(CN)₆] with a macrocyclic Cu^II complex, [Cu(teta)](ClO₄)₂ (teta = 5,7,7,12,14,14-hexamethyl-1,4,8,11-tetraazacylotetradecane), in aqueous solution gave the same product as shown by spectroscopic and physicochemical characterisation. The crystal structure of the complex shows that it is a one-dimensional linear chain type heterobinuclear Fe^III–Cu^II polymer. The unit is composed of a [Cu(teta)(H₂O)₂]²⁺ cationic complex, a Fe^III–Cu^II alternate linear chain unit, a ClO ₄ ^– ion and four water molecules. The Cu atom is coordinated in a distorted octahedral arrangement by four nitrogen atoms from one teta ligand and two nitrogen atoms of the bridging cyanide groups. The Cu—N bond distances involving the cyanide bridges, 2.522(7) and 2.608(7)Å, respectively, indicate weak antiferromagnetic interactions between the Fe^III and Cu^II atoms.