共振光散射法测定环境水样中痕量锡

基于在Tris-HCl介质中,痕量锡对氯酚红-人血白蛋白-十二烷基硫酸钠体系的共振散射光谱有明显的猝灭作用;考察了它们的光谱特征、影响因素和适宜的反应条件;确定了散射光强度与Sn2 的关系,从而建立了测定痕量锡的共振光散射新方法.该法在室温下进行,操作方便,灵敏度高和选择性好.其线性范围为0.2-4.0μg/L,检出限0.12μg/L,用于环境水样中痕量Sn2 的测定,相对标准偏差小于3.1%,加标回收率为95.5%-100.5%,效果良好.     

Diode-pumped 671 nm laser frequency doubled by CPM LBO

A design of diode-pumped high-efficiency Nd:YVO₄/LBO red laser is reported. Using critical phase-matching (CPM) LBO, 671 nm red laser was obtained from 1342 nm light by intracavity frequency doubling. With an incident pump laser of 800 mW, using type-I and type-II CPM LBO, 97 and 52 mWTEM₀₀ mode red laser outputs were obtained, with optical-to-optical conversion efficiencies of up to 12.1% and 6.5%, respectively.     

用于白光LED的高亮度蓝白色荧光粉Ca2SiO3Cl2：Eu2+的发光性质

采用固相法在较低温度下合成了Eu²⁺激活的Ca₂SiO₃Cl₂高亮度蓝白色发光材料,并对其发光性质进行了研究。其发射光谱由两个谱带组成,峰值分别位于420,498nm处,归结为Ca₂SiO₃Cl₂晶体中占据两种不同Ca²⁺格位的Eu²⁺离子的5d→4f跃迁发射。改变Eu²⁺浓度,可以使样品的发光在蓝白色和绿白色之间变化。当Eu²⁺浓度为0.005mol^-1时,样品呈现很亮的蓝白色发光。两个发射峰的激发光谱均分布在250~410nm的波长范围内,峰值分别位于333,369nm处。Ca₂SiO₃Cl₂:Eu²⁺可被InGaN管芯产生的近紫外辐射有效激发,是一种性能良好的白光LED用单一基质蓝白色荧光粉。     

溶胶-凝胶法制备小颗粒(Y,Gd)BO_3∶Eu及其表征

用溶胶 凝胶方法制备了平均粒径为 1～ 2 μm的小颗粒、高发射效率的 (Y ,Gd)BO3 ∶Eu红色发射荧光体。用XRD、SEM、粒度分析和PL光谱对荧光体作了表征和研究。常规固相反应合成 (Y ,Gd)BO3 ∶Eu需在 1 2 0 0℃以上才能形成均一的固溶体。而溶胶 凝胶法制取稀土正硼酸盐 80 0℃灼烧已可形成均一的单相 (Y ,Gd)BO3 ∶Eu,在 1 1 0 0℃可得到发光亮度最高的荧光体。它的亮度是常规固相反应于 1 2 0 0℃制得的荧光体的 1 2 0 %。采用溶胶 凝胶法制取 (Y ,Gd)BO3 ∶Eu荧光体 ,可在相当宽的实验条件范围内得到小粒径、窄分布和高亮度的荧光体 ,且有良好的颗粒形貌。     

绿色荧光粉YAGG∶Tb,Gd用于FED的尝试

FED器件的发展迫切需要具有化学和热稳定性 ,高亮度 ,长寿命的新型荧光材料。本文合成了Gd3 +离子共掺杂的YAGG∶Tb获得了YAGG∶Tb ,Gd ,并将其用于 0～ 30 0 0V低压范围 ,对其在不同电压和电流密度下的发光特性进行了测试。结果表明 ,该种材料特性优于ZnO∶Zn并且不存在电压与电流饱和     

