Crystallization of Poly(ethylene adipate) within γ-Phase Poly(vinylidene fluoride) Matrix

The effects of PEA on the γ-phase PVDF crystal structure and the crystallization of PEA within the pre-existing γ-phase PVDF spherulites have been investigated by optical microscopy(OM), infrared spectroscopy(IR) and scanning electron microscopy(SEM). The results demonstrate that the γ-phase PVDF spherulites consist of the lamellae exhibiting a highly curved scroll-like morphology and develop preferentially in PEA-rich blend. With increasing PEA concentration, the scroll diameter increases and the scrolls are better separated from each other. PEA crystallizes first in the interspherulitic region and transcrystalline layer develops. Subsequently, the transcrystalline layer of PEA continues to grow within the γ-phase PVDF spherulites, e.g., in the region between the scrolls, until impinging on other PEA transcrystalline layers or spherulites. The crystallization kinetics results indicate that the growth rate of PEA crystals in the intraspherulitic region of γ-phase PVDF shows a positive correlation with content of PEA, but a negative one with the crystallization temperature of γ-phase PVDF.     

Mass and isotopic concentrations of water-insoluble refractory carbon in total suspended particulates at Mt.Waliguan Observatory(China)

Mass concentration and isotopic values δ¹³C and ¹⁴C are presented for the water-insoluble refractory carbon（WIRC） component of total suspended particulates（TSP）,collected weekly during 2003,as well as from October 2005 to May 2006 at the WMO-GAW Mt.Waliguan（WLG） site.The overall average WIRC mass concentration was（1183±120）ng/m³（n = 79）,while seasonal averages were 2081 ±1707（spring）,454±205（summer）,650±411（autumn）,and 1019±703（winter） ng/m3.Seasonal variations in WIRC mass concentrations were consistent with black carbon measurements from an aethalometer,although WIRC concentrations were typically higher,especially in winter and spring.The δ¹³C PDB value（-25.3 ± 0.8）%.determined for WIRC suggests that its sources are C₃ biomass or fossil fuel combustion.No seasonal change in δ¹³C PDB was evident.The average percent Modern Carbon（pMC） for ¹⁴C in WIRC for winter and spring was（67.2 ± 7.7）%（n = 29）.Lower pMC values were associated with air masses transported from the area east of WLG,while higher pMC values were associated with air masses from the Tibetan Plateau,southwest of WLG.Elevated pMC values with abnormally high mass concentrations of TSP and WIRC were measured during a dust storm event.     

具有随机生存域的随机场

本文研究具有随机开参数集的随机场构造,获得了具有已知有穷维分布的随机场存在和唯一性条件。     

碳纳米管被“激光镊子”牵鼻走

~~碳纳米管被“激光镊子”牵鼻走@汪道友~~     

K(o)the-Bochner空间的凸性

本文利用K(o)the函数空间的性质以及K(o)the函数空间与K(o)the-Bochner空间的关系,讨论了K(o)the-Bochner空间E(X)的凸性,主要结果如下:(a)给出E(X)的端点的充分条件,得到了E(X)严格凸的判据,相应地推广了Lp(μ,X)以及LΦ(X)的结果;(b)讨论了E(X)的弱局部一致凸和局部完全k-凸;(c)刻画了E(X)的强凸,给出了E(X)强凸的充要条件.     

弱(L_1,L_2)-BLD映射的正则性

本文首先将文［１］中的ＢＬＤ映射推广为弱（Ｌ１，Ｌ２）－ＢＬＤ映射，并证明了如下正则性结果：存在两个可积指数 Ｐ１＝Ｐ１（ｎ，Ｌ１，Ｌ２）＜ｎ＜ｑ１＝ｑ１（ｎ，Ｌ１，Ｌ２），使得对任意弱（Ｌ１，Ｌ２）－ＢＬＤ映射ｆ∈（Ω，Ｒｎ），都有ｆ∈（Ω，Ｒｎ），即ｆ为（Ｌ１，Ｌ２）－ＢＬＤ映射．     

纳米Zr-V-O粉末的XRD及TG-DSC研究

利用机械合金化制备纳米Zr-V粉末，对制备过程的材料进行物相分析和热分析试验。初始粉末Zr（150μm）和V（150μm）元素粉末（纯度99．15％）按原子比1：2或1：1进行混合后在氩气气氛中放入SimoloyerCMol—2球磨仓中，按几种不同的试验条件进行球磨。同时在997K和1047K下热处理40min和1h，并对热处理前后的粉末进行了物相和TG-DSC实验分析。     

基于进化人工神经网络的组合系统滤波技术

在组合系统运用Kalman滤波器技术时,准确的系统模型和可靠的观测数据是保证其性能的重要因素,否则将大大降低Kalman滤波器的估计精度,甚至导致滤波器发散.为解决上述Kalman应用中的实际问题,提出了一种新颖的基于进化人工神经网络技术的自适应Kalman滤波器.仿真试验表明该算法可以在系统模型不准确时、甚至外部观测数据短暂中断时,仍能保证Kalman滤波器的性能.     

Nano-tribological study on a super-hydrophobic film formed on rough aluminium substrates

A novel super-hydrophobic stearic acid (STA) film with a water contact angle of 166^o was prepared by chemical adsorption on aluminum wafer coated with polyethyleneimine (PEI) film. The micro-tribological behavior of the super-hydrophobic STA monolayer was compared with that of the polished and PEI-coated Al surfaces. The effect of relative humidity on the adhesion and friction was investigated as well. It was found that the STA monolayer showed decreased friction, while the adhesive force was greatly decreased by increasing the surface roughness of the Al wafer to reduce the contact area between the atomic force microscope (AFM) tip and the sample surface to be tested. Thus the friction and adhesion of the Al wafer was effectively decreased by generating the STA monolayer, which indicated that it could be feasible and rational to prepare a surface with good adhesion resistance and lubricity by properly controlling the surface morphology and the chemical composition. Both the adhesion and friction decreased as the relative humidity was lowered from 65% to 10%, though the decrease extent became insignificant for the STA monolayer. The project supported by the National Natural Science Foundation of China (50375151, 50323007, 10225209) and the Chinese Academy of Sciences (KJCX-SW-L2)