FTTH用微结构光纤的性能研究

光纤到户对光纤在小弯曲半径条件下的衰减特性提出了更高的要求。微结构光纤可以实现极小弯曲半径的低衰减光信号传输,是小弯曲半径单模光纤技术解决方案的有力竞争者。设计了一种新的微结构光纤,并研制出光纤样品。这种结构的光纤具有非常优良的弯曲特性。其最小弯曲半径可达2mm,1 550nm附加损耗小于0.1dB,并且具有优良的偏振模色散特性,熔接损耗也非常小,其与G.652D单模光纤的熔接损耗为0.12dB。这些特性使其在光纤到户的复杂应用环境中具有明显的应用优势。     

Four-wave mixing in microstructure fiber

We report what we believe to be the first experimental demonstration of nondegenerate four-wave mixing in a microstructure fiber. The effect of the chi((3)) nonlinearity is enhanced in such a fiber because of the small core area, and we achieve phase matching by operating near the zero-dispersion wavelength (?750 nm) . We have observed parametric gains of more than 13 dB in 6.1-m-long fiber with a pump peak power of only 6 W. We compare our experimental gain results with those predicted by theory and explore the effects of Raman shift and (or) amplification and cascaded nonlinear mixing.     

全玻璃实心保偏光子晶体光纤的研制

设计并采用棒管法结合毛细管堆积技术制备了一种全玻璃材料的实心保偏光子晶体光纤,光纤端面测试结果表明,这种结构设计有效克服了传统光子晶体光纤制造过程中空气孔易于塌陷的困难,光纤微结构保持良好.采用剪断法测得在1550nm波长下光纤的传输损耗为6.84dB/m.测试了输出光的偏振度,结果表明该光纤具有较好的保偏特性,说明采用此方法研制具有高保偏性能且制作工艺简单的光子晶体光纤是可行的.     

1.5μm波导声光可调滤光器研究

对１．５μｍ波导型声光ＴＥ－ＴＭ模式转换光滤波器进行了研究。采用了可降低驱动功率的表面声波导结构。在１．５￣１．６μｍ波段实现了可调滤光，通带宽度小于２ｎｍ，达到９７￥以上转换率所需的射频驱动功率约８０ｍＷ（１９ｄＢｍ），器件总插入损耗约９ｄＢ。     

Gain Flattened Raman Fiber Amplifier Using Parameter Optimization and DCF Fiber

We investigate two configurations of Raman fiber amplifier in the 1530-1570 nm region. The gain spectrum variation is decreased from 8.31 dB to 2.48 dB when appropriately adjust the individual two pumps and optical fiber.     

Amplitude-squeezed solitons from an asymmetric fiber interferometer

We experimentally demonstrate a new scheme for generating amplitude-squeezed solitons in an asymmetric fiber Sagnac loop. We measure by direct detection what is to our knowledge a record reduction of 5.7+/-0.1 dB (73%) and, with corrections for linear losses, 6.2+/-0.1 dB (76%) in the photon-number fluctuations below the shot-noise level. The same scheme is also shown to generate significant classical noise reduction and is limited by Raman effects in fiber.     

Fault analysis: optical performance investigation of fiber connections with imperfect physical contact

We investigated the insertion and return losses of optical fiber connections with various air-filled gaps. Such gaps might occur when a fiber connection using physical contact unexpectedly fails, resulting in imperfect physical contact. The optical performance of these fiber connections depends on wavelength and gap size. We revealed that the measured optical performance of fiber connections with an imperfect physical contact, i.e., with an air-filled gap, might deteriorate to ~18 dB for insertion loss and 9.4 dB for return loss at worst.     

