Total Synthesis of Lajollamycin B

The first total synthesis of lajollamycin B, a structurally novel nitro-tetraene spiro-β-lactone/γ-lactone antibiotic, is described. The convergent synthesis involves the construction of the C8′–C11′ nitrodienylstannane and its coupling with the segment prepared from the C1′–C7′ ω-iodoheptadienoic acid and the right-hand heterocyclic fragment, which has been utilized for our previous syntheses of oxazolomycin A. The revision of the geometry of the terminal Δ^{10′, 11′}-double bond from E to Z is also described for the structure of natural lajollamycin B.     

Tailorable PC71BM Isomers: Using the Most Prevalent Electron Acceptor to Obtain High‐Performance Polymer Solar Cells

Despite being widely used as electron acceptor in polymer solar cells, commercially available PC₇₁BM (phenyl‐C₇₁‐butyric acid methyl ester) usually has a “random” composition of mixed regioisomers or stereoisomers. Here PC₇₁BM has been isolated into three typical isomers, α‐, β₁‐ and β₂‐PC₇₁BM, to establish the isomer‐dependent photovoltaic performance on changing the ternary composition of α‐, β₁‐ and β₂‐PC₇₁BM. Mixing the isomers in a ratio of α/β₁/β₂=8:1:1 resulted in the best power conversion efficiency (PCE) of 7.67 % for the polymer solar cells with PTB7:PC₇₁BM as photoactive layer (PTB7=poly[[4,8‐bis[(2‐ethylhexyl)oxy]benzo[1,2‐b:4,5‐b′]dithiophene‐2,6‐diyl][3‐fluoro‐2‐[(2‐ethylhexyl)carbonyl]thieno[3,4‐b]thiophenediyl]]). The three typical PC₇₁BM isomers, even though sharing similar LUMO energy levels and light absorption, render starkly different photovoltaic performances with average‐performing PCE of 1.28–7.44 % due to diverse self‐aggregation of individual or mixed PC₇₁BM isomers in the otherwise same polymer solar cells.     

Analysis of new psychoactive substances in human urine by ultra‐high performance supercritical fluid and liquid chromatography: Validation and comparison

New psychoactive substances represent serious social and health problem as tens of new compounds are detected in Europe annually. They often show structural proximity or even isomerism, which complicates their analysis. Two methods based on ultra high performance supercritical fluid chromatography and ultra high performance liquid chromatography with mass spectrometric detection were validated and compared. A simple dilute‐filter‐and‐shoot protocol utilizing propan‐2‐ol or methanol for supercritical fluid or liquid chromatography, respectively, was proposed to detect and quantify 15 cathinones and phenethylamines in human urine. Both methods offered fast separation (<3 min) and short total analysis time. Precision was well <15% with a few exceptions in liquid chromatography. Limits of detection in urine ranged from 0.01 to 2.3 ng/mL, except for cathinone (5 ng/mL) in supercritical fluid chromatography. Nevertheless, this technique distinguished all analytes including four pairs of isomers, while liquid chromatography was unable to resolve fluoromethcathinone regioisomers. Concerning matrix effects and recoveries, supercritical fluid chromatography produced more uniform results for different compounds and at different concentration levels. This work demonstrates the performance and reliability of supercritical fluid chromatography and corroborates its applicability as an alternative tool for analysis of new psychoactive substances in biological matrixes.     

Impact of Imine Bond Orientations on the Geometric and Electronic Structures of Imine-based Covalent Organic Frameworks

Many efforts are currently devoted to improving the stability and crystallinity of imine-based two-dimensional (2D) covalent organic frameworks (COFs) given their wide range of potential applications. The variation in the relative orientations of the imine bonds has been found to be a critical factor that impacts the stacking of the 2D COF layers, leads to the formation of isomer structures, and influences the crystallinity of the final product. Most investigations to date have focused only on the structural properties, while the role of the imine orientations on the electronic properties has not been studied systematically. Here, we explore this effect by examining how the electronic band structures, electronic couplings, and effective masses evolve when considering four isomeric structures of an imine-linked tetraphenyl-pyrene naphthalene-diimide COF. Our results provide an understanding of the impact of the imine orientations and how they need to be controlled to realize COF inter-layer stackings that can lead to efficient cross-plane electron transport. They can be used to guide the design and synthesis of imine-based COFs for applications where charge transport needs to be optimized.     

