| 高能X射线工业CT数据传输系统的设计 |
| |
| 引用本文： | 段黎明,廖平,张平,李胜颚.高能X射线工业CT数据传输系统的设计[J].强激光与粒子束,2008,20(9). |
| |
| 作者姓名： | 段黎明 廖平 张平 李胜颚 |
| |
| 作者单位： | 1．重庆大学 ICT研究中心， 重庆 400044；2．第二炮兵驻成都地区军事代表室， 成都 610031 |
| |
| 基金项目： | 国家高技术研究发展计划(863计划) |
| |
| 摘 要： | 针对高能X射线工业CT的特点，开发了基于USB2.0的数据传输系统。该传输系统主要包括USB2.0接口部分和传输控制部分。USB2.0接口部分使用Cypress公司的EZ-USB FX2系列CY7C68013A芯片，配置为从属FIFO接口模式，通过块传输方式将数据传送给上位机。传输控制部分使用Altera公司Cyclone系列EP1C6Q240C8N芯片，定义缓冲区接收来自探测部分的数据，产生逻辑控制信号和时序信号，发送数据到USB的端点缓冲区。测试表明该传输系统易于扩展，占用系统资源少，传输速率高，满足高能X射线工业CT数据传输的要求。
|
| 关 键 词： | X射线 工业CT 数据传输 USB FPGA |
| 收稿时间： | 1900-01-01; |
Design of data transmission system for high-energy X-ray industrial CT |
| |
| DUAN Li-ming,LIAO Ping,ZHANG Ping,LI Sheng-e.Design of data transmission system for high-energy X-ray industrial CT[J].High Power Laser and Particle Beams,2008,20(9). |
| |
| Authors: | DUAN Li-ming LIAO Ping ZHANG Ping LI Sheng-e |
| |
| Institution: | 1. ICT Research Center, Chongqing University, Chongqing 400030, China;2. The Second Artillery Military Representative Office Stationed Chengdu Region, Chengdu 610031, China |
| |
| Abstract: | Aiming at the characteristics of high-energy X-ray industrial computerized tomography(CT), a data transmission system based on USB2.0 was developed. The system consists of a USB2.0 interface and a transmission control unit. The USB20 interface unit uses Cypress’s EZ-USB FX2-CY7C68013A chip, which is set as the slave FIFO interface model to transfer data to host computer by bulk transfer mode. The transmission control unit uses Altera’s Cyclone- EP1C6Q240C8N chip which defines buffer to receive the data from detecting part, generate logic control signals and timing sequence signals, and send the data to the endpoint buffer of USB. The data transmission system was tested well and can meet the requirements of high-energy X-ray industrial CT. Also it can expand easily and take up a few sys |
| |
| Keywords: | FPGA |
| 本文献已被 维普 万方数据 等数据库收录！ |
| 点击此处可从《强激光与粒子束》浏览原始摘要信息 |
| 点击此处可从《强激光与粒子束》下载免费的PDF全文 |
