N × N集成光开关阵列模型

报道了由2N个1 × N 多模干涉马赫-曾德尔光开关组成的N × N光开关阵列结构,分析了这种结构的开关阵列优势和局限性.用场传输矩阵方法建立了1 × N多模干涉光开关的光场传输方程.给出了光开关阵列从任一输入端输入、从任一输出端输出时阵列开关的工作条件.在上述原理及理论基础上分析了4×4光开关阵列的结构和工作条件.     

扩展多模波导全内反射型Y分叉开关的分析

利用全内反射和波导理论，分析了多模波导反射区全内反射(Total Internal Reflection，TIR)型光开关的物理模型和降低串音和损耗的原因，给出改进Y分叉全内反射型光开关特征的近似计算方法。数值模拟表明，扩展多模波导的Y分叉全内反射开关的串音和损耗可分别下降15．5dB和0．65dB以上。     

多通道声光偏转选址开关

本文报道1×N多通道声光偏转选址开关的研究.由 Ti 扩散 LiNbO₃波导上两个短程透镜和一个倾斜 chirp 叉指换能器构成的集成光学声光偏转器,在两端分别对接一根和N根单模光纤时,用作多通道选址开关,在换能器带宽为200MHz,对1.3μm波长,可实现N=24;带宽增加到500MHz,可达到N=64,在波长为0.633μm的 He-Ne 激光下进行的实验和理论符合.     

激光光控超导YBa2Cu3Ox薄膜开关的研制

在对光控热电效应开关进行理论分析的基础上,木文提出用YBa₂Cu₃O_x薄膜制作光控开关,并测试了在液氮温度下薄膜开关在不同激光波长下的特征参数,测试的最好结果是响应度R_v(632.8nm,10kHz,1Hz)为217V/W,归一化探测率D_*(632.8nm,10kHz,1Hz)为2.3×10¹¹cm.Hz^1/2/W,响应时间τ为0.21ms.     

光折变晶体BaTiO3中二波混频的温度效应

研究了光折变晶体钛酸钡中相向传输的二波混频的温度效应,得到在 BaTiO₃中增益耦合系数随温升而增加、并在85℃左右反向.说明其主要载流子的类型在此温度时发生改变.给出了有效陷阱浓度N(T)的温升模型,其理论预期值与实验数据符合较好.     

周期型二元颗粒链中孤波传播的二体碰撞近似分析

本文运用二体碰撞近似理论研究了孤波在周期型二元颗粒链中的传播. 周期型二元颗粒链由N个大球和一个小球交替排列而成, 球的材质都相同. 将小球和与之相邻的大球等效成一个球, 形成一条等效链. 采用二体碰撞近似理论, 推导了孤波在颗粒链中传播的速度、通过颗粒链时间以及小球的振荡频率. 理论分析得到小球振荡频率随着半径的增大而减小, 该结果与计算机模拟结果符合得相当好. 二体碰撞近似理论给出的波通过整条颗粒链时间, 在N ≤ 2时与计算机模拟结果符合得很好. 理论计算的误差随链长的变化不大. 但随着N的增大, 理论得到的结果相对误差变大.     

完整大豆叶片中自由基对的相互作用

本工作对完整大豆叶片直接地进行了电子自旋共振谱的测量.通过求解薛定格方程,给出IP-700+的数值解析表达式,该式与ESR实验曲线符合的很好.从而证实电子自旋极化理论对大豆叶片中光诱导信号I动力学和线型分析的适用性,以及得到A1是叶绿素A二聚物的判断.     

简并四波混频信号的饱和效应

本文由光学Bloch方程和密度矩阵方程出发,研究了二能级系统共振型简并四波混频(DFWM)的饱和效应,给出了DFWM信号强度与泵浦光强度的函数关系.饱和泵浦光强的大小取决于纵向弛豫时间T1和横向弛豫时T2.对理论结果与相应实验进行了比较,表明二者符合得很好.     

广义n维耦合谐振子体系的代数解法

利用二次型理论,通过三次保对易线性变换,实现了广义n维耦合谐振子体系哈密顿量的退耦合, 得到了体系对角化后的哈密顿量,并给出了体系的能量本征值和本征函数.     

周期性分层介质高反射区范围的分析与估计

对于具有周期单元的分层介质材料高反射区的波长范围，提供一种简明的估计分析方法.基于Floquet定理，分析了有限周期单元分层介质的光子带隙特性，给出分层介质的高反射区波长范围.讨论了分层介质高反射区和周期单元禁带之间的关系.计算表明，高反射区和周期单元禁带的中心波长彼此一致.并且，随着分层介质周期单元数的增多，高反射区的深度和带宽就越接近于周期单元禁带的深度和宽度.最后，讨论周期分层介质的光子带隙特性与入射角及其与极化的变化关系. 关键词： 分层介质 带隙特性 周期单元 高反射区     

Research on DMD infrared scene projector with a high contrast ratio infrared prism design

In this paper a single-DMD infrared scene projector with a high contrast ratio prism design of the illumination optical system is presented. By using the innovative infrared three-element TIR prism group, the off-state and flat-state light that reflected by the DMD could be all steered away from the projection lens. The contrast ratio and optical efficiency has been improved with this three-element TIR prism as the light-separator. This DMD infrared scene projector also features low-profile and compact structure. The illumination and projection optical systems are proved to be of great efficient light utilization. In this letter we analyze the impacts of optical efficiency on temperature simulation. This architecture with three-element TIR prism added could be used in IRSP based single-DMD to improve contrast and optical efficiency.     

