Stability of the FID sensitivity during an analysis in capillary GC

The sensitivity of an FID may change when the carrier gas flow rate changes during a chromatographic run. Sample parts which are eluted at reduced FID sensitivity produce a reduced peak area, hence are discriminated as compared to other components. Sensitivity changes were studied for hydrogen as carrier gas. For the detector tested, differences in the carrier gas flow rates of 1 ml/min shifted the FID sensitivity by 1 to 5% (depending on the fuel gas supply). Thus the stability of the sensitivity is no longer ensured as soon as the carrier gas flow rate is changed manually or by an automatic programmer during an analysis. Sensitivity drifts may also occur during temperature programmed runs with a pressure regulated carrier gas supply since the gas flow through the capillary drops with increasing temperature. Such shifts in the response became noticeable as soon as relatively high carrier gas flow rates combined with long range temperature programmes were used. The typical patterns of such discriminations are shown, closing with a discussion on the possibilities for minimizing such undesired effects.     

Comparison of methods to enhance flame ionization detector (FID) signals in gas chromatography

The performances of some numerical methods to improve the signal to noise ratio are compared and applied to enhance noisy signals obtained in gas chromatography with capillary columns and a flame Ionization detector. Several methods have been considered: cutoffs In the Fourier transform of the recorded signal; real time numerical filtering; theoretical model curve fitting; and the correlation of a chromatogram recorded from a pseudorandomly injected sample with the pseudorandom injection function. Numerical real time filtering is shown to be the most convenient method when the main periodic component of the noise has been determined by Fourier analysis.     

Analysis of polynuclear aromatic hydrocarbons by glass capillary gas chromatography using simultaneous flame ionization and electron capture detection

The possibility of simultaneous application of an electron capture (ECD) and a flame ionization detector (FID) connected to a glass capillary column for analyzing polynuclear aromatic hydrocarbons (PNA) has been investigated. The ECD/FID ratio is determined for 46 PNA compounds. The ratios vary from 0.02 to 117 with relative standard deviations better than 20 percent determined from 10 replicate analyses. The results suggest that the method may be used for obtaining additional evidence in identifying PNA in environmental samples. Impurities and transformation products in the standard were identified by computerized glass capillary gas chromatography/mass spectrometry. Quinones and diones are responsible for the high EC-response determined in some trace components in the standard. An application of the method is shown for PNA from particulates in urban atmospheres.     

Solvent selection in ultrasonic-assisted emulsification microextraction: Comparison between high- and low-density solvents by means of novel type of extraction vessel

There are numerous published reports about dispersive liquid phase microextraction of the wide range of substances, however, till now no broadly accepted systematic and purpose oriented selection of extraction solvent has been proposed. Most works deal with the optimization of available solvents without adequate pre-consideration of properness. In this study, it is tried to compare the performances of low- and high-density solvents at the same conditions by means of novel type of extraction vessel with head and bottom conical shape. Extraction efficiencies of seven basic pharmaceutical compounds using eighteen common organic solvents were studied in this work. It was much easier to work with high-density solvents and they mostly showed better performances. This work shows that although exact predicting the performance of the solvents is multifaceted case but the pre-consideration of initial selection of solvents with attention to the physiochemical properties of the desired analytes is feasible and promising. Finally, the practicality of the method for extraction from urine and plasma samples was investigated.     

Development of a Novel Microwave Distillation Technique for the Isolation of Cannabis sativa L. Essential Oil and Gas Chromatography Analyses for the Comprehensive Characterization of Terpenes and Terpenoids,Including Their Enantio-Distribution

A microwave distillation method was optimized for the extraction and isolation of cannabis essential oil from fresh and dried hemp inflorescences. The developed method enabled us to obtain a distilled product rich in terpenes and terpenoid compounds, responsible of the typical and unique smell of the cannabis plant. The distillate from different hemp cultivars, including Kompolti, Futura 75, Carmagnola, Felina 32 and Finola were characterized by using a gas chromatograph equipped with both mass spectrometer and flame ionization detectors. In a single chromatographic run, the identity and absolute amounts of distilled compounds were determined. Peak assignment was established using a reliable approach based on the usage of two identification parameters, named reverse match, and linear retention index filter. Absolute quantification (mg g⁻¹) of the analytes was performed using an internal standard method applying the flame ionization detector (FID) response factors according to each chemical family. An enantio-GC-MS method was also developed in order to evaluate the enantiomeric distribution of chiral compounds, an analytical approach commonly utilized for establishing the authenticity of suspicious samples.     