CH3COOH.TiO2: An excellent catalyst for the green nitration of toluene by N2O4

The solvent-free nitration of toluene with N₂O₄ gas over solid acid catalysts is a green reaction for preparing the mono-nitrotoluene (NT) isomers. The acid-modified catalysts are more efficient than common catalysts for this type of reaction. For this purpose, a titanium dioxide (TiO₂) catalyst is synthesized with a sol-gel method and modified by acetic acid to increase catalytic properties. The acid-modified TiO₂ (CH₃COOH·TiO₂) is characterized by different analyses. To optimization of toluene nitration conditions, reaction temperature (X₁) (30 < X₁ < 60 °C), N₂O₄/toluene molar ratio (X₂) (0.5 < X₂ < 2), and the amount of catalyst (X₃) (0.05 < X₃ < 0.3 g) factors were investigated by Minitab software with the CCD-RSM. Three responses including the selectivity of meta-NT isomer (S_m), the ratio of para-NT to ortho-NT selectivity (S_p/o), and the selectivity of by-products (S_bp) were considered for the optimization. Statistical parameters were applied to evaluate the goodness of fitting for the models. Optimum values for X₁, X₂, and X₃ parameters are 57.9 °C, 1.91, and 0.25 g, respectively. The conversion of toluene under these conditions is 93.2%. The comparison of S_m, S_p/o, and S_bp in CH₃COOH.TiO₂ (1.51%, 0.8, and 5.48%, respectively) with Fe₂O₃ (8.5%, 0.43, and 20.57%, respectively), SiO₂ (8.43%, 0.48, and 16.24%, respectively), TiO₂ (5.9%, 0.57, and 13.87%, respectively), TiO₂–Fe₂O₃ (4.72%, 0.64, and 9.18%, respectively), and TiO₂–SiO₂ (4.42%, 0.67, and 5.73%, respectively) catalysts show that this catalyst has a low S_m and S_bp as well as a higher S_p/o than other mentioned catalysts. The mechanism of the mentioned reaction is reviewed in the presence of CH₃COOH·TiO₂ catalyst. The high stability of the CH₃COOH·TiO₂ is proved by the reusability test, and it is found that its stability against inactivation is more than the TiO₂ catalyst.     

喹啉黄中各组分的定性及定量研究

利用高效液相色谱(HPLC)对喹啉黄各组分进行分离并定量,通过液相色谱–串联质谱(LC–MS/MS)对各组分进行定性。以0.01 mol/L乙酸铵溶液和甲醇为流动相进行梯度洗脱,利用Agilent XDB–C18色谱柱对喹啉黄各组分进行分离,峰面积归一化法定量。质谱采用电喷雾负离子(ESI–)模式电离,多反应监测(MRM)模式检测,对喹啉黄各组分进行定性。结果表明,喹啉黄主要成分为喹啉黄一钠盐和喹啉黄二钠盐,分别各有两种同分异构体,各组分质量浓度在5.0~100.0μg/m L范围内与峰面积呈良好的线性关系。加标回收率为98.2%~99.1%,测定结果的相对标准偏差为0.90%~1.58%(n=6)。该方法具有良好的精密度和准确度,可用于喹啉黄中各组分的测定。     

Synthesis of Inorganic Structural Isomers By Diffusion‐Constrained Self‐Assembly of Designed Precursors: A Novel Type of Isomerism

