Emittance-dominated long bunches in dual harmonic RF system

The storage of long bunches for long time intervals needs flattened stationary buckets with a large bucket height. The longitudinal motion of the initially mismatched beam has been studied for both the single and dual harmonic RF systems. The RF amplitude is determined to be r.m.s wise matched. The bucket height of the single harmonic system is too small even for shorter bunch with only 20% increased energy spread. The Halo formation and even debunching can be seen after a few synchrotron periods for single particles with large amplitude. In the case of small energy spread for a cooled beam, Coulomb interaction cannot be ignored. The external voltage has to be increased to keep the r.m.s bunch length unchanged. The new voltage ratio R(N) simplifies physics for the emittance-dominated bunches with modest particle number N. For the single harmonic system, substantial amount of debunching occurs without increasing the external voltage, but very little if the RF amplitude is doubled. Results from the ORBIT tracking code are presented for the 1 GeV bunch in the HESR synchrotron, part of the GSI FAIR project.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Spectral luminescent properties of monomeric and associated molecular forms of acridine dyes in polymer matrices

M. V. Lomonosov Moscow State University, Leninskie Gory, 119899, Moscow, Russia. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 62, No. 2, pp. 38–46, March–April, 1995.     

Speech enhancement by array crosstalk resistant ANC and spectrum subtraction

Microphone array-based speech enhancement has great importance for speech communications and speech recognition. To reduce the aperture of the microphone array and to increase the effect of the speech enhancement will greatly broaden the application areas of the microphone array. An array crosstalk resistant adaptive noise cancellation method is therefore presented. And then an improved spectral subtraction algorithm is further cascaded to obtain better enhancement results. Theoretic analysis and experiments indicate that the proposed scheme needs only a very small microphone array while it simultaneously achieves a higher SNR improvement. Besides, the proposed scheme can be used in many noisy environments and is easy for real-time implementation.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

ß-Correction spectrophotometry and its application to determination of a trace metal and its chelate composition: Cd(II) with dithizone

Huaibei Environmental Monitoring Center, Huaibei, Anhui Province, 235000, P. R. China. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 62, No. 6, pp. 76–80, November–December, 1995.     

Cavitation in trees

Sap is transported under tension (i.e. negative pressure) in trees, according to the tension-cohesion theory. Since water is physically instable under negative pressure, a risk of cavitation is possible. Techniques have been developed during the past two decennia to study cavitation in trees. Trees appear remarkably immune to cavitation events. Cavities form only when extreme water stresses occur or when sap freezes. Nucleation is heterogeneous in trees, presumably caused by the aspiration of air bubbles through conduit walls. Threshold xylem pressures for cavitation vary greatly between species, in concordance with the great functional and ecological diversity of trees. To cite this article: H. Cochard, C. R. Physique 7 (2006).     

Energy dependence of non-linear dynamical features in e+e- collisions

A study of the dynamical fluctuation properties at various c.m. Energies in e+e- collisions is performed using the Monte Carlo method. The results suggest that, after the normalized factorial moments of 3-dimensional phase space are analyzed using an isotropical phase space partition, the NFM describing non-linear dynamical properties show a power-law scaling, I.e., the dynamical fluctuations in higher dimensional phase space are isotropic. For c.m. Energies √s≤80 GeV,the scaling exponents φq increase rapidly with the c.m. Energy and for c.m. Energies √s＞80 GeV,the φq gradually saturate.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.     

A new tuning procedure for the DTL RF field pattern

The DTL tank is a multi-cell cavity.In a fabricated tank,the measured average axial field E0 for each cell may obviously deviate from the designed value.It is generally thought the deviation is due to the errors in fabrication and assembly.But it is not always true.In this paper,it is shown that the deviation may already exist before fabrication in some cases.It is partly due to the imperfection of the current design procedures.A new design method is introduced to reduce the deviation in the design stage.     

An effective method for reducing speckle noise in digital holography

An effective method for reducing the speckle noise in digital holography is proposed in this paper.Different from the methods based on classical filtering technique,it utilizes the multiple holograms which are generated by rotating the illuminating light continuously.The intensity images reconstructed by a series of holograms generated by rotating the illuminating light possess different speckle patterns.Hence by properly averaging the reconstructed intensity fields,the speckle noises can be reduced greatly.Experimental results show that the proposed method is simple and effective to reduce speckle noise in digital holography.     

