航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束，在使用的振动环境中，会因弯曲应力而导致破裂，影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上，得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数，使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．     

Scattering of Laser Light from Mixed Micelles

Dynamic and static scattering of light was employed to investigate mixed micelles of two homologous anionic surfactants-sodium octyl sulfate and sodium hexadecyl sulfate, above the phase boundary temperature and critical micelle concentrations (cmc). The results indicate that the mixed micelles change from prolate to sphcrical as the molar ratio SOS/SHS increases from 1 to 8. Below 1 or above 8, the formation of micelles is due to one surfactant dissolving the other.     

具Hardy-Sobolev临界指数的奇异椭圆方程多解的存在性

运用变分方法研究了下面问题-Δpu=μupx(s)s-2u f(x,u),x∈Ω,u=0,x∈Ω,多重解的存在性,其中Ω是一个具有光滑边界的有界区域.     

Extrusion of pastes with a piston extruder for the determination of the local solid and fluid concentration, the local porosity and saturation and displacement profiles by means of NMR imaging

 Nuclear Magnetic Resonance (NMR) was used to investigate the extrusion behaviour of PTFE pastes in a ram extruder. By means of ¹H-NMR imaging (MRI) it is possible to determine the local proton density and therefore, the local fluid concentration. The ¹⁹F-MRI provides the local solid concentration. Thus the local saturation and the local porosity can be calculated with the information of the local fluid and solid concentration. Furthermore displacement profiles can be derived from NMR images by means of correlation techniques without any preparation or marking of the pastes. Received: 8 May 2000   Accepted: 1 May 2001     

Stress concentration and effective stiffness of aligned fiber reinforced composite with anisotropic constituents

The paper addresses the problem of calculation of the local stress field and effective elastic properties of a unidirectional fiber reinforced composite with anisotropic constituents. For this aim, the representative unit cell approach has been utilized. The micro geometry of the composite is modeled by a periodic structure with a unit cell containing multiple circular fibers. The number of fibers is sufficient to account for the micro structure statistics of composite. A new method based on the multipole expansion technique is developed to obtain the exact series solution for the micro stress field. The method combines the principle of superposition, technique of complex potentials and some new results in the theory of special functions. A proper choice of potentials and new results for their series expansions allow one to reduce the boundary-value problem for the multiple-connected domain to an ordinary, well-posed set of linear algebraic equations. This reduction provides high numerical efficiency of the developed method. Exact expressions for the components of the effective stiffness tensor have been obtained by analytical averaging of the strain and stress fields.     

Dark cure studies of cationic photopolymerizations of epoxides: Characterization of kinetic rate constants at high conversions

The effective propagation rate constant (k_p; averaged over all the propagating active centers) was characterized for solvent‐free cationic photopolymerizations of phenyl glycidyl ether over the entire range of conversions, including the high conversion regime in which mass transfer limitations become important. The profile for the k_p as a function of conversion was found to exhibit a constant plateau value at low to intermediate conversions, followed by a monotonic increase above a threshold value of conversion. To explain this trend, it is proposed that at high conversion the diffusional mobility of the photoinitiator counterion is reduced whereas the mobility of the cationic active center remains high because of reactive diffusion. Therefore, with increasing conversion, the average distance between the active centers and counterions may increase, resulting in an increase in the propagation rate constant. The profiles for the k_p values were investigated as a function of the temperature, photoinitiator anion, and photoinitiator concentration. As the photoinitiator concentration was increased, the plateau value of the effective propagation rate constant decreased whereas the threshold conversion increased. All of the experimental trends are consistent with the proposed increase in ion separation at high conversions. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4409–4416, 2004     

A refined stress-strain analysis in the load transfer zone of flat specimens of high-strength unidirectional composites in uniaxial tension 1. Theoretical analysis

With the use of an analytical approach developed, the influence of distribution of a tangential load on the stress concentration in uniaxially tensioned flat specimens of high-strength unidirectional composites near the grips of a testing machine is evaluated. In view of singularity of the analytical solution derived at the points of discontinuity of boundary conditions, for estimating the stress concentration, it is suggested to employ the averaged value of longitudinal stresses, which is calculated by means of an improper integral across the thickness of a near-surface layer. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 42, No. 6, pp. 787–796, November–December, 2006.     

Quadrupole interactions at 57Fe and 119Sn in 3d-metal antimonides

3d-metal antimonides: Fe_1+x Sb, N_+x Sb, Co_+x Sb and the (Ni_1?y Fe _y )Sb solid solution have been studied by the Mössbauer effect method at ⁵⁷Fe and ¹¹⁹Sn. It was found that the quadrupole interactions at the Fe and Sn nucleus in 3d-metal antimonides are very sensitive to the filling of different crystallographic sites with metal atoms. The metal atoms in trigonal-bipyramidal sites have a strong effect on the quadrupole splitting of ¹¹⁹Sn. They are nearest to anions (Sb or Sn) with the typical axial ratio of c/a = 1.25. The QS(x) dependence of ¹¹⁹ Sn in 3d-metal antimonides in the 0 ≤ x ≤ 0.1 concentration range can be used to determine x – the concentration of transition metal excess relative to the stoichiometric composition.     

High power diode single-end-pumped Nd:YVO4 laser

A fiber-coupled diode-single-end-pumped Nd:YVO₄ laser with an Nd:YVO₄ crystal of 0.3 at% doping concentration and 3×3×10 mm³ dimensions was reported. 14.850 W of continuous-wave output power in an M² factor of 1.12 was obtained under pump power of 27.365 W, with an optical conversion efficiency of 60.49%, and a slope efficiency of 64.5%.     

Sr2RuO4的热电势

Sr2RuO4是第一个无CuO面的层状强关联氧化物超导体.测量了9至260K温度范围内Sr2RuO4的热电势,观测到在此温度范围内其热电势为正值.用两种载流子模型对实验数据进行了拟合,并且与Hall系数的实验结果进行了比较,发现低温下两种载流子对热电势和Hall系数的贡献比较类似,但在高温区空穴对热电势的贡献很大而相应地对Hall系数的贡献不占主要地位. 关键词： Sr2RuO4 热电势