轻型汽车后桥半轴断裂件的组织及断口特征

采用光学显微镜和扫描电子显微镜等手段，对某轻型汽车40Cr后桥半轴断裂件的组织及断口特征进行了分析结果表明：半轴在调质处理时的淬火温度不够高，使其表层和心部组织中存在较多的铁素体相，造成了工件最终的硬度和疲劳强度不足，导致半轴在使用中发生扭转疲劳断裂．     

On the origin of irreproducible behaviour of Na1−xLixNbO3 solid solutions

The irreproducibility of electrical properties of Na_0.88Li_0.12NbO₃ solid solution on thermal cycling reported by M.A.L. Nobre and S. Lanfredi is explained by gradual decomposition of the supersaturated solid solution below ca. 800 °C.     

Phase transition in iodine: a chemical picture

The phase transition under pressure in iodine is analyzed using the electron localization function (ELF), explaining that the increase of the c/a ratio under compression is due to the presence of the lone pairs.A probabilistic interpretation is given for ELF.     

热丝加热电流对CH薄膜沉积速率和表面形貌的影响

 热丝辅助裂解法是结合气相沉积制备聚对二甲苯薄膜和热丝化学气相沉积而形成的一种制-CH薄膜的新方法。热丝辅助裂解法的最大特点就是在保持低衬底温度情况下可以获得高沉积速率，而热丝加热电流对薄膜沉积速率和薄膜表面形貌具有重要影响。研究表明，热丝加热电流越大，薄膜沉积速率越高，在加热电流9A时，薄膜沉积速率可达0.002mm/min，同时薄膜表面粗糙度随之增加，薄膜表面也开始出现其它元素污染，因此，一般热丝加热电流选择为7A附近。     

Crystal Structure,Phase Transition and Ferroelastic Properties of [N(CH3)4]3[As2Cl9]

The crystal structure of [N(CH₃)₄]₃[As₂Cl₉] is determined at 293 K. It crystallizes in trigonal space group P31c: a = 9.2199(8), c = 21.065(3)Å, Z = 2, R₁ = 0.0505, wR₂ = 0.1283. The crystal is built of the discrete bioctahedral [As₂Cl₉]^3— anions and the deformed tetramethylammonium cations. A structural phase transition in [N(CH₃)₄]₃[As₂Cl₉] is detected by the DSC and dilatometric techniques at 146/151 K (on cooling/heating). Dielectric relaxation studies in the frequency range 75 kHz — 5 MHz indicate reorientations of the tetramethylammonium cations within the high temperature phase. Optical observations show the existence of the ferroelastic domain structure below 146 K. The possible mechanism of phase transition is discussed on the basis of the presented results.     

NDMAP: the best material to study the Haldane's prediction

As predicted by Haldane, spin, S=1 one-dimensional (1D) Heisenberg antiferromagnet (HAF) has an energy gap between the singlet ground state and first excited triplet. On application of magnetic field, the triplet state Zeeman splits and the energy of one of the triplet state becomes zero at a critical field, H_c. Above H_c the system recovers magnetism. Then, we expect that a quasi-1D HAF will show a magnetic long-range ordering (LRO) at low temperatures due to the inter-chain coupling. This field-induced LRO has not been observed before due to complication of the crystal structure in the materials studied so far and/or technical difficulty.From a heat capacity measurement on a single crystal of an S=1 quasi-Q1D HAF, Ni(C₅H₁₄N₂)₂N₃(PF₆), we found an anomaly at a temperature in finite fields indicating a field-induced phase transition. A magnetic LRO is confirmed by a neutron diffraction measurement on the same sample. The temperature versus magnetic field phase diagram of this compound is constructed and discussed.     

大焦深成像系统仿真实验研究

如何增大非相干光学成像系统的焦深是应用光学研究领域的热点问题.本文对采用高次非球面光学掩模板与图像处理相结合增大成像光学系统焦深的新方法进行了深入分析,建立了大焦深成像系统仿真实验模型,并进行了大焦深成像系统仿真实验.实验结果证明了该方法在维持原相对孔径的同时使光学系统在较大的离焦范围内有好的成像质量.实际应用中还要综合考虑模板参量、信噪比等关键因素.     

Photoemission study of the modification of the electronic structure of transition-metal overlayers on TiO2 surfaces II. Cr on TiO2(0 0 1)

The electronic states of the Cr overlayers on TiO₂(0 0 1) surfaces have been investigated using angle-resolved and resonant photoemission spectroscopy with synchrotron radiation. At lower coverages, Cr deposition on TiO₂(0 0 1) creates two well separated in-gap emissions due to the formation of surface Ti³⁺ (3d¹) ions and Cr³⁺ (3d³) ions. At higher coverages, the in-gap emission is developed into the 2-peak-structure emission of Cr 3d character. The corresponding state is considered to be of metallic nature from the viewpoint of the high ability of oxygen adsorption, but has no Fermi edge, indicating a possibility of forming small Cr clusters on TiO₂(0 0 1) at this stage.     

Photo-induced evolution of copper sheets from cluster molecules and its application to photolithographic copper patterning

UV photoexcitation of (t-butylethynyl copper)₂₄ cluster films induces segregation of the crystals into metallic and organic phases and leads to evolve the metallic sheets sandwiched by organic polymers. The growth of the metallic crystals in the plane of the photo-electromagnetic field is attributed due to plasmon-plasmon interaction among nanoparticles embedded in dielectric polymer matrices. The surface enhanced photochemical reaction of residual cluster molecules on the photon incident direction is expected to take an important role for joining the metal particles to produce a metallic sheet. We can apply this phenomenon for photolithographic copper pattern generation on a flexible base plate.     

First-principles study of indium on silicon (1 0 0)—the structure, defects and interdiffusion

The atomic structures of indium (In) on silicon (Si) (1 0 0)-(2 × 1) surface are investigated by the local density approximation using first-principles pseudopotentials. Total energy optimizations show that the energetically favored structure is the parallel ad-dimer model. The adsorption energy of In on ideal Si(1 0 0)-(1 × 1) surface is significantly higher than that on reconstructed Si(1 0 0)-(2 × 1) surface, suggesting that In adsorption does not break the Si-Si dimer bond of the substrate. When Si surface contains single dimer vacancy defects, In chain will be interrupted, leading to disconnected In nanowires. Displacive adsorption of In on Si(1 0 0) is also considered, and the calculation suggests that interdiffusion of In into Si substrate will not be favorable under equilibrium conditions.