Plasma-polymerized thiophene films for enhanced rubber-steel bonding |
| |
Authors: | James L Delattre |
| |
Institution: | University of Bari, Department of Chemistry, Via Orabona, 4, 70126 Bari, Italy |
| |
Abstract: | Thin films of plasma-polymerized thiophene (PPTh) were deposited on cold-rolled steel substrates to improve adhesion to rubber compounds. PPTh films were characterized by X-ray photoelectron spectroscopy, Fourier transform infrared spectroscopy (FT-IR) and atomic force microscopy. The ratio of carbon-to-sulfur found in PPTh films is 4:1, suggesting the monomer structure is generally intact, which was supported by FT-IR absorptions characteristic of polymerized thiophene rings. However, some fragmentation did occur to give acetylenic and aliphatic groups. Steel-rubber adhesion measurements, performed in accordance with the ASTM 429-B peel test, strongly depended on cleaning and pretreatment methods as well as film thickness. Best results were obtained on polished steel samples that were cleaned with acid, pretreated with a hydrogen/argon plasma, then coated with 50 Å of PPTh film. These samples exhibited a peel force of 14.3 N/mm, which is comparable to that of polished brass control samples. Depth-profiling XPS analysis of the rubber-steel interface showed the existence of an iron sulfide layer which is likely responsible for the strong adhesion. |
| |
Keywords: | Thiophene Plasma-assisted CVD Adhesion-solid surfaces and interfaces Depth-profiling Rubber Steel |
本文献已被 ScienceDirect 等数据库收录! |
|