5-amino-2-methylpyridinium hydrogen fumarate: An XRD and NMR crystallography analysis

Single-crystal X-ray diffraction structures of the 5-amino-2-methylpyridinium hydrogen fumarate salt have been solved at 150 and 300 K (CCDC 1952142 and 1952143). A base–acid–base–acid ring is formed through pyridinium-carboxylate and amine-carboxylate hydrogen bonds that hold together chains formed from hydrogen-bonded hydrogen fumarate ions. ¹H and ¹³C chemical shifts as well as ¹⁴N shifts that additionally depend on the quadrupolar interaction are determined by experimental magic angle spinning (MAS) solid-state nuclear magnetic resonance (NMR) and gauge-including projector-augmented wave (GIPAW) calculation. Two-dimensional homonuclear ¹H-¹H double-quantum (DQ) MAS and heteronuclear ¹H-¹³C and ¹⁴N-¹H spectra are presented. Only small differences of up to 0.1 and 0.6 ppm for ¹H and ¹³C are observed between GIPAW calculations starting with the two structures solved at 150 and 300 K (after geometry optimisation of atomic positions, but not unit cell parameters). A comparison of GIPAW-calculated ¹H chemical shifts for isolated molecules and the full crystal structures is indicative of hydrogen bonding strength.     

Facile Tailoring of Structures for Controlled Release of Paracetamol from Sustainable Lignin Derived Platforms

Nowadays, sustainable materials are receiving significant attention due to the fact that they will be crucial for the development of the next generation of products and devices. In the present work, hydrogels have been successfully synthesized using lignin which is non-valorized biopolymer from the paper industry. Hydrogels were prepared via crosslinking with Poly(ethylene) glycol diglycidyl ether (PEGDGE). Different crosslinker ratios were used to determine their influence on the structural and chemical properties of the resulting hydrogels. It has been found that pore size was reduced by increasing crosslinker amount. The greater crosslinking density increased the swelling capacity of the hydrogels due to the presence of more hydrophilic groups in the hydrogel network. Paracetamol release test showed higher drug diffusion for hydrogels produced with a ratio lignin:PEGDGE 1:1. The obtained results demonstrate that the proposed approach is a promising route to utilize lignocellulose waste for producing porous materials for advanced biomedical applications in the pharmacy industry.     

A parallel acquisition charged particle energy analyser using a magnetic field

A new form of charged particle energy analyser is proposed. It is broadly based on the 180° magnetic spectrograph, but is intended to detect charged particles moving out of the dispersion plane with a helical motion. The analyser has the capability to acquire charged particle energy spectra over a large energy range, similar to those acquired in Auger electron spectroscopy, ca. 2500 eV and large angular range, up to 90°, in parallel. These conditions are more favourable for surface analysis by electron spectroscopy at high vacuum, where for example an electron energy resolution of 0.2% to 0.5% is typical. Expressions showing how the landing positions of the charged particles on the detector vary as a function of energy and polar take off angle are determined as well as the conditions for optimum energy resolution at a range of polar take off angles. The equations reveal that in general, the device obtains the highest resolution at angles of revolution greater than 180°. The design is simple and could be easily put into practice using available material and technologies and be used to analyse the energies of electrons emitted from a sample placed in a scanning electron microscope. It can be made to function with a primary electron beam of any desired energy and could fit in to the small space between the sample and the end of an electron column. However, the device is difficult to retrofit into existing SEMs and ideally an SEM column needs to be designed to work in association with the analyser. The direction of the magnetic field of the analyser is coincident with the axis of the electron gun so that the primary beam is little influenced by the magnetic field and symmetry can be maintained in the primary beam electron column. Because the device is intended to acquire electron spectra in parallel, any movement of the primary beam on the sample because of a ramping field in the analyser is avoided. The field of view and the effect of the analyser upon the operation of the SEM are discussed. Spectra including elastic and Auger peaks reveal an energy resolution of ~4 eV at 900‐eV electron energy. Copyright © 2016 John Wiley & Sons, Ltd.     