Quick single-photon detector with many avalanche photo diodes working on the time division

Due to the limit of response speed of the present single-photon detector, the code rate is still too low to come into practical use for the present quantum key distribution (QKD) system.A new idea is put up to design a quick single-photon detector.This quick single-photon detector is composed of a multi-port optic-fiber splitter and many avalanche photo diodes (APDs).Au of the ports with APDs work on the time division and cooperate with a logic discriminating and deciding unit driven by the clock signal.The operation frequency lies on the number N of ports, and can reach N times of the conventional single-photon detector.The single-photon prompt detection can come true for high repetition-rate pulses.The applying of this detector will largely raise the code rate of the QKD, and boost the commercial use.     

Optical Pulse Compression Schemes That Use Nonlinear Bragg Gratings

Nonlinear optical pulse compression of picosecond pulses typically requires long lengths of optical fiber and multiple components. Periodic structures, such as fiber Bragg gratings, are highly dispersive at wavelengths outside of the photonic bandgap. This implies that such gratings can be used as very short all-fiber compressors. In this paper a number of such compression schemes are reviewed involving uniform and nonuniform fiber Bragg gratings, relying on both soliton and nonsoliton compression principles. Experimental results supporting the corresponding underlying theory are also presented. Finally, an extension of one of the compression schemes is shown, which allows the generation of adjustable high-repetition rate soliton trains.     

The effect of complexing processes on energy transfer Tl+→Gd3+ and Tl+→Tb3+ in glass

T. Shevchenko Kiev University, 252022 Kiev, Pr. Akad. Glushakova, 6, Ukraine. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 62, No. 3, pp. 192–196, May–June, 1995.     

Conductively cooled all-solid-state zigzag slab laser

A diode pumped, Q-switched Nd：YAG zigzag slab laser is developed using passive conduction cooling. Flat-flat and unstable resonators are adopted in this experiment. The 150-mJ multi-mode and 100-mJ single-mode laser outputs with pulse width of 10 ns are achieved, corresponding to optical efficiencies of 19% and 13%, respectively. The experimental result demonstrates that the laser has the property of compact structure, high efficiency, reliability, and high beam quality. The design of laser has a potential application in space environment.     

The nature of empirical constants in the equation relating the frequency of the stretching vibration of oh-groups to parameters of the [MO n ]-polyhedrons coordinating these groups

Institute of Physicoorganic Chemistry, Academy of Sciences of Belarus, 220603, Minsk, Ul. Surganova, 13, Belarus. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 62, No. 1, pp. 104–107, January–February, 1995.     

A system for the remote spectroscopy in the visible and infrared regions

Results of the design and development of a system for remote sensing of the state and evaluation of the parameters of the natural environment and objects are presented. The devices developed are based on a generalized structural model of measuring system for acquisition of data on spectral, energy, polarization, angular, and spatial characteristics of the optical radiation field of the object under investigation. A. N. Sevchenko Scientific Research Institute for Applied Physical Problems at the Belarusian State University, 7, Kurchatov St., Minsk, 220064, Belarus. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 6, pp. 827–833, November–December, 1997.     

Voltage-controlled optical filter based on electrowetting

In this letter, we propose a voltage-controlled optical filter based on electrowetting. The device is made of a transparent cubic cell filled with two immiscible liquids having three indium tin oxide electrodes fabricated on the bottom substrate of the cell. A conductive droplet carrying a color filter is placed on the ITO electrode and the surrounding liquid is density-matched silicone oil. Under zero bias, the droplet is placed in the middle of the substrate and white light passes through the filter and we can see red light on the screen. When a voltage is applied to the device, the filter moves with the liquid based on electrowetting effect, we can see the white light on the screen. Due to the movement of the liquid, our device functions as an optical switcher. The switch time of the device is ~70 ms. The proposed device has a wide application in optical communication, electronic display, and optical switch.     

Controlled calibration method for laser induced breakdown spectroscopy

Laser induced breakdown spectroscopy (LIBS) is a potential technique for rapid analysis of samples present in solids, gases and liquids. In the last two decades it was an object of extensive studies. Controlled calibration method used to analysis the LIBS spectra is investigated. Compared with the inner calibration and calibration-free (CF) methods, this new method overcomes "matrix effect", and demonstrates a better ability to cope with the spectra. It is used to analyze natural soil, and errors of the concentration are decreased about 5%. The result shows that the new method is feasible and accurate.