MCM-41表面氧化铜的分散研究

金属离子修饰的M41S介孔分子筛催化剂体系是当前多相催化剂研究的热点.虽然有关介孔分子筛金属离子修饰的方法有多种[1],但均存在着负载的金属粒子在载体表面负载量低或分散不均匀等缺点;采用本课题组的有机官能团化法[2]可以得到高分散度和高负载量的介孔分子筛负载金属氧化物     

Simulation Analysis on the Profiles of Droplets Wetting on the Substrates

To study the structural characteristics and physical properties of droplets sitting on the inclined substrates and cylindrical surfaces, wetting experiments are conducted in different cases. The profile curves of the droplets are recorded and extracted by a CCD camera and image processing, respectively. Contact angles are figured out by fitting the profile curves and taking the derivative at the front and rear triple points. Based on the experimental results, a Surface Evolver is employed to simulate the morphological changes by minimizing the total energy of the system. Furthermore, theoretical shapes and feature parameters, including the heights and the spreading distances of the droplets, which are hard to obtain by normal experimental measurements are provided. The contact-angle hysteresis when the heavy droplet sitting on the inclined substrate is discussed. Meanwhile, the evolutions of the contour of the three-phase contact line are predicted when heavy droplets spread on the convex and concave cylindrical surfaces, respectively. This study provides a finite-element analysis method to describe the surface properties of molten droplets on different substrates, and the simulation results agree well with the experimental results.     

国产硅藻土吸附尿激酶机理的研究

在常温下, 尿激酶在浙江土和吉林土表面的吸附等温线分别为V型和II型; 焙烧后两者皆转为III型。吸附等温线类型与硅藻土表面结构、孔结构、表面ζ电位有关。在400℃焙烧的硅藻土等电点值最低, 吸附量最大; 改性后, 吸附量也发生改变。本文还测定了尿激酶在硅藻土表面的吸附形态, 其吸附等温线方程符合0/(1-0)=(Kc)^1/β, 并讨论了平衡常数K和尿激酶吸附功能链段数β随温度的变化。     

On the reasons for the discrepancies in the data on methanol adsorption on platinum

In the voluminous and valuable information obtained by the radioactive tracers method on the adsorption of organic substances, some data are at variance with the results of the electrochemical methods. The most typical in this respect are the data on methanol adsorption on platinum.A comparative study of methanol adsorption by the radioactive tracers method with the use of ¹⁴C and by the electrochemical methods has shown that the reason of the discrepancies in these data is the presence of impurities containing ¹⁴C in labeled methanol samples. It is suggested that these impurities are autoradiolysis products.     

DFT Study on the Effect of Hydrogen-bond Formation on the Adsorption of Aminotriazines on Graphene

DFT calculations have been performed to explore the aminotriazine adsorption on graphene surfaces.Relative energies,equilibrium geometries and electronic structures of monomer and dimer of aminotriazine molecules adsorbed at the surface were investigated and analyzed in details.It was found that the hydrogen atoms in the NH2 group of aminotriazine molecules are directed toward the graphene surface,and the adsorption energy increases as the NH2 group is added.The adsorbed aminotriazine molecules facilely form a dimer through the hydrogen bonding interactions,and the two aromatic rings of optimized structure of 2-amino-1,3,5-triazine(B) dimmer(denoted by B2) and melamine(D) dimmer(denoted by D2) are parallel to the graphene sheet.The large deviation of the averaged adsorption energy of B2 and D2 compared to monor adsorption may reflect the increase of π-π repulsion and the effect of hydrogen bond formation.The electronic structure analyses reveal that the formation of hydrogen bonds in melamine dimer has great influence on the adsorption mode at the graphene surface.     

