Research on lenses assemble precision in complicate laser amplification system

In a certain amplification system, signal laser can be amplified from 1 nJ to 5 J. To realize a high quality imaging transfer, meet beam diameter expansion requirement, and get good filtering effects, three spatial filters are designed and assembled. Lenses in these spatial filters can be assembled and adjusted by their reflection spots to meet wave-front requirements. In this letter, we analyze precision of the assembling, and make a ray-tracing simulation to discuss the relation between assembling precision and lenses parameters. On the optimized distance of 1000 mm, adjusting precision of lens tilt can reach 5 mrad.     

High-voltage SOI lateral MOSFET with a dual vertical field plate

A new silicon-on-insulator(SOI)power lateral MOSFET with a dual vertical field plate(VFP)in the oxide trench is proposed.The dual VFP modulates the distribution of the electric field in the drift region,which enhances the internal field of the drift region and increases the drift doping concentration of the drift region,resulting in remarkable improvements in breakdown voltage(BV)and specific on-resistance(Ron,sp).The mechanism of the VFP is analyzed and the characteristics of BV and Ron,spare discussed.It is shown that the BV of the proposed device increases from 389 V of the conventional device to 589 V,and the Ron,sp decreases from 366 m·cm2to 110 m·cm2.     

空间电荷效应对热场致发射中诺廷汉效应的影响

热场致发射阴极所产生的强流电子束具有很强的空间电荷效应,为研究该效应对热场致发射过程中诺廷汉（Nottingham）效应的影响机理,在理论分析的基础上,用数值方法研究了不同逸出功和多个外加电场条件下考虑空间电荷效应对诺廷汉效应结果的影响,并与不考虑空间电荷效应时的情形进行了对比. 结果表明：空间电荷效应的强弱会显著影响到阴极表面的稳态电场,进而对诺廷汉效应产生不可忽略的影响;当逸出功在3.0–4.52 eV、外加电场在3×10⁹–9×10⁹ V/m范围内时,考虑空间电荷效应的影响后,热场致发射电子所带走的平均能量较不考虑空间电荷效应时增加0–2.5 eV,且温度越高或外加电场越大时,该增加值越大;考虑空间电荷效应对诺廷汉效应的影响后,热场致发射电子从阴极带走的平均能量随外加电场的增加呈非线性下降规律;当阴极表面温度较高时,诺廷汉效应中的冷却效应随二极管间隙距离的变大而增强. 关键词： 热场致发射 诺廷汉效应 空间电荷效应 阴极表面电场     

微乳液-水热结合法制备光色可调的α-NaYF4:Yb,Er,Tm纳米材料

采用微乳液-水热结合法制备了NaYF4:Yb3+,Er3+,Tm3+纳米粒子,利用X射线衍射(XRD)、扫描电镜(SEM)等手段对样品的物相、结构和形貌进行了分析与表征。产物的X射线衍射峰与标准卡片PDF#77-2042完全一致,属于立方相NaYF4;SEM图片显示所制备的纳米粒子形貌和粒径都比较均一,为120nm左右的棉花状小球,由纳米微粒聚集而成;在980nm光的激发下,纳米粒子能够同时发出蓝光(438和486nm)、绿光(523和539nm)和红光(650nm);通过调节Tm3+:Er3+的比例(0,0.5,0.8,1,2,3,5,7),由色度坐标图(CIE)可以看出当Tm3+和Er3+的比例从0增加到2时,样品的整体发光光色是向绿光方向移动;当Tm3+和Er3+的比例为1:1时,得到伪白光;Tm3+和Er3+的比例从2到7时,样品整体的发光向红光方向移动。     

风机封闭系统内噪声模拟分析

风机系统工作时的一个突出问题是其进风口和出风口产生的噪声。由于风机流场非常复杂,以及实验成本、实验条件限制,基于计算流体力学（Computational Fluid Dynamics, CFD）的理论逐渐成为风机噪声估计的重要方法。本文拟通过对由风机及其冷却系统构成的封闭系统进行数值建模和仿真,判断出风机主要气动噪声源的位置和种类,为处于封闭系统内的风机的噪声大小预测,提供一个可供参考的信息。结果表明：风机出口腔体内部非定常压力波动强度最大。     

