国产硅藻土吸附尿激酶机理的研究

在常温下, 尿激酶在浙江土和吉林土表面的吸附等温线分别为V型和II型; 焙烧后两者皆转为III型。吸附等温线类型与硅藻土表面结构、孔结构、表面ζ电位有关。在400℃焙烧的硅藻土等电点值最低, 吸附量最大; 改性后, 吸附量也发生改变。本文还测定了尿激酶在硅藻土表面的吸附形态, 其吸附等温线方程符合0/(1-0)=(Kc)^1/β, 并讨论了平衡常数K和尿激酶吸附功能链段数β随温度的变化。     

DFT Study on the Effect of Hydrogen-bond Formation on the Adsorption of Aminotriazines on Graphene

DFT calculations have been performed to explore the aminotriazine adsorption on graphene surfaces.Relative energies,equilibrium geometries and electronic structures of monomer and dimer of aminotriazine molecules adsorbed at the surface were investigated and analyzed in details.It was found that the hydrogen atoms in the NH2 group of aminotriazine molecules are directed toward the graphene surface,and the adsorption energy increases as the NH2 group is added.The adsorbed aminotriazine molecules facilely form a dimer through the hydrogen bonding interactions,and the two aromatic rings of optimized structure of 2-amino-1,3,5-triazine(B) dimmer(denoted by B2) and melamine(D) dimmer(denoted by D2) are parallel to the graphene sheet.The large deviation of the averaged adsorption energy of B2 and D2 compared to monor adsorption may reflect the increase of π-π repulsion and the effect of hydrogen bond formation.The electronic structure analyses reveal that the formation of hydrogen bonds in melamine dimer has great influence on the adsorption mode at the graphene surface.     

Effect of the temperature on the thermodynamic characteristics of the ion-exchange separation of substances on ionites

The basic results on the effect of temperature on the equilibrium and thermodynamic characteristics of ion-exchange systems and the use of this effect in developing reagentless methods for ion-exchange separation are considered.     

Investigations on the influence of the substrate on the crystal structure of sputtered LiCoO2

The influence of the uppermost substrate layer on the structural properties of sputtered lithium cobalt oxide (LiCoO₂) is discussed in this work. For this purpose, bare, oxidized, and platinum-coated silicon wafers, as well as stainless steel and titanium sheets, were used as substrates. The resulting crystal structure of LiCoO₂ deposited on these substrates was analyzed and discussed. The LiCoO₂ thin films were deposited by RF magnetron sputtering with different film thicknesses. A subsequent annealing step at 700 °C was performed to induce the crystallinity of LiCoO₂. The crystal orientation was determined by X-ray diffraction. The obtained results show a strong dependency of LiCoO₂'s crystal structure on the surface the film is deposited on. However, the strong influence of the film thickness reported in previous publications could not be observed. If LiCoO₂ is deposited on the substrates with a metallic surface, a strong (003) preferential orientation is obtained for a wide range of film thicknesses. In contrast, sputtering of LiCoO₂ on bare and on oxidized silicon wafers results in a (101) dominated crystal structure for the different film thicknesses. These experiments show the importance of the characterization of LiCoO₂'s crystal structure in the intended battery setup.     

La传感器在测定铝液凝固过程中La活度研究

微量稀土加入铝或铝合金中，如果加入方法、数量、时间得当，可明显改善材料的多项性能．稀土对铝及铝合金的影响规律和作用机理，已取得了一些进展，但对稀土铝合金的热力学性质，尤其是溶解态稀土的研究少有报导［‘，2］．本工作采用L即．95C。。。。FZ。。多晶作为固体电解     

第三相界面对高分子共混物粗化过程的影响研究

共混物相分离的机理已有研究［１］．但对共混物分散相的粗化过程的研究则不多见．１９７７年,Ｃａｈｎ等［２］预言第三相界面与低分子共混物之间存在的浸润作用对相分离过程应有较大影响．近年Ｔａｎａｋａ等［３］的研究结果表明,在几何空间受限的条件下,含有小分子...     

Study on the stability of the serotonin and on the determination of its acidity constants

The present work aimed at describing the spectral behaviour of the serotonin and to evaluate its acidity constants using three different methods, using two spectrophotometry titrations and a third method that involved point-by-point analysis, which permitted to monitor closely and determine the evolution of the serotonin species in solution as a function of time. The three methods allowed estimation of three acidity constants associated to the same number of functional groups that form part of the molecule. The results given by the point-by-point analysis were: log(beta1) = 24.95 +/- 0.12; log(beta2) = 20.20 +/- 0.10; log(beta3) = 10.89 +/- 0.018.     

软段结构对聚氨酯性能影响的研究

用熔融缩聚法俣成了己二酸系和己二酸／芳香二酸混合系两个系列的聚酯；同溶液一步法将部分聚酯与ＭＤＩ反应，形成一系列聚酯型氨酯，以化学分析，ＶＰＯ，ＩＲ，ＤＳＣ，ＷＡＸＤ，力学拉伸等手段对聚酯和聚氨酯进行了表征；讨论了软段聚酯的结构对聚氨酯的结晶性，耐热性，粘结性等性能的影响。     

取代基对螺噁嗪类化合物光致变色性能影响的探究

本文合成了4种螺噁嗪类化合物,并通过FTIR、1H NMR、ESI-MS对其结构进行了表征。研究了吲哚环上氮原子和噁嗪环9′位不同的取代基及溶剂化效应对其光致变色性能的影响。结果表明,吲哚环的氮原子引入体积较大的基团对螺噁嗪最大吸收波长无明显影响,然而有利于开环体的稳定性,且溴原子的引入会影响螺噁嗪的光响应性;噁嗪环9′位上的供电子基团会降低螺噁嗪的开环体稳定性;螺噁嗪开环体的褪色过程符合一级动力学方程;在非质子溶剂中,螺噁嗪开环体的最大吸收波长呈现正向溶剂化效应;有机酸的加入,可以增加开环体的热稳定性。     

