微波法制备CaMoO4:Tb3+,Eu3+白色荧光粉及其发光性能研究

通过微波法制备了CaMoO4:Tb3+,Eu3+白色荧光粉.采用X射线粉末衍射仪、扫描电子显微镜和荧光光谱仪对样品材料的结构、形貌和发光性能进行了表征.分别讨论了在不同助剂、不同反应浓度、不同反应温度及稀土离子Eu3+和Tb3+共掺比例变化对荧光粉的发光性能的影响.结果表明:不加活性剂所得CaMoO4:Tb3+,Eu3+样品在反应浓度为0.06 mol/L、反应温度为120℃时发光性能最好;通过调节CaMoO4:Tb3+,Eu3+荧光粉中稀土离子Eu3+和Tb3+共掺比例荧光粉的发光颜色可以很容易地从冷白光变为暖白光.     

Advanced Li-Ion Batteries with High Rate,Stability, and Mass Loading Based on Graphene Ribbon Hybrid Networks

To optimize the cycle life and rate performance of lithium-ion batteries (LIBs), ultra-fine Fe₂O₃ nanowires with a diameter of approximately 2 nm uniformly anchored on a cross-linked graphene ribbon network are fabricated. The unique three-dimensional structure can effectively improve the electrical conductivity and facilitate ion diffusion, especially cross-plane diffusion. Moreover, Fe₂O₃ nanowires on graphene ribbons (Fe₂O₃/GR) are easily accessible for lithium ions compared with the traditional graphene sheets (Fe₂O₃/GS). In addition, the well-developed elastic network can not only undergo the drastic volume expansion during repetitive cycling, but also protect the bulk electrode from further pulverization. As a result, the Fe₂O₃/GR hybrid exhibits high rate and long cycle life Li storage performance (632 mAh g⁻¹ at 5 A g⁻¹, and 471 mAh g⁻¹ capacity maintained even after 3000 cycles). Especially at high mass loading (≈4 mg cm⁻²), the Fe₂O₃/GR can still deliver higher reversible capacity (223 mAh g⁻¹ even at 2 A g⁻¹) compared with the Fe₂O₃/GS (37 mAh g⁻¹) for LIBs.     

基于CARS技术的超燃冲压发动机点火过程温度测量

相干anti-Stokes Raman散射（coherent anti-Stokes Raman scattering，CARS）技术作为一种非接触测量手段，已广泛应用于多种发动机模型燃烧室温度测量及地面试验.然而，目前的工作主要集中在稳态燃烧场温度的测量，缺乏用高分辨率的单脉冲来测量瞬变的燃烧火焰温度及组分浓度的研究.基于CARS理论，结合多参数拟合算法，开发了基于MATLAB的CARS光谱计算和拟合程序CARSCF；利用McKenna平面火焰炉在不同工况下进行了温度测量，并与DLR测量结果进行对比，结果显示开发的CARSCF具有较高的测量重复性和准确性；最后将CARS技术应用于测量超燃冲压发动机点火过程中的温度测量，获取了点火过程中的温度.结果显示，在来流Mach数为3的条件下，H₂/air点火过程中温度呈现急剧上升然后缓慢下降，而CARS信号则呈现急剧上升然后急剧下降随后又缓慢上升的趋势，并且在点火过程中最高温度为1 511 K.      

静止轨道高光谱海洋水色仪光学系统设计

设计了由超大口径前置望远系统和超大视场光谱仪组成的超大口径高光谱海洋水色仪.前置望远系统采用同轴三反光学系统结构,口径为4 m,视场为0.64°,焦距为21.6 m,波段范围为400~1 000nm.超大视场光谱仪采用改进的Offner结构,视场为240mm,光谱分辨率为10nm.探测器像元尺寸为15μm×15μm,4片探测器交错拼接实现400km幅宽.超大视场光谱仪在400~1 000nm的宽波段内,点列图半径的均方根值均小于3.9μm,静止轨道高光谱海洋水色仪全系统不同波长的MTF在33.3lp/mm处大于0.52,各项指标均满足应用要求.     

