High-voltage SOI lateral MOSFET with a dual vertical field plate

A new silicon-on-insulator(SOI)power lateral MOSFET with a dual vertical field plate(VFP)in the oxide trench is proposed.The dual VFP modulates the distribution of the electric field in the drift region,which enhances the internal field of the drift region and increases the drift doping concentration of the drift region,resulting in remarkable improvements in breakdown voltage(BV)and specific on-resistance(Ron,sp).The mechanism of the VFP is analyzed and the characteristics of BV and Ron,spare discussed.It is shown that the BV of the proposed device increases from 389 V of the conventional device to 589 V,and the Ron,sp decreases from 366 m·cm2to 110 m·cm2.     

三氧化二铝-聚苯乙烯复合微球的制备

以Al2O3-PS复合材料为原料,采用乳液微封装法制备出掺杂Al2O3的PS空心微球。三相溶液分别是两个水相：蒸馏水（W1相）、5wt%PVA水溶液（W2相）和3wt%Al2O3-PS溶液（O相,苯和三氯甲烷混合物作溶剂）。所得微球表面粗糙度低于50nm。     

MOS结构电离辐射效应模型研究

基于氧化层空穴俘获和质子诱导界面陷阱电荷形成物理机制的分析,分别建立了MOS结构电离辐射诱导氧化层陷阱电荷密度、界面陷阱电荷密度与辐射剂量相关性的物理模型.由模型可以得到,在低剂量辐照条件下辐射诱导产生的两种陷阱电荷密度与辐射剂量成线性关系,在中到高辐射剂量下诱导陷阱电荷密度趋于饱和,模型可以很好地描述这两种陷阱电荷与辐射剂量之间的关系.最后讨论了低剂量辐照下,两种辐射诱导陷阱电荷密度之间的关系,认为低辐射剂量下两者存在线性关系,并用实验验证了理论模型的正确性.该模型为辐射环境下MOS器件辐射损伤提供了更 关键词： MOS结构 辐射 界面陷阱 氧化层陷阱     

三氧化钨/氧化银复合材料的水热法合成及其光催化降解性能研究

染料污染是水污染中最严重的问题之一,吸引了很多科学家的关注.人们尝试了很多方法去解决该问题,如化学氧化法、物理吸附法、光催化降解法和生物降解法等.与其他几种方法相比,光催化法有着低能耗、环保以及高效等优势.三氧化钨是常见的半导体材料,具有独特的光学性能,近年来受到了广泛的研究.本文以钨酸钠和硫脲为前驱体,通过水热法制备了三氧化钨/氧化银(WO_3/Ag_2O)复合材料,并用光催化降解亚甲基蓝来分析其光催化性能.通过X射线光电子能谱、X射线衍射、透射电子显微镜、扫描电子显微镜、紫外可见吸收光谱等表征手段对样品的形貌、晶格结构和光催化的性能进行表征.氧化银的带宽为1.2 e V,对可见光很敏感,三氧化钨和氧化银的复合使材料在可见光下的光催化活性显著增强,在可见光下对亚甲基蓝染料的光降解率可以达到98%.实验结果表明,复合材料中的三氧化钨纳米棒为六方相,其平均直径约为200 nm,平均长度约为4μm.而复合材料中的氧化银纳米颗粒为六方相,附着在氧化钨纳米棒的表面,平均晶粒尺寸为20 nm.氧化银的存在为复合材料提供了更多的反应活性位点.相较于单一组分,复合材料在可见光下的光吸收度更高,这说明三氧化钨和氧化银的复合改变了材料的能带结构.研究发现,三氧化钨和氧化银之间形成的异质结构是其优良光催化性能的来源.此外,三氧化钨和氧化银复合材料还具有良好的催化稳定性和化学稳定性.本文结果表明,可以通过给宽带隙的半导体材料复合一些带隙合适的金属氧化物以提升其光催化活性.     

P2-type Na0.6[Mg(II)0.3Mn(IV)0.7]O2 as a new model material for anionic redox reaction

In this work, P2-Na_0.6[Mg(II)_0.3Mn(IV)_0.7] O₂ with inoxidizable elements (Na⁺, Mg²⁺ and Mn⁴⁺) except O^2- was synthesized and investigated, which exhibited high reversible capacity (~210 mAh/g) with highly reversible ARR characteristic.     

Novel Protonic Conductive Silicates Produced by the Sol-Gel Method

ABSTRACT

Materials which display ionic conductivity were produced by the sol-gel and microemulsion-gel methods. The charging and discharging characteristics were investigated and it was found that a single ionic species was responsible for the conduction, the ionic species being residual protons from the initial component mixture. The complex impedence of various samples was measured and the ionic conductivities ranged in value from 9 × 10^?8 to 1 × 10^?5 ohm^?1 cm^?1. An Arrhemius plot for a microemulsion-gel revealed that the energy of activation was 0.15 eV.     

15N-Traceruntersuchungen zum Mechanismus der N2O-Bildung in Böden

Nitrous oxide is a potential environmental hazard responsible for the green house effect and the destruction of the ozone layer in the lower stratosphere. Biological denitrification under anaerobic conditions in soils results in the formation of both N₂O and N₂, whereby highly nitrogen-fertilized agricultural soils contribute to a considerable extent of the N₂O emission. Latest results in the literature indicate that nitrous oxide can also be formed as a byproduct of the microbial nitrification. This is of importance for soils in central Germany because of the non-existence of typical denitrification conditions in a semiaride climate.

This study was conducted to measure the path of N₂O formation in Haplic Phaeozen: using [¹⁵N] ammonium and [¹⁵N] nitrat and a GC-MS aided incubation system. The kinetic isotope method was used to evaluate the experimental data. The results are:

- Under anaerobic conditions (～ 90% of the water holding capacity = WHC) N₂O originates mainly from the nitrate pool by denitrification.

- As expected, the N₂O formation is low under aerobic conditions (～ 80% WHC) but the gas originates directly from the ammonium and not from the nitrate pool, probably as a byproduct of the nitrification process.     

Kurze Originalmitteilungen Ein neues Lanthan-140-Generatorsystem

Neben ihrer breiten Anwendung in der Nuklearmedizin gewinnen Radionuklidgeneratoren zunehmend auch für die verfahrensctechnische Forsehung Bedeutung. Es konnte gezeigt warden, daß die Generatorsysteme ⁹⁹Mo/^99mTe und ¹¹³Sn/^113mI für zahlreiche Untersuchungen von Transportund Mischvorgängen in technischen Anlagen genutzt warden könnea [1, 2].

Der Radionuklidgenerator ¹¹⁰Ba/¹¹⁰La hat für den Einsatz in der Technik günstigere Eigenschaftcn als die für die Nuklearmedizin entwickelten Generatoren. Insbesondere für die Untersuchung der Materialtransportvorgänge in Polykondensationsreaktoren der Chemiefaserindustrie hat sich ein Lanthan-140-Generator gut bewährt, der mit Tributylphosphat (gesättigt mit 13 N HN03) als Elutionsmittel arbeitet [3, 4].