Dispersion Compensation in Externally Modulated Transmission System Using Chirped Fiber Grating

We present an externally modulated NTSC AM-VSB erbium-doped fiber amplifier (EDFA)-repeated system in the 1550 nm region which uses a chirped fiber grating (CFG) as a dispersion compensation device. In contrast to the conventional externally modulated fiber optical CATV systems, either with or without dispersion compensation fiber (DCF), good performances of carrier-to-noise ratio (CNR) S 50 dB, composite second order (CSO) S 74 dB, and composite triple beat (CTB) S 65 dB were achieved for the full channel band after a 100-km single-mode fiber (SMF) transmission.     

Nonlinear-optical modulator for high-power fiber lasers

We propose a novel nonlinear-optical fiber modulator for high-power (>1-W) single-mode fiber lasers. The device is based on transferring the amplitude modulation from a low-power signal at the Stokes frequency onto a high-power beam through stimulated Raman scattering. The efficiency and limitations of the Raman modulator when highly Ge-doped fiber is used is considered. An insertion loss of less than 0.4 dB and an extinction ratio of 20 dB are predicted for modulation of a 10-W single-mode Nd-doped fiber laser.     

Dispersion Compensation in Externally Modulated Transmission System Using Chirped Fiber Grating

We present an externally modulated NTSC AM-VSB erbium-doped fiber amplifier (EDFA)-repeated system in the 1550 nm region which uses a chirped fiber grating (CFG) as a dispersion compensation device. In contrast to the conventional externally modulated fiber optical CATV systems, either with or without dispersion compensation fiber (DCF), good performances of carrier-to-noise ratio (CNR) ≥50 dB, composite second order (CSO) ≥74 dB, and composite triple beat (CTB) ≥65 dB were achieved for the full channel band after a 100-km single-mode fiber (SMF) transmission.     

Large-scale interferometric fiber sensor arrays with multiple optical amplifiers

We report what we believe to be the first laboratory prototype of a fiber sensor array using multiple low-gain (5dB) remotely pumped amplifiers in a 10-rung ladder structure. Incorporating amplifiers improves the system noise figure to less than 20dB, compared with 32dB in an optimized passive array of the same size. Scalability to more than 300sensors per fiber pair while a high dynamic range (1microrad/ sensitivity) is maintained is demonstrated.     

Novel fiber design for broadband long period gratings

We report a novel fiber design for obtaining long period gratings (LPGs) having a broad transmission spectrum. These gratings are based on guided to guided mode coupling in a staircase profile fiber. Numerical simulations predict 20 dB bandwidths as high as 100 nm and an estimated insertion loss of less than 1 dB. Such broadband LPGs are expected to find applications in many all fiber components.     

Dynamic Gain-Clamped Amplifier with Backward-Injection of a Fabry-Perot Laser

We have been experimentally demonstrated an active control technique of dynamic gain-clamped spectra for the erbium-doped fiber amplifiers (EDFA's) by a backward-injected Fabry-Perot (F-P) laser into this EDFA. In addition, employing a short length erbium-doped fiber (EDF) that not cause any gain saturation for preamplification in front of this amplifier module, it can reduce the noise figure degradation and simultaneously achieve gain variation from 11.1 dB to 0.5 dB for 10 dB input power level change.     

Raman-Assisted Passively Mode-Locked Fiber Laser

We propose and demonstrate a Raman-assisted passively mode-locked Yb-doped fiber laser in a normal dispersion regime. A section of highly nonlinear fiber is adopted to enhance the nonlinearity to extend the bandwidth of the gain spectrum by the stimulated Raman effect. The mode-locked fiber laser emits a broad spectral bandwidth of 64 nm at the-20 dB level and a highly stable pulse operation with a signal-to-noise ratio of 77 dB.     

Very-large-mode-area photonic bandgap Bragg fiber polarizing in a wide spectral range

A design of a polarizing all-glass Bragg fiber with a microstructure core has been proposed for the first time. This design provides suppression of high-order modes and of one of the polarization states of the fundamental mode. The polarizing fiber was fabricated by a new, simple method based on a combination of the modified chemical vapor deposition (MCVD) process and the rod-in-tube technique. The mode field area has been found to be about 870 μm2 near λ=1064 nm. The polarization extinction ratio better than 13 dB has been observed over a 33% wavelength range (from 1 to 1.4 μm) after propagation in a 1.7 m fiber piece bent to a radius of 70 cm.     

