Multiparameter Polynomial Adaptive Stabilizers

In 1983 Morse proved, for unknown scalar one-dimensional linearsystems, the nonexistence of rational or polynomial universalstabilizers (UAS). In 1983, Nussbaum gave an example of an analyticUAS. In our paper, it is shown that there exist time-invariantpolynomial UAS's with multidimensional gain adaptation. Thedesign procedure is developed for linear, minimum-phase systemsof relative degree one. Convergence of the closed-loop systemis proved. Some numerical simulations are provided.     

Total synthesis of d-(+)-biotin

A total synthesis of d-(+)-biotin is described starting from d-(+)-glucosamine using acyliminium chemistry.     

Asymmetric synthesis of pedamide using I_2-induced heterocyclization to construct the skeleton

An alternative approach to synthesize pedamide,a key building block of pederin was described.Iodine-induced asymmetric heterocyclization was used as the key step to construct the skeleton,a tetrahydropyran ring with three chiral centers.Brown's asymmetric allylation and Lewis acid-mediated allylation were investigated to introduce chains and chiral alcohols.Sharpless dihydroxylation decorated the side chain.And high optically pure target was obtained by removing the epimers formed in these reactions on c...     

Microwave-assisted one-pot synthesis of 3-substituted-3,4-dihydrocoumarins via tendem Konevenagel and Hantzsch reactions

A convenient route for the synthesis of 3,4-dihydrocoumarin derivates from salicylaldehyde derivates and 1,3-dicarbonyl compounds under solvent-free microwave irradiation conditions was described. In this way, a range of compounds was obtained in moderate to good yields in a short reaction time.     

In situ measurement of biaxial modulus of Si anode for Li-ion batteries

We report in situ measurement of biaxial moduli of a Si thin-film electrode as a function of its lithium concentration. During lithiation, biaxial compressive stress is induced in the Si film and it undergoes plastic flow. At any state-of-charge (SOC), a relatively small delithiation–relithiation sequence unloads and reloads the film elastically. From the stress and strain changes during a delithiation–relithiation cycle, the biaxial modulus of the film is calculated. Stress change is obtained by measuring the change in substrate curvature using a Multi-beam Optical Sensor; the elastic strain change is obtained from the change in SOC. By repeating these measurements at several different values of SOC, the biaxial modulus was seen to decrease from ca. 70 GPa for Li_0.32Si to ca. 35 GPa for Li_3.0Si. Such a significant reduction in elastic modulus has important implications for modeling stress evolution and mechanical degradation in Si-based anodes.     

Real-time measurement of stress and damage evolution during initial lithiation of crystalline silicon

Crystalline to amorphous phase transformation during initial lithiation in (100) Si wafers is studied in an electrochemical cell with Li metal as the counter and reference electrode. During initial lithiation, a moving phase boundary advances into the wafer starting from the surface facing the lithium electrode, transforming crystalline Si into amorphous Li(x)Si. The resulting biaxial compressive stress in the amorphous layer is measured in situ, and it was observed to be ca. 0.5 GPa. High-resolution TEM images reveal a very sharp crystalline-amorphous phase boundary, with a thickness of ～1 nm. Upon delithiation, the stress rapidly reverses and becomes tensile, and the amorphous layer begins to deform plastically at around 0.5 GPa. With continued delithiation, the yield stress increases in magnitude, culminating in a sudden fracture of the amorphous layer into microfragments, and the cracks extend into the underlying crystalline Si.     

Self-injection length in La0.7Ca0.3MnO3-YBa2Cu3O7-δ ferromagnet-superconductor multilayer thin films

We have carried out extensive studies on the self-injection problem in barrierless heterojunctions between La_0.7Ca_0.3MnO₃ (LCMO) and YBa₂Cu₃O_7-δ (YBCO) thin films. The heterojunctions were formed in situ by sequentially growing LCMO and YBCO films on 〈100〉 LaAlO₃ (LAO) substrate using a pulsed laser deposition (PLD) system. YBCO micro-bridges with 64 μm width were patterned both on the LAO (control) and LCMO side of the substrate. Critical current, I _c, was measured at 77 K on both the control side as well as the LCMO side for different YBCO film thickness. It was observed that while the control side showed a J _c of ∼ 2 × 10⁶ A/cm², the LCMO side showed about half the value for the same thickness (1800 ?). The difference in J _c indicates that a certain thickness of YBCO has become ‘effectively’ normal due to self-injection. From the measurement of J _c at two different thicknesses (1800 ? and 1500 ?) of YBCO films both on the LAO as well as the LCMO side, the value of self-injection length (at 77 K) was estimated to be ∼ 900 ?. To the authors’ best knowledge, this is the first time that self-injection length has been quantified. A control experiment carried out with LaNiO₃ deposited by PLD on YBCO did not show any evidence of self-injection.     

六元gcd封闭集上Smith矩阵的整除性

我们给出了关于六元gcd封闭集S的充分必要条件,使得在整数矩阵环M_6(Z)中,定义在S上的e次幂GCD矩阵(S~e)整除e次幂LCM矩阵[S~e].这部分解决了Hong在2002年提出的一个公开问题.     

Total synthesis of the originally proposed and revised structures of palmerolide A and isomers thereof

Palmerolide A is a recently disclosed marine natural product possessing striking biological properties, including potent and selective activity against the melanoma cancer cell line UACC-62. The total syntheses of five palmerolide A stereoisomers, including the originally proposed (1) and the revised [ent-(19-epi-20-epi-1)] structures, have been accomplished. The highly convergent and flexible strategy developed for these syntheses involved the construction of key building blocks 2, 19-epi-2, 20-epi-2, ent-2, 3, ent-3, 4, and ent-4, and their assembly and elaboration to the target compounds. For the union of the building blocks, the Stille coupling reaction, Yamaguchi esterification, Horner-Wadsworth-Emmons olefination, and ring-closing metathesis reaction were employed, the latter being crucial for the stereoselective formation of the macrocycle of the palmerolide structure. The Horner-Wadsworth-Emmons olefination and the Yamaguchi lactonization were also investigated and found successful as a means to construct the palmerolide macrocycle. The syntheses were completed by attachment of the enamide moiety through a copper-catalyzed coupling process.     

Highly effective direct synthesis of DMC from CH_3OH and CO_2 using novel Cu-Ni/C bimetallic composite catalysts

Novel Cu-Ni/C has been prepared and utilized as an efficient catalyst system in direct synthesis of DMC from CH3OH and CO2.