QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

Construction of a QCM sensor for detecting diethylstilbestrol in water based on the computational design of molecularly imprinted polymers

Combining molecular imprinting technology and quartz crystal microbalance (QCM), the diethylstilbestrol-molecularly imprinted polymers (DES-MIPs) were designed. The LC-ωPBE/6-31G(d,p) method was chosen to predict the properties of DES-MIPs in this study. The calculated results showed that the complex formed from DES and methacrylic acid with molar ratio of 1:5 and ethylene dimethacrylate as cross-linking agent had the largest amount of hydrogen bonds, the lowest binding energy, and the optimal stability property. With the guidance of calculations, the DES-MIPs were used to prepare QCM electrode by embedding method to construct the DES-MIPs-QCM sensor. The experimental results displayed that the sensor had a high binding affinity for DES when the DES-MIPs was 15 mg and the coating volume was 10 µL. The minimum detection limit of the sensor for DES was 2.63 ng/mL in the range of 50 to 350 ng/mL. The DES-MIPs-QCM sensor exhibited high recognition capacity for DES compared to its structural analogs. The sensor had been successfully used for the determination of DES in the actual water samples.     

石英的顺磁中心在电子自旋共振测年中的特性及应用

沉积物的电子自旋共振测年是利用石英矿物中的顺磁中心浓度确定总辐射能量,进而推定石英矿物的埋藏年代。石英中可用于测年的顺磁中心包括E’心、Al心、Ti心和Ge心。E’心需要经过热活化后才能测年。Al心是一种电子空穴心,在低温下可观测到较强的信号值。光照可以使Al心漂白,但有残留值存在。Ti心、Ge心都是电子中心,Ti心在低温测试中可见,信号微弱。Ge心光晒退最敏感,在常温观测中可见。不同顺磁中心的形成机理不同导致它们具有不同的特性,适用于不同沉积环境中的样品测年,在冰碛物中Ge心测年更具有可行性。电子自旋共振测试时降低温度可使信号增强,Ti心在10 K和15 K时信号强度最大;Al心在20 K时信号最强。Ge心在200 K时信号明显增强。在电子自旋共振测年中可根据不同顺磁中心信号强度的变化调整测试温度获得信号的最优值。在以后的ESR测试中可以选取信号最强时的测试温度进行测试,以增强微弱信号的信噪比,有利于对复杂的信号形态的分辨确定,提高对信号强度定量的准确性。     

New approach for natural products screening by real-time monitoring of hemoglobin hydrolysis using quartz crystal microbalance

The hemoglobin (Hb) released from erythrocytes is a primary nutritive component for many blood-feeding parasites. The aspartic protease cathepsin D is a hemoglobinase that is involved in the Hb degradation process and is considered an interesting target for chemotherapy intervention. However, traditional enzymatic assays for studying Hb degradation utilize spectrophotometric techniques, which do not allow real-time monitoring and can present serious interference problems. Herein, we describe a biosensor using simple approach for the real-time monitoring of Hb hydrolysis as well as an efficient screening method for natural products as enzymatic inhibitors using a quartz crystal microbalance (QCM) technique. Hemoglobin was anchored on the quartz crystal surface using mixed self-assembled monolayers. The addition of the enzyme caused a mass change (frequency shift) due to Hb hydrolysis, which was monitored in real time. From the frequency change patterns of the Hb-functionalized QCM, we evaluated the enzymatic reaction by determining the kinetic parameters of product formation (k_cat). The QCM enzymatic assay using immobilized human Hb was shown to be an excellent approach for screening possible inhibitors in complex mixtures, opening up a new avenue for the discovery of novel inhibitors.     

动态加载过程中石英玻璃诱导水的快速结晶相变

在气炮加载试验中利用弹载光源原位测试技术,观测了夹于石英玻璃之间的水在动态压缩过程中的透光特性. 通过其光透射特性研究了水的冲击相变. 实验结果发现液态水在动态冲击压缩过程中, 其压力低于2 GPa 就出现透明性变差的现象,而且水的透明性下降与石英玻璃的存在有关,是一种石英诱导水的结晶相变现象.     