Simultaneous derivatization and air-assisted liquid–liquid microextraction of some aliphatic amines in different aqueous samples followed by gas chromatography-flame ionization detection

The paper presents a new method based on simultaneous derivatization and air-assisted liquid–liquid microextraction (AALLME) for the extraction and preconcentration of some aliphatic amines prior to gas chromatography-flame ionization detection (GC-FID). Primary aliphatic amines are derivatized and extracted simultaneously by a fast reaction with butylchloroformate (derivatization agent/extraction solvent) under mild conditions. The mixture of butylchloroformate and aqueous sample solution is rapidly sucked into a 10-mL glass syringe and then is injected into a test tube with conical bottom and the procedure is repeated seven times. After centrifuging the resulted cloudy solution, the derivatized analytes in the sedimented phase are determined by GC-FID. The influence of main factors on the efficiency of derivatization/extraction procedure is studied. Under the optimal conditions, the enrichment factors (EFs) for aliphatic amines are obtained in the range of 248–360 and limits of detection (LODs) are between 0.30 and 2.6 μg L⁻¹. The obtained extraction recoveries ranged from 50 to 72% and the relative standard deviation (RSD) was less than 4.8% for intra-day (n = 6) and inter-days (n = 4) precision. The method is successfully applied to determine some aliphatic amines in environmental water samples.     

Methods for correlating T1rho and FID components in wideline 1H NMR studies of motionally heterogeneous polymer systems

We address the problem of correlating the observed FID and T_1ρ components in wideline ¹H relaxation measurements of motionally heterogeneous polymers, and show that different methods of data treatment can highlight different aspects of the correlations present. For a sample of polypropylene we find that the T_1ρ relaxation behaviour is driven by relaxation associated with the intermediate FID component, which strongly suggests a motionally inhomogeneous amorphous region in the sample.     

固相萃取-气相色谱法测定甲醇制烯烃副产汽油及甲醇制汽油产物中的含氧化合物

采用纯硅胶柱固相萃取技术对甲醇制烯烃副产汽油或甲醇制汽油产物进行预处理,将产物中的含氧化合物与烃类进行色谱分离,采用质谱鉴定产物中的含氧化合物。使用标准溶液优化纯硅胶小柱的洗脱条件,比较预处理方法的回收率,考察预处理方法的重复性。结果表明,标准溶液的各含氧化合物组分回收率为87.7%~95.3%。采用气相色谱-火焰离子化检测器(GC-FID)通过内标法对实际样品中除甲醇和乙醇外的含氧化合物进行定量分析,使用丁酮、叔戊醇、戊酮和己酮的响应因子作为同碳数醛、酮、醇的FID响应因子,定量甲醇制烯烃副产汽油和甲醇制汽油产物中的含氧化合物。对于甲醇和乙醇,采用GC-MS分析提取特征离子用外标法定量。结果表明,甲醇制烯烃副产汽油和甲醇制汽油产物中的含氧化合物以酮类、醛类为主,并有少量的醇类。     

Experimental validation of an effective carbon number-based approach for the gas chromatography–mass spectrometry quantification of ‘compounds lacking authentic standards or surrogates’

For the quantitative analysis of ‘compounds lacking authentic standards or surrogates’ (CLASS) in environmental media, we previously introduced an effective carbon number (ECN) approach to develop an empirical equation for the prediction of their response factor (RF). In this research, a series of laboratory experiments were carried out to benchmark the reliability of an ECN approach for sorbent tube/thermal desorption/gas chromatography (GC)/mass spectrometry (MS) applications. First, the ECN values were determined using external calibration data from 25 reference volatile organic compounds (VOCs) using two MS dectectors (quadrupole (Q) and time-of-flight (TOF)). Then, a certified standard mixture of 54 VOCs was analyzed by each system as a simulated unknown sample. The analytical bias, assessed in terms of percentage difference (PD) between the certified and ECN-predicted mass values, averaged 19.2 ± 16.1% (TOF-MS) and 28.2 ± 27.6% (Q-MS). The bias using a more simplified carbon number (CN)-based prediction increased considerably, yielding 53.4 ± 53.3% (TOF-MS) and 61.7 ± 81.3% (Q-MS). However, the bias obtained using the ECN-based prediction decreased significantly to yield average PD values of 9.84 ± 7.28% (TOF-MS) and 16.8 ± 8.35% (Q-MS), if the comparison was limited to 26 (out of 54) VOCs with CN ≥ 4 (i.e., 25 aromatics and hexachlorobutadiene).