A polymer surface for antibody detection by using surface plasmon resonance via immobilized antigen

A polymer substrate based surface plasmon resonance (SPR) technique was developed for detection of specific monoclonal antibody 10B2 (MAb 10B2) against bacterium Acidovorax avenae subsp. citrulli (Aac). The monolayer of Aac antigen was physically immobilized on 95:5 polystryrene – copoly acrylic acid (95PSMA) for detection of antibody. The amount of antigen–antibody binding was found to depend on the surface density of immobilized Aac on the sensor surface and the antibody concentration. The detection limit was 5 μg/ml which was lower than the required concentration during the normal production of the antibody at 10–100 μg/ml. This suggests a possible use of surface for the antibody screening. Moreover, an application in antibody screening was explored by combination of surface plasmon resonance imaging (SPR imaging) and antibody detection assay on the 95PSMA surface. Two antigens of bovine serum albumin (BSA) and Aac were used as a model system for antibody screening. The result shows that both antibodies can be distinguished using the immobilized antigens on the 95PSMA surface based SPR imaging technique.     

Adsorption of bovine serum albumin (BSA) on polystyrene (PS) and its acid copolymer

The effect of surface polarity on the adsorption of bovine serum albumin (BSA) on polystyrene (PS), 7% polystyrene-co-maleic anhydride (7%PSMAn) and 50% polystyrene-co-maleic acid (50%PSMA), at pH 7.4, was investigated. Polystyrene represented the non-polar surface while 7%PSMAn and 50%PSMA represented a low and high acid content copolymer. The amount of the adsorbed BSA depended on the amount of the acid content in the copolymer. BSA formed a monolayer with a side-on orientation on the low polarity PS surface, a mixed side-on and end-on orientation on 7%PSMAn and a predominantly side-on orientation on 50%PSMA. The thickness of adsorbed BSA, measured with an atomic force microscope (AFM), varied from 3 nm to 5 nm for the side-on orientation and from 10 nm to 15 nm for the end-on orientation. The average area occupied per BSA molecule was consistent with the proposed orientation, and was 34.8 nm², 27.8 nm² and 18.0 nm² for PS, 7%PSMAn and 50%PSMA, respectively. The adsorption showed a concentration dependency following the Freundlich isotherm, which indicated the interactions among adsorbed BSA molecules on the polymer surface. The adsorption took place as an island-like morphology and started to fuse into a patch-like morphology at higher concentrations before achieving a complete monolayer formation. A non-uniform surface coverage and defects were observed in all cases. It is recommended that for an effective blocking of PS, 7%PSMAn and 50%PSMA, the BSA concentration should be higher than 3 mg/mL.