部分相干电磁光束在湍流介质中传输的偏振变化

 从推广的惠更斯-菲涅尔原理出发，推导出了部分相干电磁光束的偏振态在湍流介质中传输的表达式。并以电磁高斯-谢尔模型(EGSM)光束为例，研究了湍流对电磁高斯-谢尔模型光束偏振态的影响。研究结果表明，对于轴上点，湍流介质的折射率结构常数越大，偏振度趋于最大值的速度越快，达到的最大值越小；光斑越大，偏振度达到最大值的位置离光源越远，在光斑增大的过程中，偏振度所达到的极大值会先增大后减小，最后保持与光源相同的偏振度不变。对于轴外点，一个固定的z，光的偏振度随着离轴距离的增大而逐渐下降，并最终等于零。折射率结构常数越大，偏振度随离轴距离的增大而下降得越缓慢；光斑越大，偏振度随离轴距离的增大下降得越快。     

激光雷达中层大气遥感技术

介绍了中科院武汉物理与数学研究所瑞利激光雷达的技术特点，并从其对武汉地区中层大气密度和温度廓线探测的典型结果，给出了该激光雷达对中层大气主要参数的探测能力。     

Changes in the spectrum of Gaussian Schell-model beams propagating through turbulent atmosphere

Based on the extended Huygens-Fresnel principle, the spectrum of Gaussian Schell-model (GSM) beams propagating through turbulent atmosphere is derived analytically. It is shown that, if the scaling law is valid, the normalized spectrum S(ω) of GSM beams propagating through turbulent atmosphere is the same as the normalized source spectrum S⁽⁰⁾(ω), whether GSM source is quasi-homogenous or not. On the other hand, if the scaling law fails, S(ω) of GSM is different from S⁽⁰⁾(ω). The structure constant of the refractive index, transverse coordinate of observation point and spatial correlation length of the source affect the spectrum, which is illustrated numerically.     

木质装饰板材贫氧条件下燃烧和热解特性研究

本文利用热重差热分析仪,在各种不同的氧气浓度下对落叶松、红木和红松样品进行实验。通过对TG、DTG和DTA曲线的分析,样品干燥基要经历两个失重过程,第一个失重过程主要是纤维素和半纤维素的热解,第二个失重过程主要是木质素的炭化分解和燃烧。在各氧气浓度条件下,热解失重的第一个阶段TG和DTG曲线差异很小;在各样品失重的第二个阶段,随着氧气浓度的增加,TG和DTG曲线左移,反应结束的温度明显降低。氧气能使木质素的炭化物氧化并进而可能使其着火燃烧,从而使反应进程加快。当氧气浓度大于6.32%时,各样品DTA曲线上均有两个明显放热峰,并且随着氧气浓度的增加,DTA曲线放热峰越尖锐,放热峰面积越大,说明氧气浓度越大,在两阶段失重过程中更多的挥发分物质和固体炭化物参与燃烧。     

SIMS analysis of residual gas elements with a Cameca IMS-6f ion microprobe

In this paper, we present experimental data for SIMS analysis of residual gas elements (RGEs) with a Cameca IMS-6f ion microprobe. We considered a simple experimental technique, which provides an effective separation of the secondary ions, sputtered from the bulk of a target, and from the molecules, adsorbed on the analyzed surface from the residual atmosphere. The technique needs the sputtering yield of one monolayer (ML) per second to be applied. The method improves (in more than one order of magnitude) the detection limit for RGEs in SIMS analysis, and simultaneously, provides information about the residual atmosphere at the sample surface and in the main chamber of the experimental instrument. The method provides a calibration method for an ion gauge, and can be used for SIMS analysis with a gas (O₂) flooding.     

钛硅分子筛TS-1合成晶化气氛的影响

考察了不同晶化气氛(N2、H2、A ir、O2)对合成钛硅分子筛TS-1的影响,用XRD、IR和N2吸附/脱附对所合成的钛硅分子筛进行结构表征,发现在H2气氛下合成的TS-1结晶度最高,锐钛矿的含量最少;O2气氛下合成的TS-1中锐钛矿含量最高.以氯丙烯氧化为模型反应,考察了不同晶化气氛下合成的钛硅分子筛的催化活性和双氧水的利用效率.结果表明,在H2气氛下所合成的钛硅分子筛的双氧水的利用效率最高.     

紫外拉曼光谱研究焙烧气氛对氧化锆相变的影响

 以紫外拉曼光谱技术研究了在不同焙烧气氛中氧化锆样品的表面晶相结构及其转变过程．结果表明，在有氧气氛中焙烧的氧化锆样品易转变为单斜相，而在惰性气氛中焙烧可以有效地稳定样品体相和表面的四方相结构．在缺氧气氛中焙烧的样品暴露于空气中后，表面极易转变为单斜相，而其体相仍为四方相结构，这表明四方相氧化锆在样品表面是极不稳定的．     

液相色谱/大气压化学电离飞行时间质谱分析氢化可的松中微量杂质

采用液相色谱/大气压化学电离飞行时间质谱测定氢化可的松对照品中微量杂 质，并采用源内碰撞诱导解离质谱进行了结构定性分析。方法简单，可靠，重现性 好。     

Influence of Gas Atmosphere on Removal of Sulphate Groups From Titanium Oxide

The studies were devoted to determination of the effect of gas atmosphere and its pressure on the second step of decomposition of hydrated titanium dioxide (HTD) promoted by sulfate groups. It has been found that thermal decomposition of HTD at temperatures above 300°C consists of a number of processes such as dehydroxylation, desulfuration, recrystallization and sintering of solid grains, photochemical processes (if the decomposition proceeds in the presence of light) and adsorption of gas phase components (in the presence of air or SO₂). Kinetic parameters characterizing this step of decomposition have been determined for processes carried out in vacuum and in argon or air atmospheres (at a pressure of 13.33hPa). The kinetic curves of decomposition carried out in the presence of gases capable of being adsorbed on the surface of partly dehydrated HTD are featured by local extrema due to simultaneous processes of decomposition and adsorption of gas components. This revised version was published online in August 2006 with corrections to the Cover Date.     

Ordered porous films based on fluorinated polyimide derived from 2,2′-bis(3,4-dicarboxyphenyl) hexafluoropropane dianhydride and 3,3′-dimethyl-4,4′-diaminodiphenylmethane

One of fluorinated polyimides was synthesized from 2,2′-bis(3,4-dicarboxyphenyl) hexafluoropropane dianhydride (6FDA) and 3,3′-dimethyl-4,4′-diaminodiphenylmethane (DMMDA) by two-steps method, which had good solubility and hydrophilicity. 6FDA-DMMDA polyimide was dissolved in chloroform (CHCl₃) and cast on a glass substrate in a humid atmosphere. It was found that 6FDA-DMMDA/CHCl₃ solution was easy to form ordered porous structure at high concentration, and the reason was discussed in detail. In addition, the influences of solution concentration, the atmosphere humidity, were also tested.