以磷化铁为添加剂沿(111)面生长磷掺杂金刚石大单晶

掺杂是调控金刚石性能的一种重要手段。本文采用温度梯度法,在5.6 GPa、1 312 ℃的条件下,选用Fe₃P作为磷源进行磷掺杂金刚石大单晶的合成。金刚石样品的显微光学照片表明,随着Fe₃P添加比例的增加,金刚石晶体的颜色逐渐变深,包裹体数量逐渐增加,晶形由板状转变为塔状直至骸晶。金刚石晶形的变化表明Fe₃P的添加使生长金刚石的V形区向右偏移,这是Fe₃P改变触媒特性的缘故。红外光谱分析表明,Fe₃P的添加使金刚石晶体中氮含量上升,这说明磷的进入诱使氮原子更容易进入金刚石晶格中。激光拉曼光谱测试表明,随着Fe₃P添加比例的增加,所合成的掺磷金刚石的拉曼峰位变化不大,其半峰全宽(FWHM)值变大,这说明磷的进入使得金刚石晶格畸变增加。XPS测试结果显示,随着Fe₃P添加比例的增加,金刚石晶体中磷相对碳的原子百分含量也会增加,这意味着添加Fe₃P所合成的金刚石晶体中有磷存在。     

Synthesis of flower-like WS2 by chemical vapor deposition

Flower-like tungsten disulfide (WS₂) with a diameter of 5-10 μm is prepared by chemical vapor deposition (CVD). Scanning electron microscopy (SEM), energy dispersive spectrometer (EDS), Raman spectroscopy, and ultraviolet-visible (UV-vis) spectroscopy are used to characterize its morphological and optical properties, and its growth mechanism is discussed. The key factors for the formation of flower-like WS₂ are determined. Firstly, the cooling process causes the generation of nucleation dislocations, and then the "leaf" growth of flower-like WS₂ is achieved by increasing the temperature.     

全球海洋潜水旅游目的地分布特征及其自然影响因素研究

以全球海洋潜水旅游目的地为研究对象, 借助地理信息系统(GIS), 运用基尼系数、层次分析法(AHP)等方法, 研究全球海洋潜水旅游目的地的分布特征及其自然影响因素. 结果显示: (1)全球海洋潜水旅游目的地的分布数量由低纬向高纬递减; 洲际分布呈现高度集中, 主要聚集区是东亚与东南亚、地中海-红海以及加勒比海沿岸, 太平洋、印度洋与大西洋为散点分布. (2)影响海洋潜水旅游目的地的自然因素主要为海洋地形、海水温度、陆地气温、洋流、潮汐、海水能见度、珊瑚礁等, 相关因素影响程度与广度因海域呈现地域综合导控, 使得海洋潜水旅游目的地主要聚集在热带海域等地.     

Towards Fabrication of Atomic Dopant Wires via Monolayer Doping Patterned by Resist-Free Lithography

Fabrication of atomic dopant wires at large scale is challenging.We explored the feasibility to fabricate atomic dopant wires by nano-patterning self-assembled dopant carrying molecular monolayers via a resist-free lithographic approach.The resist-free lithography is to use electron beam exposure to decompose hydrocarbon contaminants in vacuum chamber into amorphous carbon that serves as an etching mask for nanopatterning the phosphorus-bearing monolayers.Dopant wires were fabricated in silicon by patterning diethyl vinylphosphonate monolayers into lines with a width ranging from 1 μm down to 8 nm.The dopants were subsequently driven into silicon to form dopant wires by rapid thermal annealing.Electrical measurements show a linear correlation between wire width and conductance,indicating the success of the monolayer patterning process at nanoscale.The dopant wires can be potentially scaled down to atomic scale if the dopant thermal diffusion can be mitigated.     

轴流压气机势流和尾迹相互干涉叠加效应分析

尾迹与势流的相互作用对压气机叶片表面的压力波动强度和出口的轴向速度分布及波动会产生很大影响。针对两级跨声速轴流压气机,采用数值方法研究两排转子叶片周向相对位置不同情况下,叶片表面压力波动抵消区域位置发生的变化。研究结果表明:转子叶片周向位置的变化会对静子叶片尾迹形态产生影响,会导致叶片表面压力波动抵消区域发生变化。伴随转子叶片周向相对位置的变化,存在上游转子叶片尾迹减缓下游静子叶片尾迹衰减的现象,从而改变了叶片排之间的相互干涉强度,并使叶片表面压力波动强度发生变化。     