Investigations on the influence of the substrate on the crystal structure of sputtered LiCoO2

The influence of the uppermost substrate layer on the structural properties of sputtered lithium cobalt oxide (LiCoO₂) is discussed in this work. For this purpose, bare, oxidized, and platinum-coated silicon wafers, as well as stainless steel and titanium sheets, were used as substrates. The resulting crystal structure of LiCoO₂ deposited on these substrates was analyzed and discussed. The LiCoO₂ thin films were deposited by RF magnetron sputtering with different film thicknesses. A subsequent annealing step at 700 °C was performed to induce the crystallinity of LiCoO₂. The crystal orientation was determined by X-ray diffraction. The obtained results show a strong dependency of LiCoO₂'s crystal structure on the surface the film is deposited on. However, the strong influence of the film thickness reported in previous publications could not be observed. If LiCoO₂ is deposited on the substrates with a metallic surface, a strong (003) preferential orientation is obtained for a wide range of film thicknesses. In contrast, sputtering of LiCoO₂ on bare and on oxidized silicon wafers results in a (101) dominated crystal structure for the different film thicknesses. These experiments show the importance of the characterization of LiCoO₂'s crystal structure in the intended battery setup.     

浅析环境空气样品采集的影响因素

环境空气质量中的气态污染物的监测监测结果的准确可靠,除了实验测试条件的掌控、测试人员的技术水平外,还与样品的采集过程有关.作为常规例行监测的项目,空气中二氧化硫、二氧化氮的监测已进行多年.作者在实际工作中发现,样品采集的影响因素对监测结果产生直接的影响,但这些因素往往被忽视.本文将从最常见、常常被人忽视而对监测结果直接产生影响的环境温度、采样瓶阻力和动力系统等方面进行分析.     

Study on the stability of the serotonin and on the determination of its acidity constants

The present work aimed at describing the spectral behaviour of the serotonin and to evaluate its acidity constants using three different methods, using two spectrophotometry titrations and a third method that involved point-by-point analysis, which permitted to monitor closely and determine the evolution of the serotonin species in solution as a function of time. The three methods allowed estimation of three acidity constants associated to the same number of functional groups that form part of the molecule. The results given by the point-by-point analysis were: log(beta1) = 24.95 +/- 0.12; log(beta2) = 20.20 +/- 0.10; log(beta3) = 10.89 +/- 0.018.     

关于变价态奎宁电极的研制与Ph对电极斜率影响的探讨

本文研究在两种质子化状态存在时奎宁的电极行为与特点,证明在不同pH溶液中变价态奎宁电极电位不能直接用能斯脱公式或Nicolsky-eisenman公式表出,提出了变价态电极的S-σ经验或,并依据此式,用奎宁选择性电极测出20℃下I=0.5McIlvaine缓冲液双质子化奎宁,辛可宁、硫胺的Ka1分别为(8.37±0.96)x10[-5],(8.00±0.92)x10[-5].(8.37±0.96)x10[-6].指出:同系列溶剂介电常数增大,液膜电极斜率增大,存在S-1/ε线性关系,电极可用于奎宁的电位滴定法或直接电位法测定。     

Microcalorimetric investigations on the influence of propolis on the bacterium micrococcus luteus

Propolis or bee-glue is the third important product of honey bees after honey and wax. Known for thousands of years for its curative effects it is finding evermore attention in alternative and classical therapy in recent times against, e.g. infections, inflammations, dermatologic diseases and in wound healing.

Microcalorimetric experiments were performed on the influence of several propolis samples from Germany, Uruguay, Ethiopia and of a commercial propolis tincture on growth and metabolism of the recommended gram-positive bacterium Micrococcus luteus. Propolis extracts were prepared following established recipies for the water-soluble and insoluble components and the precipitate.

Addition of these extracts to a growing M. luteus culture in different growth phases resulted in a strong decline of the heat production rate, a prolongation of the lag phase or an introduction of a new, second lag phase, while the form of the calorimetric power-time curve remained unchanged. The calorimetric response showed a linear dependence on the propolis concentration. Although the quantitative gain of the extracts from the different propolis samples was nearly constant, the effects varied considerably between the specimens used.