MCM-41表面氧化铜的分散研究

金属离子修饰的M41S介孔分子筛催化剂体系是当前多相催化剂研究的热点.虽然有关介孔分子筛金属离子修饰的方法有多种[1],但均存在着负载的金属粒子在载体表面负载量低或分散不均匀等缺点;采用本课题组的有机官能团化法[2]可以得到高分散度和高负载量的介孔分子筛负载金属氧化物     

Simulation Analysis on the Profiles of Droplets Wetting on the Substrates

To study the structural characteristics and physical properties of droplets sitting on the inclined substrates and cylindrical surfaces, wetting experiments are conducted in different cases. The profile curves of the droplets are recorded and extracted by a CCD camera and image processing, respectively. Contact angles are figured out by fitting the profile curves and taking the derivative at the front and rear triple points. Based on the experimental results, a Surface Evolver is employed to simulate the morphological changes by minimizing the total energy of the system. Furthermore, theoretical shapes and feature parameters, including the heights and the spreading distances of the droplets, which are hard to obtain by normal experimental measurements are provided. The contact-angle hysteresis when the heavy droplet sitting on the inclined substrate is discussed. Meanwhile, the evolutions of the contour of the three-phase contact line are predicted when heavy droplets spread on the convex and concave cylindrical surfaces, respectively. This study provides a finite-element analysis method to describe the surface properties of molten droplets on different substrates, and the simulation results agree well with the experimental results.     

NMR Studies on the Effect of Solvents on the Dimerization of Benzoic Acid

The chemical shifts of carboxyl proton in benzoic acid have been measured in a variety of solvents. The characteristic monomer and dimer chemical shifts have been evaluated at 23°. A detailed discussion is given to illustrate the solvent shifts of carboxyl proton, from which the dielectric constant of solvent is considered as the main factor. The plot of carboxyl proton shift against (∈—1)/(∈+1) reveals a roughly linear dependence, indicating that a high field shift will be brought about by an increasing dielectric constant of solvent. Another linear relationship between log (δ—δ_D) and log ∈ suggests that an increase of ∈ will destroy the cyclic dimer, leading to an increase of the monomeric population and therefore to a higher field of the carboxyl proton signal.     

Effect of the Chemical Structure of Heat-Resistant Thermoplastics on the Friction on Steel

A general approach to understanding the complex nature of the friction of friction-resistant heatresistant thermoplastics has been developed. This approach made it possible to idenify two main factors determining the basic character of the friction of these polymers on steel: the dispersion component of the intermolecular interaction energy and the molecular weight. Specific properties of some polymers can be used to refine the friction behavior.     

Influence of the Nature of Alumina on the State of Oxygen on Its Surface

Russian Journal of General Chemistry -     

Effect of the Nature of the Dopant on the Response of a Sensor Array Based on Polyaniline

The effect of the nature of the dopant on the response of a sensor array based on films of polyaniline (PAn) under the influence of the vapor of various organic solvents was studied. It was established that the main factors determining the magnitude of the response of PAn films are the morphology of the films and the accepting power of the analyte molecules (in the case of "standard" acid dopants) and also the possibility of additional donor–acceptor interaction between the analyte molecules and the dopant (in the case of heteropoly acid dopants). It was shown that with heteropoly acids as dopants of PAn it is possible to increase substantially the selectivity of the response of the sensor array.     

Effect of the substituent on the phosphorus atom on the reaction of aminophosphines with 1-alkylisatins

Depending on the substituent on the phosphorus(III) atom, reactions of tris(dialkylamino)phosphines, 2-diethylamino-1,3,2-benzodioxaphosphole, and benzene-1,4-diylbis(N,N,N′,N′-tetraethylphosphonous diamide) with 1-alkylisatins lead to the formation of isoindigo derivatives, spirophosphoranes, or spirooxiranes whose structure was determined by NMR spectroscopy and X-ray analysis.     

Studies on the effect of non-electrolytes on the stability of copper ferrocyanide sol

Summary In general the addition of non-electrolyte to hydrophobic sols results into an irregular change in the stability of the latter, towards electrolyte coagulation. Precipitation concentration of potassium chloride for copper ferrocyanide sol changes in the presence of ethyl alcohol, glycol or glycerol. Ethyl alcohol sensitizes while others stabilise the sol to different extents. In presence of these alcohols, electrolytic coagulation of copper ferrocyanide sol is attended by a decrease in the conductance and hydrogen ion concentration as compared to a pure sol (sol without non-electrolyte).

---

Zusammenfassung Im allgemeinen verursacht das Zufügen von Nicht-Elektrolyten zu hydrophoben Solen eine irregul?re ?nderung der Stabilit?t der letzteren hinsichtlich der Elektrolytkoagulation. Die F?llungskonzentration von Kaliumchlorid für Kupfer-Ferrocyanid-Sol ?ndert sich bei Gegenwart von ?thylalkohol, Glykol oder Glycerin. ?thylalkohol sensibilisiert, w?hrend die anderen das Sol in verschiedenem Ausma\ stabilisieren. In Gegenwart dieser Alkohole ist die Elektrolytkoagulation des Kupfer-Ferrocyanid-Sols von einer Abnahme der Leitf?higkeit und der Wasserstoffionenkonzentration, verglichen mit den reinen Solen ohne Nicht-Elektrolyt begleitet.