Picosecond flat-top pulse generation using dual-mode fiber Mach-Zehnder interferometers

We report on an optical fiber Mach-Zehnder interferometer made by offset splicing a dual-mode fiber with two single-mode fibers. The extinction ratio can be tuned from less than 1 dB to greater than 28 dB by rotating the dual-mode fiber along its axial direction. The interferometer is utilized as a pulse shaper to convert a 2.5 ps Gaussian pulse to a 5.2 ps flat-top pulse.     

Anomalous dispersion in a solid, silica-based fiber

We demonstrate an all-solid (nonholey), silica-based fiber with anomalous dispersion at wavelengths where silica material dispersion is negative. This is achieved by exploiting the enhanced dispersion engineering capabilities of higher-order modes in a fiber, yielding + 60 ps/nm km dispersion at 1080 nm. By coupling to the desired higher-order mode with low-loss in-fiber gratings, we realize a 5 m long fiber module with a 300 fs/nm dispersion that yields a 1 dB bandwidth of 51 nm with an insertion loss of approximately 0.1 dB at the center wavelength of 1080 nm. We demonstrate its functionality as a critical enabler for an all-fiber, Yb-based, mode-locked femtosecond ring laser.     

基于椭圆孔包层和微型双孔纤芯的新型高双折射光子晶体光纤

设计了一种新型高双折射光子晶体光纤,即其包层引入椭圆形空气孔,且以三角晶格方式周期排列,纤芯引入亚波长尺寸(~0.16 μm)的微型双孔结构阵列.采用全矢量有限元法和各向异性完美匹配层边界条件分析了该型光子晶体光纤的双折射特性和色散特性,详细介绍了该光子晶体光纤在不同的椭圆率、椭圆归一化面积、微型双孔孔径、两小孔之间间距的情况下双折射和限制损耗随波长的变化曲线.模拟结果表明,通过同时在包层和纤芯引入非对称性,获得了较高的双折射(~10^-3量级)和极低(~10^-4 dB/km)的限制损耗.提供了一种新的光子晶体光纤设计方法,即通过同时在包层和纤芯引入新结构来同时获得高双折射和低损耗.     

Wavelength-spacing tunable multiwavelength erbium-doped fiber laser based on four-wave mixing of dispersion-shifted fiber

We experimentally demonstrate a wavelength-spacing tunable multiwavelength erbium-doped fiber laser based on degenerate four-wave mixing in a dispersion-shifted fiber incorporating multiple-fiber Bragg gratings. We have achieved stable operation of the multiwavelength erbium-doped fiber laser, which has 0.8 nm spacing ten-channel lasing wavelengths and a high extinction ratio of more than approximately 45 dB, at room temperature. The output power of the multiwavelength erbium-doped fiber laser is stable, so the peak fluctuation is less than approximately 0.2 dB. By changing the properties such as loss and polarization state of multiple fiber Bragg grating cavities, we can exercise flexible control of the wavelength spacing of the multiwavelength output. We can also obtain switchable multiwavelength lasing operation by elimination of the effects of alternate single-fiber Bragg gratings.     

非均匀微结构光纤中双折射现象的研究

报道了利用飞秒脉冲激光与非均匀微结构光纤相互作用中产生超连续光谱后在非均匀微结构光纤传输中双折射拍频现象的研究.利用35?fs的飞秒激光脉冲在高双折射微结构光纤中的传输过程中直接观察到了拍频现象.并利用有限元方法对该光纤进行了模拟计算分析，计算得出在600?nm处拍频长度为毫米量级.所得结果与实验一致. 关键词： 双折射效应 微结构光纤 超连续光谱 有限元法