A sensitive and efficient method for trace analysis of some phenolic compounds using simultaneous derivatization and air‐assisted liquid–liquid microextraction from human urine and plasma samples followed by gas chromatography–nitrogen phosphorous detection

In present study, a simultaneous derivatization and air‐assisted liquid–liquid microextraction method combined with gas chromatography–nitrogen phosphorous detection has been developed for the determination of some phenolic compounds in biological samples. The analytes are derivatized and extracted simultaneously by a fast reaction with 1‐flouro‐2,4‐dinitrobenzene under mild conditions. Under optimal conditions low limits of detection in the range of 0.05–0.34 ng mL^?1 are achievable. The obtained extraction recoveries are between 84 and 97% and the relative standard deviations are less than 7.2% for intraday (n = 6) and interday (n = 4) precisions. The proposed method was demonstrated to be a simple and efficient method for the analysis of phenols in biological samples. Copyright © 2015 John Wiley & Sons, Ltd.     

Construction of Charring-Functional Polyheptanazine towards Improvements in Flame Retardants of Polyurethane

Nitrogen-containing flame retardants have been extensively applied due to their low toxicity and smoke-suppression properties; however, their poor charring ability restricts their applications. Herein, a representative nitrogen-containing flame retardant, polyheptanazine, was investigated. Two novel, cost-effective phosphorus-doped polyheptazine (PCN) and cobalt-anchored PCN (Co@PCN) flame retardants were synthesized via a thermal condensation method. The X-ray photoelectron spectroscopy (XPS) results indicated effective doping of P into triazine. Then, flame-retardant particles were introduced into thermoplastic polyurethane (TPU) using a melt-blending approach. The introduction of 3 wt% PCN and Co@PCN could remarkably suppress peak heat release rate (pHRR) (48.5% and 40.0%), peak smoke production rate (pSPR) (25.5% and 21.8%), and increasing residues (10.18 wt%→17.04 wt% and 14.08 wt%). Improvements in charring stability and flame retardancy were ascribed to the formation of P–N bonds and P=N bonds in triazine rings, which promoted the retention of P in the condensed phase, which produced additional high-quality residues.     

Polyol‐enhanced dispersive liquid–liquid microextraction coupled with gas chromatography and nitrogen phosphorous detection for the determination of organophosphorus pesticides from aqueous samples,fruit juices,and vegetables

Polyol‐enhanced dispersive liquid–liquid microextraction has been proposed for the extraction and preconcentration of some organophosphorus pesticides from different samples. In the present study, a high volume of an aqueous phase containing a polyol (sorbitol) is prepared and then a disperser solvent along with an extraction solvent is rapidly injected into it. Sorbitol showed the best results and it was more effective on the extraction recoveries of the analytes than inorganic salts such as sodium chloride, potassium chloride, and sodium sulfate. Under the optimum extraction conditions, the method showed low limits of detection and quantification within the ranges of 12–56 and 44–162 pg/mL, respectively. Enrichment factors and extraction recoveries were in the ranges of 2799–3033 and 84–92%, respectively. The method precision was evaluated at a concentration of 10 ng/mL of each analyte, and relative standard deviations were found to be less than 5.9% for intraday (n = 6) and less than 7.8% for interday (n = 4). Finally, some aqueous samples were successfully analyzed using the proposed method and four analytes (diazinon, dimethoate, chlorpyrifos, and phosalone) were determined, some of them at ng/mL level.     

半夹芯16电子碳硼烷化合物Cp*CoS2C2B10H10与含磷化合物的反应性

半夹芯16电子碳硼烷化合物Cp~*CoS_2C_2B_(10)H_(10)分别与二苯基甲基膦、苯基二甲基膦和三甲基膦反应得到碳硼烷衍生物(Cp~*CoS_2C_2B_(10)H_(10))(PPh_2Me)(1)、(Cp~*CoS_2C_2B_(10)H_(10))(PPhMe_2)(2)和(Cp~*CoS_2C_2B_(10)H_(10))(PMe_3)(3)。分别用红外、核磁、元素分析、质谱和单晶X射线衍射等表征方法对1、2和3进行了结构表征。紫外可见吸收光谱结果显示化合物1、2和3在乙腈溶剂中均有2个吸收峰,第一个吸收峰分别位于321、316和321 nm;第二个吸收峰分别位于425、399和407 nm。荧光光谱结果显示化合物1、2和3在乙腈中的最大发射波长位于406 nm左右。     

Isomerization of Secondary Phosphirane into Terminal Phosphinidene Complexes: An Analogy between Monovalent Phosphorus and Transition Metals

Secondary phosphirane complexes isomerize above 100 °C to give the corresponding terminal phosphinidene complexes, which can be trapped by alkenes and alkynes. This reaction is a rare instance of the isomerization of a P^III derivative into a P^I derivative. It appears to mimic the reductive elimination of alkanes from transition‐alkylmetal hydrides.     

