s=355GeV附近的R值测量

利用北京谱仪(BES)在s=3.55GeV附近获取的总积分亮度约为5pb^－1的实验数据,测量了e⁺e^－湮没强子产生截面与μ子对产生截面的比值(即R值).其测量误差比其它实验组已发表的此能区的测量误差减小约50%.     

e+e－湮没中的胶子碎裂

本文假定e⁺e^－湮没时产生的胶子的强子化,胶子首先劈裂成一对等效的夸克、反夸克对.夸克之间的色相互作用,碎裂成末态强子.由此计算的e⁺e^－→3jet事例中的带电粒子多重数,胶子与夸克jet中多重数比率,以及e⁺e^－三胶子事例中的重子比率,都与实验结果一致.解释了e⁺e^－→3jet末态粒子的角分布.     

北京正负电子对撞机上QCD的精确检验

广义的Crewther关系式可以把正负电子湮没过程中强子产生的分支比R=σ(e⁺e^－→强子)/σ(e⁺e^－→μ⁺μ^－),同轻子核子深度非弹性散射中的Bjorken求和规则和Gross-UewellynSmith求和规则联系起来,提供一个没有标度和重整化方案任意性的有关量子色动力学(QCD)物理量的基本关系式.强子产生分支比R可以在升级后的北京正负电子对撞机或τ–粲工厂上进行精确的测量,从而提供对QCD的精确检验.     

400GeV/c pp碰撞两粒子关联的角度依赖性

利用400GeV/c pp碰撞多重产生的实验数据计算了粒子-粒子关联(PPC)及其不对称性(PPCA)的角度依赖性.结果与L3的e⁺e^－数据有明显的差别,但与NA22强子碰撞的实验数据符合得很好;领头粒子对强子碰撞的PPCA分布有很大影响.通过计算两粒子方位角差的分布观察到了方位角关联.     

随机组合模型中夸克动量分数的随机抽样问题

本文简要介绍了e⁺e^－湮没成强子喷注的物理图象,引入了随机夸克组合模型中夸克动量分数的分布,重点从数学上严格推导了这一分布的抽样方法.     

北京谱仪R值测量中的初态辐射修正

从R值测量实验的角度讨论了e⁺e^－碰撞通过单光子湮没产生强子截面的辐射修正,分析了3种典型的计算方案.在BEPC/BES上运行的2—5GeV能区,不同方案给出的辐射修正因子理论值(1+δ)的差别大约是1%—2%,而每一方案计算中由于各种不确定因素带来的有效辐射修正因子(1+δobs)的总误差约为2%—3%.     

北京谱仪Ⅱ中性径迹测量误差的确定

选取辐射Bhabha样本,研究了北京谱仪Ⅱ(BESⅡ)桶部簇射计数器(BSC)对中性径迹的沉积能量和空间位置的测量,定出了实际数据的测量误差.并利用Monte Carlo产生的e⁺e^－→γγ事例定出MC数据的能量及位置测量误差.结果已用于BESⅡ运动学拟合,能改善物理分析结果.     

弦张量与奇异粒子产生

用一种参数化的形式研究了弦上具有硬胶子纽结所导致的有效弦张量的增长.在此种形式下强子一强子碰撞中有效弦张量随碰撞能量的增加而增加是来自碰撞中微喷注的产生.这种机制既能解释强子一强子碰撞奇异夸克压低因子随碰撞能量之增而增的行为,又能解释e⁺e^－湮没中该因子与能量近似无关的现象.     

τ轻子Michel参数测量中的电子识别方法

北京谱仪(BES)合作组通过τ→eνν衰变的电子能谱测定Michel参数,本文利用BES在质心系能量4,03GeV处获取的e⁺e^－对撞数据,通过BES给出的带电粒子dE/dx、β、E/p测定值及其适当组合,实现了电子的有效识别.     