Experimental investigation of a flowing fluid layer on metal surface roughness measurement and aberration correction using adaptive optics

The induced optical aberration of laser beam passing through a transparent flowing fluid layer on a metal specimen is experimentally and empirical formula studied. The proposed study presents an experimental investigation of metal surface roughness measurement by combining an optical probe of laser-scattering phenomena and adaptive optics (AO) for aberration correction. In the absence of the AO correction scheme, induced flow velocity of 0.278 m/s can severely degrade the residual wavefront root mean square (RMS) error to 0.58 μm and decrease the scattered laser intensity. Real-time AO correction in closed-loop at a sampling rate of 8Hz can reduce the wavefront RMS error to 0.19 μm and improve the attenuation of scattered laser intensity. The maximum relative error of the estimated roughness (R _a) is less than 7.8% compared with the stylus method. The experimental results show satisfactory correction in the presence of a flowing fluid layer using the AO system.     

Reanalysis of the photoassociation spectrum of 133Cs2 （6P3/2） lg state

Reanalysis of the photoassociation spectrum of the weakly binding （6S1/2 ＋ 6P3/2） lg 133Cs2 levels, reported in the previous study [J. Mol. Spectro. 255 （2009） 106], is performed by using a Lu-Fano graph coupled to the improved LeRoy- Bernstein formula including two additional modified terms. A more accurate coefficient （c3） is obtained for the leading long-range potential （-c3/R3） of a diatomic molecule.     

Lead zirconate titanate behaviors in an LDMOS

The behaviors of lead zirconate titanate (PZT) deposited as the dielectric for high-voltage devices are investigated experimentally and theoretically. The devices demonstrate not only high breakdown voltages above 350 V, but also excellent memory behaviors. A drain current-gate voltage (ID-VG) memory window of about 2.2 V is obtained at the sweep voltages of ±10 V for the 350-V laterally diffused metal oxide semiconductor (LDMOS). The retention time of about 270 s is recorded for the LDMOS through a controlled ID-VG measurement. The LDMOS with memory behaviors has potential to be applied in future power conversion circuits to boost the performance of the energy conversion system.     

傅里叶红外光谱仪分束器自动装调系统设计

为了提高傅里叶红外光谱仪干涉系统的精度,设计了一种基于一体化分束器的自动装调系统。使用光学胶水将棱镜与分束器固定在一起组成一体化分束器,在一体化分束器上设置三点调整机构,O点位置进行固定作为参考点,在X点、Y点位置装入压电陶瓷,利用压电陶瓷驱动分束器进行微小位移的调整。在动镜匀速运动的情况下,利用四象限检测器检测三路携带相位差信息的信号,对信号进行放大滤波和数字化处理后,采用DSP的ECAP模块捕捉三路相位差信号,并利用增量式PID算法根据相位差来对三个点位的调整幅度进行实时控制,使用DSP的AD模块采集三路信号,并利用USB2.0与上位机进行通信,在上位机上实时显示三路信号图形及相位差信息。利用光学胶水的紫外固化特性,在支架上安装紫外照射灯,调整过程中不断增加照射强度使光学胶水进行深度固化,从而制作出符合傅里叶变换红外光谱仪应用需求的一体化分束器。实验结果表明,所设计的基于一体化分束器的自动装调系统具有结构简单,调整精度高等优点,其能够满足常规红外分束器装调需求。     

A Mössbauer spectroscopic study of an industrial catalyst for dehydrogenation of etylbenzene to styrene

Iron oxide catalyst with spinel structure used for dehydrogenation of ethylbenzene is one kind of important catalyst in petrochemical industry. In this work several series of industrial catalyst were prepared with different components and different manufacturing processes. Mössbauer Spectroscopy has been used to determine the optimal components and the better manufacturing process for spinel structure formation. The results may prove useful for producing the industrial dehydrogenation catalyst with better catalytic property.