Research of Asymmetric Y-Branching Total Internal Reflection All-Optical Switch

Y-branching TIR all-optical switch have been fabricated. When the switching optical intensity is 149.9W/mm2, the extinction ratio is 18dB. A theoretical model was also proposed which provided a good fit to the experimental data.     

改进型非对称Y分叉内全反射光开关特性分析

提出一种改进型非对称Y分叉内全反射光开关,较详细地分析了结构参量对光开关消光比和损耗的影响,优化设计后开关的消光比可大幅度提高,并给出了一种优化设计的方案.     

一种实现大功率LED均匀照明的投射器设计

以特定区域的均匀照明为目标,设计一种以单粒LED为光源的均匀投射系统。根据LED的发光特性以及能量守恒定律选择采用折射 全反射(TIR)光学系统,通过建立TIR折射面及全反射面轮廓曲线上的点所满足的常微分方程,利用Runge Kutta求解常微分方程得到轮廓曲线上点的坐标,再在UG中对坐标点进行曲线拟合得到轮廓曲线,进而得到TIR模型及适合数控加工的面形数据。将TIR模型导入Tracepro并对投射系统追迹光线。模拟结果表明：目标平面的光照均匀度达到92.6%,系统的效率达到91.8%。     

4×4自由空间光开关结构及其矩阵分析

光开关是全光通信网络中的一种重要的光无源器件。提出了一种4×4自由空间光开关的结构设计方法,并进行了矩阵理论分析。该4×4光开关具有新颖的光模块化结构,该光开关结构仅由偏振分束组合棱镜,λ／4波片,λ／2波片,直角棱镜,全反镜和偏振光调制器组成,对光开关的控制与输入光束的偏振态无关。所有的输出端口可以和输入端口无阻塞地互连交换。这种新型的光开关结构具有光学元件少,结构紧凑,模块化,与偏振无关的特点。基于4×4光开关的矩阵分析得到了路由控制表,为4×4光开关从任意输人端口到任意输出端口的路由控制状态提供了理论分析手段,从而可以方便地实现无阻塞地光交换开关矩阵的路由控制功能。     

Thermo-Optic Two-Mode Interference Optical Waveguide Device with Fast Response Time

Abstract

Based on the two-mode interference principle, a thermo-optic two-mode interference waveguide structure with heat-insulating grooves in both sides of the two-mode interference core has been proposed for optical switching. The thermal analysis of the proposed structure with SiON core and SiO₂ cladding has been performed by the finite difference method. The switching power of the device is estimated as ～450 mW, and the response time is estimated as ～98 μs, which is eight times faster than that of the existing thermo-optic two-mode interference device. The device length of the switch is 2.7 times less than that of the existing total internal reflection (TIR) thermo-optic switch.     

Nonlinear interferometry and phase measurements for surface second-harmonic generation in a dispersive geometry

Direct measurement of the phase of the surface nonlinear susceptibility is based on the interference of nonlinear optical signals. Up to now, this has not been possible for Second-Harmonic Generation (SHG) in geometries such as Total Internal Reflection (TIR) due to the refractive dispersion of harmonic and fundamental light created in TIR. We demonstrate two schemes which enable us to overcome this dispersion, leading to interference between two second-harmonic signals generated consecutively by the same laser. The advantages and limitations of the two approaches are discussed. We use this technique to check the theoretical predictions for the nonlinear Fresnel factors for SHG in the TIR geometry.Paper presented at the 129th HE-Heraeus-Seminar on Surface Studies by Nonlinear Laser Spectroscopies, Kassel, Germany, May 30 to June 1, 1994     

SOI波导反射模式的古斯-汉欣空间位移效应及其数字式热光开关

借助波导转角镜结构,利用古斯-汉欣空间位移和热光效应折射率调制的有效组合,提出了波导反射模式数字式热光开关结构。在给定入射角的条件下优化了空间古斯-汉欣位移,在具有古斯-汉欣效应的本征态下,反射光束出现了较大的跳跃。在1.0μm厚硅膜的绝缘体上硅平台上,单模输入波导和多模干涉波导结构之间的导模本征态匹配,验证了1×3数字式光开关功能。实验中,器件结构引起的光损耗为0.3 dB,开关功率为130~150 mW,开关时间约为50μs,相邻输出端之间隔离度为15 dB。与马赫-曾德尔干涉仪型的2×2热光开关和等离子体效应热光开关的最新结果进行比较证明了该数字式热光开关的先进性。     

Modeling and design of WDM optical buffers in asynchronous and variable-length optical packet switches

This paper aims to analyze the influence of wavelength conversion on the design of optical fiber delay line (FDL) buffers in a wavelength-division multiplexing (WDM) packet switch. We focus on the network scenario that variable-length packets arrive at the optical switch asynchronously. Through a detailed analysis of the behaviors of packets in the WDM FDL buffer, an approximate analytical traffic model is established. And the theoretical model is proved to be reasonable by simulations. Based on the model, it is clear that, under the same traffic load per wavelength channel, the utilization of tunable wavelength converters (TWCs) to resolve the output contention significantly reduces the number of fiber delay lines (FDLs) in optical buffers, and to achieve a given packet loss probability under a certain number of FDLs, the required number of tunable wavelengths can be predicted. The model can also estimate the optimal value of the basic time unit of the FDLs, and examine the influence of WDM on the optimal value. Finally, the impact of wavelength conversion on the optical switch size is analyzed. To the best of our knowledge, it is the first time that modeling on this problem is presented.