Three-dimensional visualization of columnar vortices in rotating Rayleigh–Bénard convection

Journal of Visualization -  To enrich the three-dimensional experimental details of vortex structures in rotating Rayleigh–Bénard convection, we established a technique...     

Liquid crystalline properties of dissymmetric molecules IV. The substituent effect on thermal properties of nematic and smectic A phases in three aromatic ring systems with ester linkages

This paper describes the effect of substituent and ester linkage on smectic properties for some derivatives of 4-R -phenyl 4-(4-octyloxybenzoyloxy)benzoates (1), 4-octyloxyphenyl 4-(4-R-benzyloxy)benzoates (2), 4-(4-octyloxybenzoyloxy)phenyl 4- R -benzoates (3), and 4-R-phenyl 4-octyloxyphenyl terephthalates (4) where R = OCH₃, CH₃, OC₈H₁₇, C8H17, halogens, CF₃, OCF₃, CN, NO2, etc. The thermal properties are discussed in terms of the electrostatic nature of the substituents and the relative orientation of the ester groups with respect to both terminal substituents. The substituent effect on the layer structure of the smectic A phase is also examined by means of a small angle X-ray analysis.     

Results of 0.5% cold-leg small-break LOCA experiments at ROSA-IV/LSTF: Effect of break orientation

Three 0.5% cold-leg small-break loss-of-coolant accident (SBLOCA) experiment were conducted at the ROSA-IV Large Scale Test Facility (LSTF) to investigate the effects of break orientation on system thermal-hydraulic responses. In these three experiments, the break hole was located at the side, bottom, and top of the horizontal cold leg, respectively. Although the key phenomena observed in the three experiments were basically the same, the break flow rate was affected by the break orientation when phase stratification occured in the cold leg; the break flow rate was largest for the side break and smallest for the top break. The RELAP5/MOD2 code failed to predict the difference in the break flow rate observed in the experiments. Modification to the break flow calculation models, for both subcooled and two-phase flow discharge conditions, resulted in good agreement between data and predictions.     

Plasma polymerization of cyano compounds

Plasma polymerizations of three cyano compounds—acrylonitrile (AN), 1,2-dicyanoethylene (FN), and tetracyanoethylene (TCE)—were investigated by FT IR and XPS, and the transforamtion of cyano groups during the plasma polymerization was discussed. The results pointed out an aspect of the preparation of plasma films with cyano groups. Plasma polymerizations of AN, FN, and TCE deposited brown or dark brown films that contained carbon, nitrogen, and oxygen. The elemental composition of the plasma films, especially N/C atomic ratio, showed a monomer dependence but no rf power dependence. The plasma films contained amide and amino groups, and ketene-imine and conjugated — C = N — structures as well as cyano groups as nitrogen functionalities, and carbonyl and carboxyl groups as oxygen functionalities. For the preparation of plasma films with cyano groups, compounds with more than two cyano groups themselves are not suitable as monomers. The operation of plasma polymerization under mild plasma conditions at low rf power and in no oxygen atmosphere is favorable for the preparation of plasma films with cyano groups. © 1992 John Wiley & Sons, Inc.     

Effect of annealing on structure and permeability of poly [(l-trimethylsilyl)-l-propyne]

The permeability of annealed poly (l-(trimethylsilyl)-l-propyne) was studied from the viewpoint of structural information obtained from x-ray diffraction and density. The sample cast from benzene solution had low density (0.82 g/cm³) and high permeability, whereas the annealed sample had a higher density (0.88 g/cm³) and permeability lower by two orders of magnitude. The smaller-angle x-ray diffraction peak for each sample, which was likely to reflect the distance between intermolecular chains, increased in intensity and shifted toward higher angle, corresponding to the change of the density with annealing. The logarithmic oxygen permeability was proportional to the density, namely the free volume fraction correlated with the diffusion coefficient and controlled by annealing and swelling by alcohols.     

Detection of 8-hydroxy-2'-deoxyguanosine in deoxyribonucleic acid by the 32P-postlabeling method.

Using synthesized 8-hydroxy-2'-deoxyguanosine 3'-monophosphate as a marker, the 32P-postlabeling method was adapted with minimum modifications for the analysis of 8-hydroxy-2'-deoxyguanosine (8-OH-dG) content in deoxyribonucleic acid (DNA). This method allows the analysis of one 8-OH-dG per 10(4) DNA nucleotides with only 10 pmoles of nucleotides required. The amounts of 8-OH-dG in DNA detected by the postlabeling method correlated well with the electrochemical detection method but were consistently lower.     

Formation of polymeric micelles with amino surfaces from amphiphilic AB‐type diblock copolymers composed of poly(glycolic acid lysine) segments and polylactide segments

Amphiphilic AB‐type diblock copolymers composed of hydrophobic poly(L ‐lactide) (PLA) segments and hydrophilic poly(glycolic acid lysine) [poly(Glc‐Lys)] segments with amino side‐chain groups self‐associated to form PLA‐based polymeric micelles with amino surfaces in an aqueous solution. The average diameter of the loose core–shell polymeric micelles for poly(Glc‐Lys) [number‐average molecular weight (M_n) = 1240]‐b‐PLA (M_n = 7000) obtained by a dimethyl sulfoxide/water dialysis method was estimated to be about 50 nm in water by dynamic light scattering measurements. The size and shape of the obtained polymeric micelles were further observed with transmission electron microscopy and atomic force microscopy. To investigate the possibility of applying the obtained PLA‐based polymeric micelles as bioabsorbable vehicles for hydrophobic drugs, we tested the entrapment of drugs in poly(Glc‐Lys) (M_n = 1240)‐b‐PLA (M_n = 7000) micelles and their release with doxorubicin as a hydrophobic drug. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1426–1432, 2002     

Concentration dependence of electroosmosis and streaming potential across charged membranes

Electroosmosis and streaming potential measurements were carried out across charged membranes made of collodion and sulfonated polystyrene. Experiments were confined to the range where linear flux/force relationships hold. Saxén's relationship holds between electroosmosis and streaming potential; for porous charged membranes these exhibit an approximate inverse proportionality to ionic mobility at the limit of low electrolyte concentration. Both tend towards zero at the limit of high electrolyte concentration.