The calorimetric investigations were supplemented by polarographic oxygen monitoring and by the standard agar well technique to determine the growth inhibition factor of the propolis extracts.     

基于分离粒子随机扩散理论的色谱模拟

为了对扩散分子的轨迹实施动态追踪与模拟, 深入理解分子扩散对色谱动力学的影响, 本文利用微尺度受限空间随机行走的模拟方法对色谱填充柱中的分子扩散过程进行了模拟. 重点考察了固定相的填充率、固定相的形状和柱长对色谱动力学行为的影响. 模拟结果表明短柱和大填充率具有较高的柱效; 在相同的密堆排列下, 固定相形状对分子扩散过程影响微弱; 待分离粒子的运动表现出微尺度空间限域的扩散特征, 但粒子的流动行为会随外部压力的增大而增加. 本论文提出的模拟方法对于发展高效能色谱, 开发新型分离技术等具有参考意义.     

第三相界面对高分子共混物粗化过程的影响研究

共混物相分离的机理已有研究［１］．但对共混物分散相的粗化过程的研究则不多见．１９７７年,Ｃａｈｎ等［２］预言第三相界面与低分子共混物之间存在的浸润作用对相分离过程应有较大影响．近年Ｔａｎａｋａ等［３］的研究结果表明,在几何空间受限的条件下,含有小分子...     

铅锑电极上PbO2生长过程的研究

应用电位阶跃和阻抗跟踪法,考虑基底铅氧化电流的影响,研究了铅锑电极上PbO₂的生长过程,探讨了锑对这一过程的影响。铅锑电极上PbO₂生长过程符合二维瞬时成核和生长过程机理,锑将抑制这一过程的进行。     

Fabrication on the Flexible Supercapacitor Based on the Polypyrrole Deposited on Polyethylene/Polypropylene Non-Woven Film

Russian Journal of Electrochemistry - Non-woven films of polypropylene/polyethylene (PP/PE) are usually used as filter membrane or diaphragm because of their excellent mechanical strength and...     

Quantum calculations on the adsorption of halide ions on the noble metals

The interaction of halide ions with the three noble metals has been investigated using the B3LYP density functional method and the cluster model approximation. The results of calculations for the M—X⁻ and M₁₂—X⁻ (M = Cu, Ag, Au; X = F, Cl, Br, I) systems are presented. At the (100) surface, modeled in the present work by the M₁₂ cluster, all halide ions have been found to adsorb preferentially at the hollow site, followed by the bridge and by the top positions. The adsorption energy has been found to decrease when going from fluoride to iodide in both atom—ion and cluster—ion cases. The opposite trend is observed for the estimates of the charge transfer from the ions to the surface. When different metals are compared, the M₁₂—X⁻ interaction energies decrease in the order Au > Ag > Cu, but for the smaller ions some deviations from this line do appear. The relative values of the calculated harmonic vibrational frequencies do agree with those found experimentally, but their magnitude is much smaller as a result of the effect of the lower surface coverage.     

基于TGA-FTIR联用技术的EVA热解研究

采用热重-傅里叶变换红外光谱联用技术研究了在N2气氛下乙烯-乙酸乙烯酯共聚物(EVA)的热稳定性及其分解失重情况；实验首先单独使用热重分析仪考察了EVA在不同升温速率下的失重情况；然后采用热-红联用技术对EVA失重过程中的逸出气体进行考察；由实验结果可以明显地看出，EVA的分解失重分为两个阶段，并且随着升温速率的增大EVA的起始失重温度有所增加；第一个失重阶段所放出的气体经傅里叶变换红外光谱扫描并与标准气相谱库中乙酸的标准红外谱图对照后确定为乙酸，第二个失重阶段是由于碳氢链段的分解而引起的；最后根据升温速率为5℃／min时EVA第一个失重阶段的失重率计算得出EVA样品中乙酸乙烯酯的含量为31．8%(ω)。