Usage of deep eutectic solvents for the digestion and ultrasound-assisted liquid phase microextraction of copper in liver samples

In this study, we used deep eutectic solvents for digestion and ultrasound-assisted emulsification liquid phase microextraction (UA-ELPME) of copper in liver samples. Different types of DESs were prepared for digestion and microextraction steps. DESs consisting of lactic acid and choline chloride for the digestion step and DESs consisting of tetrabuthylamonium chloride and decanoic acid for ultrasound-assisted emulsification liquid phase microextraction were used in this method. The liver samples were digested by using DES-based digestion method. After digestion step, Cu(II) ions in aqueous phase were complexed with sodium dimethyl dithiocarbamate (NaDMDTC) and the obtained hydrophobic complex was extracted to tetrabuthylamonium chloride-decanoic acid DES phase. A microsample injection system coupled with flame atomic absorption spectrometer (MS-FAAS) was used in the detection of copper. LOD, LOQ, PF and % RSD were determined as 4.00, 13.2 µg L^??1, 10 and 3.2%, respectively. The proposed microextraction procedure was successfully applied to copper contents of the liver samples.     

Chemical profile by LC–MS/MS,GC/MS and antioxidant activities of the essential oils and crude extracts of two Euphorbia species

In this study, it was aimed to investigate the chemical composition and antioxidant activities of two Euphorbia species. The major component of the fatty acid compositions obtained from the petroleum ether extracts was identified as palmitic acid for Euphorbia gaillardotii and Euphorbia macroclada. The main constituents of the essential oils were identified as arachidic acid for E. gaillardotii and tetratetracontane for E. macroclada. Among the 27 studied compounds, hesperidin, rutin, hyperoside and quinic, malic, gallic and tannic acids were found to be the most abundant compounds in the two Euphorbia species. The methanol extracts of E. gaillardotii and E. macroclada showed strong antioxidant activity in all tested methods. Particularly, IC₅₀ values of E. macroclada methanol extract that was the richest in terms of total phenolic-flavonoid contents were found to be lower than α-tocopherol and butylated hydroxytoluene in β-carotene bleaching, 2,2-diphenyl-1-picrylhydrazyl free and ABTS cation radical scavenging methods.     

Switchable solvent based liquid phase microextraction of palladium coupled with determination by flame atomic absorption spectrometry

A switchable solvent-based micro-extraction method for pre-concentration and separation of ultratrace palladium was developed prior to its flame atomic absorption spectrometric detection. Reverse change of hydrophilicity of N,N-dimethylcyclohexylamine (DMA) was achieved by reaction with carbonated water. The hydrophilic bicarbonate salt of the protonated DMA was used as extractant for palladium complexed with 2-(5-bromo-2-pyridylazo)-5-diethylaminophenol (5-Br-PADAP). Formation of the hydrophobic form of switchable solvent from hydrophilic form of switchable solvent phase was achieved by addition of sodium hydroxide into the extractant-sample solution. The effect of key parameters affected extraction recovery was studied and optimised by using Plackett–Burman design, central composite design and three dimension (3D) surfaces response. The calibration plot was linear in the range 0.015–1.6 mg L^?1 of palladium with a correlation coefficient of 0.999. The limit of detections values of palladium for liquid and solid samples were 4.28 μg L^?1 and 0.54 µg g^?1, respectively. The pre-concentration factor was 37.5. The accuracy was confirmed by determination of palladium in certified reference material. The procedure was also applied for determination of palladium content of real samples as automotive catalytic converter, roadside dust, sea water and river water.     

Copper(II) complexes with pyridine-2,6-dicarboxylic acid from the oxidation of copper(I) iodide

Via an oxidation reaction of Cu(I) iodide with pyridine-2,6-dicarboxylic acid (H₂L) in DMF three copper(II) complexes, [(CH₃)₂NH₂]₂[CuL₂] (1), K₂[CuL₂]?H₂L?H₂O (2) and [Cu(L)(H₂O)]_n (3), were synthesized and characterized. The structures of 1–3 were determined by single crystal X-ray diffraction studies. In-situ DMF decomposition produces dimethylamine base under solvothermal conditions and a proton transfer reaction takes place for the complex formation of 1. 3-D networks are stabilized in 1 and 2 via hydrogen bonds. Complex 3 is a 1-D coordination polymer with Cu-O semi-coordination bonds. Thermal decomposition of the complexes results in the corresponding metal oxides. Also, the electrochemical behavior of 1 was determined to be a metal-centered and diffusion-controlled, one-electron reduction process.     