The structure of precursors is used to control the formation of six possible structural isomers that contain four structural units of PbSe and four structural units of NbSe₂: [(PbSe)_1.14]₄[NbSe₂]₄, [(PbSe)_1.14]₃[NbSe₂]₃[(PbSe)_1.14]₁[NbSe₂]₁, [(PbSe)_1.14]₃[NbSe₂]₂[(PbSe)_1.14]₁[NbSe₂]₂, [(PbSe)_1.14]₂[NbSe₂]₃[(PbSe)_1.14]₂[NbSe₂]₁, [(PbSe)_1.14]₂[NbSe₂]₂[(PbSe)_1.14]₁[NbSe₂]₁[(PbSe)_1.14]₁[NbSe₂]₁, [(PbSe)_1.14]₂[NbSe₂]₁[(PbSe)_1.14]₁[NbSe₂]₂[(PbSe)_1.14]₁[NbSe₂]₁. The electrical properties of these compounds vary with the nanoarchitecture. For each pair of constituents, over 20 000 new compounds, each with a specific nanoarchitecture, are possible with the number of structural units equal to 10 or less. This provides opportunities to systematically correlate structure with properties and hence optimize performance.     

Identification and separation of saxitoxins using hydrophilic interaction liquid chromatography coupled to traveling wave ion mobility‐mass spectrometry

The aim of this work was to develop a reliable and efficient analytical method to characterise and differentiate saxitoxin analogues (STX), including sulphated (gonyautoxins, GTX) and non‐sulphated analogues. For this purpose, hydrophilic interaction liquid chromatography (HILIC) was used to separate sulphated analogues. We also resorted to ion mobility spectrometry to differentiate the STX analogues because this technique adds a new dimension of separation based on ion gas phase conformation. Positive and negative ionisation modes were used for gonyautoxins while positive ionisation mode was used for non‐sulphated analogues. Subsequently, the coupling of these three complementary techniques, HILIC‐IM‐MS, permitted the separation and identification of STX analogues; isomer differentiation was achieved in HILIC dimension while non‐sulphated analogues were separated in the IM‐MS dimension. Additional structural characteristics concerning the conformation of STXs could be obtained using IM‐MS measurements. Thus, the collision cross sections (CCS) of STXs are reported for the first time in the positive ionisation mode. These experimental CCSs correlated well with the calculated CCS values using the trajectory method. Copyright © 2015 John Wiley & Sons, Ltd.     

Stochastic/Controlled Symmetry Breaking of the T8‐POSS Cages toward Multifunctional Regioisomeric Nanobuilding Blocks

Precise synthesis of nanobuilding blocks with accurately positioned functional groups presents a daunting challenge. Herein, a practical synthesis and thorough characterization of a series of T₈‐polyhedral oligomeric silsesquioxane (POSS) di‐ and triadducts is reported. Upon addition of triflic acid across the double bonds in octavinylPOSS (V₈T₈) followed by hydrolysis, the cubic symmetry of the T₈‐POSS cage (O_h) is broken into C_2v (ortho‐), C_2v (meta‐), and D_3d (para‐) for diadducts and further to C_s (oom‐), C_s (omp‐), and C_3v (mmm‐) for triadducts in a stochastic fashion. Their structures and regioconfigurations have been unambiguously demonstrated by ¹H, ¹³C, and ²⁹Si NMR spectroscopy, as well as MALDI‐TOF mass spectrometry. The assignment of the diadducts was further corroborated by converting each individual diadduct into triadduct(s), the structure of which is controlled by the symmetry of the precursor. Except for the C_3v triadduct, they can all be prepared in synthetically useful quantities. The presence of two types of highly reactive and mutually orthogonal functional groups facilitates further modification into complex nanostructures and composite materials. These unique regioisomers provide a versatile platform for constructing giant molecules and Janus silsesquioxanes.     

Selective and Simultaneous Determination of Dihydroxybenzene Isomers Based on Green Synthesized Gold Nanoparticles Decorated Reduced Graphene Oxide

In the present study, we report the simultaneous electrochemical determination of hydroquinone (HQ), catechol (CC) and resorcinol (RC) at gold nanoparticles (Au‐NPs) decorated reduced graphene oxide (RGO) modified electrode. An enhanced and well defined peak current response with a better peak separation of HQ, CC and RC is observed at RGO/Au‐NPs composite than that of RGO and Au‐NPs modified electrodes. The fabricated modified electrode shows a wide linear response in the concentration range of 3–90 µM, 3–300 µM and 15–150 µM for HQ, CC and RC, respectively. The detection limit of HQ, CC and RC is found as 0.15 µM, 0.12 µM and 0.78 µM, respectively.