一些磷－氮型极压抗磨添加剂性能的研究

合成了一些磷－氮型极压抗磨添加剂烷基亚磷酸酯胺盐和氮杂环胺盐，并对其油溶性和润滑性等进行了试验研究。结果表明，磷－氮型极压抗磨添加剂的化学结构对其油溶性和极压抗磨性都有较大的影响：烷基链增长有助于油溶性的改善，氮杂环胺盐的油溶性更好；伯胺盐的抗磨性比仲胺盐和叔胺盐的都好，氮杂环胺盐的抗磨性更好；磷－氮型极压抗磨添加剂的减摩性明显比硫化烯烃、烷基亚磷酸酯和苯三唑十八胺的都好，有的在２５０℃时的摩擦系数仅约为０．０４．Ｘ射线光电子能谱和俄歇电子能谱分析发现，磷－氮型极压抗磨添加剂在摩擦表面形成了一种含氮富磷的化学反应膜。其中，元素磷是以磷酸铁的化合态形式存在，而元素氮则是以其原有的价态形式存在，这表明氮参与了整个摩擦过程。在试验研究和分析讨论的基础上，通过综合归纳还提出了磷－氮型极压抗磨添加剂的作用机理模式图。     

The Metaphosphite (PO2−) Anion as a Ligand

The utilization of monomeric, lower phosphorous oxides and oxoanions, such as metaphosphite (PO₂⁻), which is the heavier homologue of the common nitrite anion but previously only observed in the gas phase and by matrix isolation, requires new synthetic strategies. Herein, a series of rhenium(I–III) complexes with PO₂⁻ as ligand is reported. Synthetic access was enabled by selective oxygenation of a terminal phosphide complex. Spectroscopic and computational examination revealed slightly stronger σ-donor and comparable π-acceptor properties of PO₂⁻ compared to homologous NO₂⁻, which is one of the archetypal ligands in coordination chemistry.     

Mixed Boron(III) and Phosphorous(V) Complexes of meso‐Triaryl 25‐Oxasmaragdyrins

Two unprecedented mixed B^III/P^V complexes of meso‐triaryl 25‐oxasmaragdyrins were synthesized in appreciable yields under mild reaction conditions. These unusual 25‐oxasmaragdyrin complexes containing one or two seven‐membered heterocyclic rings comprised of five different atoms (B, C, N, O, and P) were prepared by reacting B(OH)(Ph)‐smaragdyrin and B(OH)₂‐smaragdyrin complexes, respectively, with POCl₃ in toluene at reflux temperature. The products were characterized by HRMS and 1D‐ and 2D‐NMR spectroscopy. X‐ray crystallography of one of the mixed B^III/P^V smaragdyrin complexes indicated that the macrocycle is significantly distorted and contains a stable seven‐membered heterocyclic ring within the macrocycle. The bands in the absorption and emission spectra were bathochromically shifted with reduced quantum yields and singlet‐state lifetimes relative to the free base, meso‐triaryl 25‐oxasmaragdyrin. The mixed B^III/P^V complexes were difficult to oxidize but easier to reduce than the free base. The DFT‐optimized structure of the 25‐oxasmaragdyrin complex with two seven‐membered heterocycles indicated that it was a bicyclic spiro compound with two half‐chair‐like conformers. This was in contrast to the chair‐like conformation of the complex with a single seven‐membered heterocyclic ring. Moreover, incorporation of a second phosphate group in the former case stabilized the bonding geometry and resulted in higher stability, which was reflected in the bathochromic shift of the absorption spectra, more‐positive oxidation potential, and less‐negative reduction potential.     

Synthesis and performance of electroless Ni–P–TiCN composite coatings on Al substrate

Electroless Ni–P and Ni–P–TiCN composite coatings have been deposited successfully on Al substrates. Scanning electron microscopy (SEM) and energy dispersive X‐ray (EDX) techniques were applied to study the surface morphology and the chemical composition of the deposited films. Moreover, X‐ray diffraction (XRD) proved that Ni–P and Ni–P–TiCN deposits have amorphous structures. The properties of Ni–P–TiCN/Al composite films such as hardness, corrosion resistance and electrocatalytic activity were examined and compared with that of Ni–P/Al film. The results of hardness measurements reveal that the presence of TiCN particles with Ni–P matrix improves its hardness. Additionally, the performance against corrosion was examined using Tafel lines and electrochemical impedance spectroscopy techniques in both of 0.6 M NaCl and a mixture of 0.5 M H₂SO₄ with 2 ppm HF solutions. The results indicate that the incorporation of high dispersed TiCN particles into Ni–P matrix led to a positive shift of the corrosion potential and an increase in the corrosion resistance for all aluminum substrates after their coating with Ni–P–TiCN. In addition, Ni–P–TiCN/Al electrodes showed a higher electrochemical catalytic activity and stability toward methanol oxidation in 0.5 M NaOH solution compared with that of Ni–P/Al. Copyright © 2014 John Wiley & Sons, Ltd.