Quartz Crystal Microbalance Biosensor for Saxitoxin Based on Immobilized Sodium Channel Receptors

This work explored the possibility of coupling the toxin receptor-binding principle with the piezoelectric transduction principle. The sensing component of the saxitoxin biosensor involves a piezoelectric quartz crystal that was coated with sodium channel receptors. The sodium channel receptors were isolated from the electroplax organ of Electrophorus electricus. Binding of the sodium channel extracts to the quartz crystal was facilitated by pre-coating the gold electrode with a hydrophobic self-assembled monolayer of dodecanethiol. The instrumentation system consisted of a flow cell that held the quartz crystal, an oscillator circuit, an injection port, and a frequency counter that was connected to a personal computer. The various immobilization and measurement parameters were optimized. Binding of saxitoxin standards with the immobilized sodium channels was monitored through the decrease in the crystal oscillation frequency readings (ΔF) upon the introduction of saxitoxin into the flow cell. A calibration curve for saxitoxin was constructed by plotting the ΔF values vs. saxitoxin concentrations in the range from 0.1 to 2.0 μg/mL. A correlation coefficient of 0.9653 was obtained. The saxitoxin biosensor developed has the potential to be applied to the rapid screening of total paralytic shellfish poisoning toxins.     

A Fast Electrochemical Quartz Crystal Microbalance,which Acquires Frequency and Bandwidth on Multiple Overtones

An electrochemical quartz crystal microbalance (EQCM) is described, which measures the shifts of frequency and bandwidth on multiple harmonics with a time‐resolution of 10 milliseconds. The technique requires the process under study to be repetitive. Examples are square wave amperometry and cyclovoltammetry. Data acquisition is fast because the raw data consist of traces of the electrical admittance at fixed frequencies . A few (∼10) such time traces are acquired sequentially at a set of frequencies evenly spaced around the crystal's resonance. Since all time‐traces are triggered by the same repetitive process, plots of the conductance G (ω_i , t ) and the susceptance B (ω_i , t ) from constant time delays, t , versus frequency can be produced a posteriori. The shifts, ΔG (ω_i ) and ΔB (ω_i ) quantify a difference between two resonance curves, pertaining to the sample's reference state and the state at time t . Fitting a difference of two resonance curves to these data, one obtains shifts of frequency, Δf (t ) and shifts of bandwidth, ΔΓ(t ), versus time. This procedure is repeated for the different overtones. Given the repetitive nature of the process, one may accumulate and average, which lowers the noise down to a few tens of mHz. The capabilities of this instrument are demonstrated with two examples, which are copper deposition/dissolution and electro‐responsivity of a polymer film containing weakly acidic side groups.     

Development of Piezoelectric Immunosensor for the Detection of Probiotic Bacteria

A Quartz Crystal Microbalance (QCM) based direct immunosensor was developed for real-time detection of probiotic bacteria. To optimize the immunosensor system, model measurements were carried out with bovine serum albumin (BSA) and anti-BSA IgG (a-BSA) antibody. During the model experiments, two kinds of self-assembled monolayers were created to compare their efficiency on antigen binding. Sulfosuccinimidyl 6-[3-(2-pyridyldithio)propionamido] hexanoate (sulfo-LC-SPDP) and 16-mercapto-hexadecanoic acid (MHDA) cross-linking agents were used for immobilizing anti-BSA antibody onto the gold surface of the AT-cut quartz wafer. Two different measuring procedures, flow-through and stopped-flow methods, were applied, and the frequency responses obtained by both analytical methods were compared.

After the model experiments probiotic bacteria, Bifidobacterium bifidum O1356 and Lactobacillus acidophilus O1132 serotypes were detected from buffer solution and from real samples (spiked milk samples, acidophilus, and bifidus milk samples).

Using the novel immunosensor, the target bacteria could be detected in the range of 10⁴–10⁷ colony-forming units (CFU)/ml within 60 minutes. The selectivity of a-Bifidobacterium bifidum and a-Lactobacillus acidophilus antibody coated sensors were also tested.     

多壁碳纳米管修饰铂基片石英晶体微天平研究白细胞介素-6与其受体的相互作用

在pH 7.4、室温条件下,用多壁碳纳米管(MWCNTs)修饰石英晶体微天平(QCM) Pt基片,经过EDC/NHS活化后固定白细胞介素-6(IL-6),检测不同浓度可溶性白细胞介素-6受体(sIL-6R)与IL-6的结合所引起响应信号的变化,并用Origin软件对数据进行拟合分析,构建了一种高性能实时监测IL-6与s...     

Electrospun Poly(acrylonitrile-co-acrylic acid) Nanofibrous Membranes for Catalase Immobilization:Effect of Porphyrin Filling on the Enzyme Activity

Porphyrin-filled nanofibrous membranes were facilely prepared by electrospinning of the mixtures of poly(acrylonitrile-co-acrylic acid)(PANCAA) and porphyrins. 5,10,15,20-Tetraphenylporphyrin(TPP) and its metal-loderivatives(ZnTPP and CuTPP) were studied as filling mediators for the immobilization of redox enzyme. Results indicate that the introduction of TPP, ZnTPP and CuTPP improves the retention activity of the immobilized catalase. Among these three porphyrins, the ZnTPP-filled PANCAA nanofibrous membra...