高质量氧化镓单晶及肖特基二极管的制备

本文采用导模法生长技术,成功制备了高质量掺Si氧化镓(β-Ga₂O₃)单晶,掺杂浓度为2×10¹⁸ cm^-3.晶体呈现淡蓝色,通过劳厄衍射、阴极荧光(CL)及拉曼测试对晶体的基本性质进行了表征,结果表明晶体质量良好.紫外透过光谱证明该晶体的禁带宽度约为4.71 eV.此外,在剥离衬底上,采用电子束蒸发、光刻和显影技术制备了垂直结构的肖特基二极管,平均击穿场强EAva为2.1 MV/cm,导通电阻3 mΩ·cm²,展示了优异性能.     

A post curing strategy toward the feasible covalent adaptable networks in polyacrylate latex films

The implementation of covalent adaptable networks (CANs) in general resin system is becoming attractive. In this work, we propose a simple post-curing strategy based on the core-shell structured acrylate latex for the achievement on both the improved general performance and the CANs characteristics in latex films. The building to the CANs was relied on the introduction of 4,4′-diaminophenyl disulfide as the curing agent, which cured the acetoacetoxy decorated shell polymer through the ketoamine reaction. The metathesis reaction of aromatic disulfides in the crosslinking segments enabled the thermally induced dynamic behavior of the network as revealed in the stress relaxation tests by comparison with other diamine crosslinking agents without the incorporation of disulfide. The synergism of the dynamic crosslinking of the shell polymer and static crosslinking in the core polymer contributed to the improved mechanical strength (15 MPa, strain% = 250%) and the suppressed water adsorption (~1% in 24 h of soaking) of the latex film, which exhibited above 90% of recovery in both strength and strain from a cut-off film damage within 1 h at 80°C. Moreover, the cured latex film could be recycled, and 75% of the mechanical performance was regained after three fragmentation-hot-pressing cycles. These, in addition with the feasible and environmental friendly characteristics, suggest a sustainable paradigm toward the smart thermosetting latex polymers.     

CONTINUOUS DEPENDENCE ON DATA UNDER THE LIPSCHITZ METRIC FOR THE ROTATION-CAMASSA-HOLM EQUATION

In this article,we consider the Lipschitz metric of conservative weak solutions for the rotation-Camassa-Holm equation.Based on defining a Finsler-type norm on the tangent space for solutions,we first establish the Lipschitz metric for smooth solutions,then by proving the generic regularity result,we extend this metric to general weak solutions.     

酸溶-电感耦合等离子体发射光谱法测定白云石和菱镁石中主次元素

利用电感耦合等离子体原子发射光谱仪( ICP-AES)建立白云石和菱镁石中铝、钙、铁、镁、锰、磷、硅、锶的测定方法。研究了酸体系、温度及消解方式对试样消解的影响,结果表明,使用5 mL盐酸和硝酸混合酸(1：3)-0.75 mL氢氟酸-5 mL水以密闭消解的方式在150 ℃下消解白云石和菱镁石30min,并以2mL饱和硼酸络合多余的氢氟酸,可以得到澄清消解液。通过白云石和菱镁石中铝、钙、铁、镁、锰、磷、硅、锶的谱线干扰情况,选择Al 308.215 nm、Ca 318.127 nm、Fe 261.187 nm、Mg 277.983 nm、Mn 257.61 nm、P 213.618 nm、Si 251.611 nm、Sr 421.552 nm作为分析线,各元素的校准曲线在线性范围内线性关系良好,相关系数均不小于0.999。按照实验方法测定白云石和菱镁石标准物质,各元素结果的相对标准偏差 (RSD, n=6)为0.89~3.19%,测定值与认定值无显著性差异。本方法有效解决了白云石和菱镁石快速有效溶解及准确测定问题。     

二环己基-18冠-6加速锶离子在微米管支撑的水/1,2-二氯乙烷界面上的转移反应

采用玻璃微米管支撑的液/液界面通过循环伏安法(CV)研究了二环己基-18冠6(DCH18C6)加速Sr2+在水/1,2-二氯乙烷(W/DCE)界面上的转移反应,考察了DCH18C6加速Sr2+在W/DCE界面转移的影响因素,如DCH18C6和Sr2+浓度等,并求算其络合物的稳定常数。实验结果表明,Sr2+与DCH18C6发生的是一个1:1的扩散控制的界面络合转移过程,其络合常数β为5.31×1023。本研究可为理解溶剂萃取Sr2+行为提供基础理论数据。