钝头体中的广义雷诺比拟关系

钝头体壁面的摩阻和热流分布规律不同,平板流动中的雷诺比拟关系在钝头体壁面失效. 文章在前期高超声速广义雷诺比拟理论研究工作的基础上,利用数值仿真的方法对不同外形和来流参数条件下的钝头体广义雷诺比拟关系开展进一步研究. 通过建立钝头体绕流边界层的理论分析模型,得到了钝头体壁面雷诺比拟系数的线性分布预示公式. 采用数值求解 N-S 方程的方法,计算了圆柱和幂次体壁面的摩阻和热流以及二者之间的比拟系数. 通过与前期数值和理论结果对比,以及计算收敛性和网格无关性检验,对数值方法进行了验证. 通过在不同雷诺数 ($Re_\infty = 3.98\times 10^2 \sim 1.59\times 10^6$) 和马赫数 ($M_\infty = 3\sim 12$) 条件下的计算结果对比分析雷诺比拟系数的分布,总结了钝头体中广义雷诺比拟关系受外形和来流条件的影响,评估了广义雷诺比拟理论的适用性. 研究发现,在较高雷诺数条件下,离驻点较远的下游 ($\theta > 60^\circ$) 部位,雷诺比拟系数的分布不同程度地偏离理论预示的线性规律. 相比于圆柱外形,幂次体壁面的雷诺比拟系数分布的线性规律相对较好,其分布斜率略低于圆柱壁面的结果. 研究表明,如果针对实际外形和雷诺数进行适当修正,可以提高广义雷诺比拟关系的预示精度.      

Mindlin 矩形微板的热弹性阻尼解析解

首次给出了四边简支的 Mindlin 矩形微板热弹性阻尼的解析解. 基于考虑一阶剪切变形的 Mindlin 板理论和单向耦合热传导理论建立了微板热弹性耦合自由振动控制微分方程. 忽略温度梯度在面内的变化,在上下表面绝热边界条件下求得了用变形几何量表示的温度场的解析解. 进一步将包含热弯曲内力的结构振动方程转化为只包含挠度振幅的四阶偏微分方程. 利用特征值问题之间在数学上的相似性,在四边简支条件下给出了用无阻尼 Kirchhoff 微板的固有频率表示的 Mindlin 矩形微板的复频率解析解,从而利用复频率法求得了反映热弹性阻尼水平的逆品质因子. 最后,通过数值结果定量地分析了剪切变形、材料以及几何参数对热弹性阻尼的影响 规律. 结果表明,Mindlin 板理论预测的热弹性阻尼小于 Kirchhoff 板理论预测的热弹性阻尼. 两种理论预测的热弹性阻尼之间的差值在临界厚度附近十分显著. 另外,随着微板的边/厚比增大,Mindlin 微板的热弹性阻尼最大值单调增大,而 Kirchhoff 微板的热弹性阻尼最大值却保持不变.      

Nd∶YVO4/Nd∶GdVO4双波长激光器的功率均衡实验研究

实验研究了Nd∶YVO4/Nd∶GdVO4双波长激光器在不同抽运功率条件下,通过调节热沉温度达到功率均衡时的输出特性.实验结果表明:对于Nd∶YVO4/Nd∶GdVO4双波长激光器,当提高抽运功率,需要重新降低热沉温度达到功率均衡输出,降温幅度与抽运功率增加之比为11.23℃/W.与此同时,随着抽运功率和热沉温度的变化,双波长激光器的中心波长会出现小幅度的漂移,左峰波长随抽运功率增加的蓝移速率为0.056 nm/W,右峰波长随抽运功率增加的蓝移速率为0.054 nm/W.实验还发现功率均衡条件下激光器的输出总功率随抽运功率的增加而增加,拟合斜效率为8.7%,当抽运功率为5.58 W时,输出最大总功率达到115.7 mW.     

Second harmonic magnetoacoustic responses of magnetic nanoparticles in magnetoacoustic tomography with magnetic induction

Due to the unique magnetic, mechanical and thermal properties, magnetic nanoparticles(MNPs) have comprehensive applications as the contrast and therapeutic agents in biomedical imaging and magnetic hyperthermia. The linear and nonlinear magnetoacoustic responses determined by the magnetic properties of MNPs have attracted more and more attention in biomedical engineering. By considering the relaxation time of MNPs, we derive the formulae of second harmonic magnetoacoustic responses(2H-MARs) for a cylindrical MNP solution model based on the mechanical oscillations of MNPs in magnetoacoustic tomography with magnetic induction(MAT-MI). It is proved that only the second harmonic magnetoacoustic oscillations can be generated by MNPs under an alternating magnetic excitation. The acoustic pressure of the 2H-MAR is proportional to the square of the magnetic field intensity and exhibits a linear increase with the concentration of MNPs. Numerical simulations of the 2H-MAR are confirmed by the experimental measurements for various magnetic field intensities and solution concentrations using a laser vibrometer. The favorable results demonstrate the feasibility of the harmonic measurements without the fundamental interference of the electromagnetic excitation, and suggest a new harmonic imaging strategy of MAT-MI for MNPs with enhanced spatial resolution and improved signal-to-noise ratio in biomedical applications.