Hard collisions of spinning protons: Past,present and future

There will be a review of the history of polarized proton beams, and a discussion of the unexpected and still unexplained large transverse spin effects found in several high-energy proton-proton spin experiments at the ZGS, AGS and Fermilab. Next, there will be a discussion of present and possible future experiments on the violent elastic collisions of polarized protons at IHEP-Protvino's 70GeV U-70 accelerator in Russia and the new high-intensity 50GeV J-PARC facility being built at Tokai in Japan.     

Schottky metal library for ZNO-based UV photodiode fabricated by the combinatorial ion beam-assisted deposition

A binary alloy Schottky barrier diode on zinc oxide (ZnO) was developed using the combinatorial ion beam-assisted deposition system. The compositional fraction of the binary alloy was continuously varied using the composition-spread technique, to control the Schottky barrier height. After metal deposition, patterned Schottky diodes were fabricated on a ZnO single-crystal substrate. Pt-Ru alloy was selected from the work function viewpoint. Our experiments showed that the compositional fraction of the Schottky binary alloys changed continuously as designed and the Schottky barrier heights measured by current-voltage (I-V) measurements increased with increasing Pt content. Maximum barrier height difference for ZnO was 137 meV. Using ion beam deposition in parallel with the combinatorial system showed that the Schottky barrier heights for ZnO can be controlled by binary metal alloying.     

Modification of multiphoton ionization spectra via third harmonic generation in focused laser beams

The modification of multiphoton ionization spectra through third harmonic generation in focused laser beam geometries is reported. A strong enhancement of the ionization peaks corresponding to the decay of thenf' autoionizing series of Kr and the observation of a double resonance in Xe, which is missing in low atomic density spectra, is shown to originate from excitation channels involving absorption of third harmonic photons. This excitation is demonstrated to occur in a significantly extended volume outside the focal region, thus strongly increasing the ionization yield.     

Analysis of autoionizing Rydberg series Cu I 3d 9 4snl with the multichannel quantum defect theory

Using atomic beam technique, a combination of collisional and laser excitation, and photoion detection, autoionizing Cu I states in the region of the ionization limits Cu II 3d ⁹ 4s(^3,1 D) were investigated. In spite of the complicated structure of the signals due to the four different ionization limits³ D ₃,³ D ₂,³ D ₁ and¹ D ₂ and the large number of possible (LSJ)-states, which can be reached by this experimental technique, the majority of the signals could be attributed to definite Rydberg series 3d ⁹ 4s(³ D ₃,³ D ₂,³ D ₁,¹ D ₂)nl (LSJ). Perturbations were analyzed by the three- and four-channel quantum defect theory and by Hartree-Fock calculations. General formulas for the calculation of the photoionization cross section by the four-channel quantum defect theory in the case of two closed and two open channels are given.     

Threshold photoemission spectroscopy in solids

Threshold photoemission spectroscopy (TPES) is used to measure the Fe 2p spectrum of a stainless steel sample. The obtained spectrum is compared with analogous spectra measured by X-ray photoemission and absorption spectroscopies. The results of this comparison suggest that resonant two-electron autoionization processes, rather than direct photoemission from the core level, are the main mechanisms contributing to the signal. Limits and applicability of this experimental approach to investigate bulk electronic properties in solids are discussed.     

Adhesion hysteresis in dynamic atomic force microscopy

The effects of adhesion hysteresis in the dynamic‐dissipation curves measured in amplitude‐modulation atomic force microscopy are discussed. Hysteresis in the interaction forces is shown to modify the dynamics of the cantilever leading to different power dissipation curves in the repulsive and attractive regimes. Experimental results together with numerical simulations show that power dissipation, as measured in force microscopy, is not always proportional to the energy dissipated in the tip–sample interaction process. (© 2008 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Temperature-pressure phase diagram of silicon determined by Clapeyron equation

The temperature-pressure phase diagram [T-P] for silicon (Si) is predicted through the Clapeyron equation where the pressure-dependent volume difference is modeled and the corresponding thermodynamic amount of solid transition enthalpy is calculated by introducing the effect of surface stress induced pressure. The model prediction is found to be consistent with the present experimental results and other theoretical predictions.     

Resonant widths, line intensities and lineshapes for MQDT models with two or more open channels

Approximate analytical formulae describing the energy variation of line intensities, autoionization widths and lineshape asymmetries, are derived for a Phase-Shifted Multichannel Quantum Defect Theory model composed of two closed interacting channels coupled to two effective continua. This is accomplished by putting the two compatibility equation solutions, for the common phase shifts of the two open channels, in such a form so the resonant behavior is attributed to one of them, the other accounting for an energy dependent background. Then, the well-known procedures for the simpler case where only one continuum is considered are applied, using only the resonant solution. The method is quite general and applicable to any MQDT model with two or more open channels. The resulting analytical formulae are tested on experimental spectra of Sr, Ba and Cu and it is shown that they are valid as long as: i) The resonances are non-overlapping, ii) The direct closed channel coupling is much stronger than the indirect one through the continua and (when excitation matrix elements are involved) iii) The open channels excitation strength is smaller or at least comparable to the closed channels one. Received: 26 May 1998 / Accepted: 1st July 1998     

Force spectroscopy of single multidomain biopolymers: A master equation approach

Experiments using atomic force microscopy for unfolding single multidomain biopolymers cover a broad range of time scales from equilibrium to non-equilibrium. A master equation approach allows to identify and treat coherently three dynamical regimes for increasing linear ramp velocity: i) an equilibrium regime, ii) a transient regime where refolding events still occur, and iii) a saw-tooth regime without any refolding events. For each regime, analytical approximations are derived and compared to numerically investigated examples. We analyze in the framework of this model also a periodic experimental protocol instead of a linear ramp. In this case, a major simplification arises if the dynamics can be restricted to an effectively two-dimensional subspace. For transitions with an intermediate meta-stable state, like Immunoglobulin27, a refined model allows to extract previously unknown molecular parameters related to this meta-stable state.     

Studies on CdS nanoparticles dispersed in silica matrix prepared by sol-gel technique

SiO₂/CdS-nanoparticle composite films (SiO₂:CdS=85:15, 80:20, 75:25 and 70:30) were prepared by the sol-gel route. The films were characterized by studying microstructural (XRD and TEM) and optical (transmittance and photoluminescence) properties. Band gaps of these films annealed at different temperatures (373-473 K) for different times (10-120 min) indicated that the signature of nanocrystallinity is retained throughout the range of our experimental conditions. A thermal diffusion process controlled growth in the crystallite size with increasing annealing time and temperature. The average radii of the nanoparticles varied as the cube root of the annealing time but showed exponential dependence on the inverse of annealing temperature. Photoluminescence (PL) studies of the composite films indicated excitonic transitions. Theoretical analysis of the line shapes of the PL peaks recorded at 300 K and 80 K could be accounted for by the combined effects of size distribution and phonon broadening. It was observed that the deformation potential (E _d) effectively controlled the line shapes of the PL measurements. Received 24 May 2002 Published online 27 January 2003 RID="a" ID="a"e-mail: msakp@mahendra.iacs.res.in