Gd3+对Ca0.8Zn0.2TiO3:Pr3+红色发光材料的敏化作用

采用溶胶-凝胶法在较低温度下合成了红色发光材料Ca0.8Zn0.2TiO3:0.002Pr3 ,xGd3 .金属离子预先溶解含有柠檬酸的乙二醇溶液中.XRD表明在800℃灼烧2h形成了钛酸盐的晶体.荧光检测结果表明所合成样品的特征激发峰为330nm、特征发射峰为614nm,分别对应于O(2p)→Ti(3d)带间跃迁和Pr3 的1D2→3H4的特征发射.样品的发光强度随x的不同而不同,发光强度增强了29%-69%.当x＝0.0005时,即nPr3 :nGd3 ＝4∶1时样品的红色发光强度最强,发光强度增强了69%.     

Optical properties of a high-efficiency glass ceramic X-ray storage phosphor

The turbidity, photoluminescence, and photo-stimulated luminescence (PSL) of fluorozirconate glass containing barium chloride nano- and micro-crystals have been measured for samples prepared by isochronal (70 min) annealing over a temperature range of 220–283°C, and correlated with the microstructure as determined by X-ray diffraction measurements. Crystallization of hexagonal phase barium chloride commences at around 220°C, but until 275°C the material retains excellent transparency although it displays negligible PSL. Between 275°C and 277°C, the hexagonal phase converts to the orthorhombic phase, the transparency abruptly decreases, and the PSL rises to a value of around 13% of that found for the commercial storage phosphor BaFBr:Eu. For a slightly higher temperature of 280°C, new phases appear which correspond to the onset of bulk crystallization, and at 283°C the relative PSL rises to 33%, while the transparency falls further. The trade-off between optical transparency and PSL over this narrow temperature window for X-ray imaging plate applications is briefly discussed.     

New developments in X-ray storage phosphors

We found a significant PSL effect in Eu²⁺-doped fluorozirconate glasses (ZBLAN) which were additionally doped with Br⁻ or Cl⁻ ions. The PSL is attributed to the characteristic emission of Eu²⁺ present in nano-crystallites of BaBr₂ or BaCl₂, which form in the glass upon annealing. The metastable hexagonal form of BaX₂ (X=Br,Cl) is always formed first before it is converted into the stable orthorhombic form. The particle size increases upon annealing and so does the PSL efficiency of the glass ceramic. However, there is a saturation of the PSL efficiency, which is for Br⁻ doping about 9% and for Cl⁻-doping about 80% of the Eu-doped BaFBr standard. The particle size was determined by transmission electron microscopy (TEM). The TEM results show a clear tendency for bigger particles for longer annealing at the expense of its number. The particle size for the most efficient phosphor is about 100 nm.     

Eu,Dy共掺杂SrAl2O4长余辉材料制备新工艺

活化Al-Sr合金粉末水解制备SrAl₂O₄长余辉材料的前驱体,并采用高温固相反应法制备出Eu,Dy共掺杂的SrAl₂O₄长余辉材料,对其微观结构和发光特性进行了研究。实验结果表明:前驱体中Al、Sr元素在微观状态下分布均匀,所制成的长余辉发光材料的发射主峰位于520nm附近,为典型的Eu²⁺离子4f5d-4f的特征发射,初始亮度达到18cd/m²,余辉时间长达46h。     

Ce3+离子敏化Eu3+∶Cr3+∶Sm3+∶YAG外延层的荧光现象

对Ce3+ ∶Eu3+ ∶Cr3+ ∶Sm3+ ∶YAG处延层中的荧光敏化现象进行了报道和分析 ,在较高浓度的Ce3+ 离子掺杂时 ,外延层在蓝色、绿色波段出现了新的荧光谱线 ,可解释为在Ce3+ 离子敏化作用下 ,Eu3+ 离子产生了由高位激发态能级5Di(i=1,2 ,3)直接到基态能级7Fj(j =0 ,1,2 ,3)的辐射跃迁过程 ,并且这种Ce3+ ∶Eu3+ ∶Cr3+ ∶Sm3+ ∶YAG外延层还是一种新颖的白色单晶荧光材料。