部分子末态的色分离联接对e+e－反应中强子产额及其动量谱的影响

用JETSET事例产生器对e⁺e^－→qq+ng→hadrons反应中,末态部分子(qq+ng)以色分离的联接方式进行强子化时,各种强子产额及π⁺,K^±,p/p的动量谱进行了计算;与传统的色中性流联接方式强子化结果进行比较.结果表明:由T权重确定的色分离单态和色中性流这两种完全不同的色联接方式强子化得到的强子产额及π⁺,K^±,p/p的动量谱,与实验符合的程度相同,有些更好.     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Hybrid Wavelength and Code Division Multiple Access in Optical Networks

A review of schemes for multiple access in fiber optic networks shows that a hybrid of wavelength and code division multiple access (WCDMA) combines the best features of both. In particular, the hybrid scheme retains the large information carrying capacity of wavelength division multiple access (WDMA) and flexibility of code division multiple access (CDMA). In this paper WDMA, optical CDMA (OCDMA), and WCDMA networks are discussed. In OCDMA networks, concept of incoherent and coherent coding including inverse decoding and matched filter is introduced. The delay performance of both WDMA and WCDMA networks, under the simple suboptimum access protocols based on cyclic search, is computed. It has been shown quantitatively that tuning delay significantly affects the delay performance of both WDMA and WCDMA networks. Futhermore, delay performance of WCDMA networks is always better than the WDMA networks for the same tuning delay, load, and number of users.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Research on beamforming method for dual-line array with space mismatch between the two line arrays

The performance of port/starboard discrimination of dual-line array will be seriously degraded when the space between the two line arrays of the dual-line array is mismatched. The directivity function of the delay-sum and delay-subtract beamforming is deduced and the port/starboard discrimination of the delay-sum and delay-subtract beamforming is also studied both under the ideal status and the status under which the space between the two line arrays of the dual-line array is mismatched. Analysis results show the delay-subtract beamforming has better performance of port/starboard discrimination. At last, the sea trial results demonstrate the theoretical results.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Retrieval of ultraviolet skylight radiances and O3 slant column densities from balloon-borne limb spectrometer

With a novel light-weight and absolutely calibrated ultraviolet （UV） spectrometer, UV skylight radiances and O3 slant column densities are measured by balloon-borne limb measurements in Xinjiang area, China. UV skylight radiances measured at the height of 31 km are compared with the results from Modtran in the wavelength range from 290 to 420 nm. O3 slant column densities are derived from radiance spectra in the Huggins bands （320 - 335 nm） using differential optical absorption spectroscopy method. And the parameter exhibits a good correlation with the same value simulated by radiative transfer model （Tracy）. The O3 profile simultaneously measured by an O3 sonde is used as input in Tracy calculations. The O3 sonde is launched on the same balloon.     

Design optimization of highly sensitive LSPR enhanced surface plasmon resonance biosensors with nanoholes

For breaking through the sensitivity limitation of conventional surface plasmon resonance (SPR) biosensors, novel highly sensitive SPR biosensors with Au nanoparticles and nanogratings enhancement have been proposed recently.But in practice, these structures have obvious disadvantages.In this study, a nanohole based sensitivity enhancement SPR biosensor is proposed and the influence of different structural parameters on the performance is investigated by using rigorous coupled wave analysis (RCWA).Electromagnetic field distributions around the nanohole are also given out to directly explain the performance difference for various structural parameters.The results indicate that significant sensitivity increase is associated with localized surface plasmons (LSPs) excitation mediated by nanoholes.Except to outcome the weakness of other LSP based biosensors, larger resonance angle shift, reflectance amplitude, and sharper SPR curves' width are obtained simultaneously under optimized structural parameters.     

Polymer gratings based on photopolymerization for low-order distributed feedback polymer lasers

Novel polymer distributed feedback(DFB)gratings are fabricated based on photopolymerization to reduce lasing threshold of polymer lasers.A photopolymer formulation sensitive to 355-nm ultraviolet(UV)light is proposed for the fabrication of polymer gratings and it can be used to form polymer films by spin-coating process.A very low surface-relief depth ranging from 12.5 to about 1.0 nm has been demonstrated with a refractive-index modulation of about 0.012.The experimental results indicate that such polymer gratings have promising potentials for the fabrication of low-order DFB organic semiconductor lasers.