Effects of timber skidding on chemical characteristics of herbaceous cover, forest floor and topsoil on skidroad in an oak (Quercus petrea L.) forest

This paper examines the effects of timber harvesting by skidding on some soil properties (sand, silt, clay, pH, organic carbon, bulk density and compaction), herbaceous cover (unit mass) and forest floor (unit weight) properties. Also N (%), P, K, Na, Ca, Mg, Fe, Zn, Cu and Mn (ppm) were determined in all herbaceous cover, forest floor and two soil depth (0–5 cm and 5–10 cm) on skidroad of an oak (Quercus petrea L.) stand in Istanbul Belgrad Forest – Turkey. In this study, obtained results are; the forest floor and the herbaceous cover amount on the skidroad have been found considerably lower than undisturbed area. There were some crucial changes in the characteristics of the soil which has been investigated down to 10 cm depth. Soil bulk density was found quite high in the samples taken from the skidroad subject to compaction compared to the ones on the undisturbed area. Nevertheless, no important difference had been detected between the skidroad and the undisturbed area at both soil depths in terms of organic carbon contents. Moreover, the soil acidity (pH) values showed noteworthy differences in the analysis of soil samples taken from both soil depths on the skidroad and on the undisturbed area. Fe and Cu contents of herbaceous samples on skidroad were significantly higher than undisturbed area. Forest floor on skidroad had significantly higher K content, and significantly lower Zn, Mn and N content compared to undisturbed area. P, Fe, Zn and Mn contents were found significantly lower in 0–5 cm soil depth on skidroad than undisturbed area. In 5–10 cm soil depth, concentrations of N, P, Fe, Zn and Mn were significantly lower, while Mg and Cu contents were significantly higher than undisturbed area. Results indicate that long-term harvest using skidding techniques on these sites had adversely affected soil cation concentrations, physical soil conditions and mass of herbaceous cover and forest floor.     

Synthesis,Characterization and Electrorheological Properties of Polyindene/Kaolinite Composites

In this study, synthesis, characterization and electrorheological (ER) properties of polyindene (PIN) and polyindene/kaolinite composites were carried out by cationic radical polymerization using FeCl₃ as the oxidizing agent. The homopolymer and composites, containing different amounts of PIN were characterized by FTIR spectroscopy, thermo‐gravimetric (TGA) analyses, scanning electron microscopy (SEM) and dynamic light scattering (DLS) methods. The conductivity and dielectric properties of PIN and PIN/kaolinite composites were determined. Suspensions of PIN and PIN/kaolinite composites were prepared in silicone oil (SO), at a series of concentrations (c=5–25 m/m %). The effects of concentration, shear rate, electric field strength, frequency, temperature and promoter on ER activities of suspensions were investigated.     

Synthesis of a Calix[4]crown‐6 Cone Conformer‐Based Oligomer and its Metal Cation Extraction Abilities

A new calixcrown‐6 oligomer 5 was synthesized by reacting a 1,3‐distal di‐amino derivative of cone p‐tert‐butylcalix[4]crown‐6 with malonyl dichloride. Extraction studies with precursor monomers 2 and 3 and oligomer 5 showed differences in their metal cation extraction behavior and selectivity. Precursors monomers 2 and 3 were selective for Hg²⁺; whereas, oligomer 5 showed high affinity towards both alkali (Li⁺, Na⁺, K⁺, and Cs⁺) and heavy metal cations (Cu²⁺, Cd²⁺, Hg²⁺ and Pb²⁺).     

Synthesis and Liquid Crystalline Behavior of Random Copolymer of Poly(ethylene oxide) Macromonomer and Liquid Crystalline Monomer by the Photon Transmission Technique

Random copolymers of poly(ethylene oxide) macromonomer with p‐vinylbenzyl end‐functional group (PEOVB) and liquid crystalline monomer, namely 6‐(4‐cyanobiphenyl‐4′‐oxy)hexyl acrylate (COA), were prepared by conventional free radical polymerization. A living anionic polymerization technique was employed for the synthesis of PEO macromonomers bearing p‐vinylbenzyl moiety at one end. The photon transmission method was also applied to study the phase transitions of COA monomer and its random copolymer with PEO. It was found that, for both samples, the nematic‐smectic A transition is continuous, but the critical fluctuation regions do not allow to obtain 3D XY values. Instead, we have obtained the values close to mean field regime. Scaling of thermal hystersis for random copolymer sample near the nematic‐isotropic transition was studied as well. Thermal hysteresis loops were produced under linearly varying temperature. It was shown that the areas of the hysteresis loops scale with the temperature scanning rate with an exponent being equal to 0.614 which is in good agreement with the field‐theoretical value.