Twist-Bend Nematic Glasses: The Synthesis and Characterisation of Pyrene-based Nonsymmetric Dimers

A selection of pyrene-based liquid crystal dimers have been prepared, containing either methylene-ether or diether linked spacers of varying length and parity. All the diether linked materials, CBOnO.Py (n=5, 6, 11, 12), exhibit conventional nematic and smectic A phases, with the exception of CBO11O.Py which is exclusively nematic. The methylene-ether linked dimer, CBnO.Py, with an even-membered spacer (n=5) was solely nematogenic, but odd-members (n=6, 8, 10) exhibited both nematic and twist-bend nematic phases. Replacement of the cyanobiphenyl fragment by cyanoterphenyl giving CT6O.Py, gave elevated melting and nematic-isotropic transition temperatures, and SmA and SmC_A phases were observed on cooling the nematic phase. Intermolecular face-to-face associations of the pyrene moieties drive glass formation, and all these materials have a glass transition temperature at or above room temperature. The stability of the glassy twist-bend nematic phase allowed for its study using AFM, and the helical pitch length, P_TB, was measured as 6.3 and 6.7 nm for CB6O.Py and CB8O.Py, respectively. These values are comparable to the shortest pitch of a twist-bend nematic phase measured to date.     

Lengthscale-dependent,elastically anisotropic,physically-based hcp crystal plasticity: Application to cold-dwell fatigue in Ti alloys

A crystal plasticity model for hcp materials is presented which is based on dislocation glide and pinning. Slip is assumed to occur on basal and prismatic systems, and dislocation pinning through the generation of geometrically necessary dislocations (GNDs). Elastic anisotropy and, through the coupling of GNDs with slip rate, physically-based lengthscale effects are included.     

Individuality Normalization when Labeling with Isotopic Glycan Hydrazide Tags (INLIGHT): A Novel Glycan-Relative Quantification Strategy

The Individuality Normalization when Labeling with Isotopic Glycan Hydrazide Tags (INLIGHT) strategy for the sample preparation, data analysis, and relative quantification of N-linked glycans is presented. Glycans are derivatized with either natural (L) or stable-isotope labeled (H) hydrazide reagents and analyzed using reversed phase liquid chromatography coupled online to a Q Exactive mass spectrometer. A simple glycan ladder, maltodextrin, is first used to demonstrate the relative quantification strategy in samples with negligible analytical and biological variability. It is shown that after a molecular weight correction attributable to isotopic overlap and a post-acquisition normalization of the data to account for any systematic bias, a plot of the experimental H:L ratio versus the calculated H:L ratio exhibits a correlation of unity for maltodextrin samples mixed in different ratios. We also demonstrate that the INLIGHT approach can quantify species over four orders of magnitude in ion abundance. The INLIGHT strategy is further demonstrated in pooled human plasma, where it is shown that the post-acquisition normalization is more effective than using a single spiked-in internal standard. Finally, changes in glycosylation are able to be detected in complex biological matrices, when spiked with a glycoprotein. The ability to spike in a glycoprotein and detect change at the glycan level validates both the sample preparation and data analysis strategy, making INLIGHT an invaluable relative quantification strategy for the field of glycomics.

Evaluation of the interrelationship between mass resolving power and mass error tolerances for targeted bioanalysis using liquid chromatography coupled to high‐resolution mass spectrometry

The determination of acceptable mass error tolerances for high‐resolution mass spectrometry based signals has been evaluated in a comprehensive way. This was achieved by using a technical approach which is based on the post‐column infusion of an analyte containing solution. This well‐known experimental setup was not used to spot signal suppression regions of a particular analyte, but to spot regions of the chromatogram where a systematic mass drift of the analyte ion can be observed (isobaric interference plot). Not the changing signal intensity but the stability of the measured analyte mass was observed. A wide range of different analytes in combinations with potentially interfering matrices has been evaluated. Furthermore, different mass resolving power settings were evaluated. Isobaric interferences between matrix compounds and analytes were common at mass resolving powers <50 000 full width at half maximum. The proposed post‐column infusion technique is a useful tool for the determination of the assay and matrix‐specific mass error tolerances. It aims to ensure the highest possible selectivity, at the same time preventing the encounter of detrimental mass error related peak deformations as well as false negative findings. Unlike conventional matrix spiking approaches, isobaric interference plots provide information of potential interferences across the whole chromatographic time range. This becomes relevant when there is a relative retention time shift between the analyte and potential interfering matrix compounds. Furthermore, the described setup can be used to study how the mass accuracy of any mass spectrometer is affected by a widely varying total ion current. Copyright © 2012 John Wiley & Sons, Ltd.     

The evaluation of molecular electronic matrix elements using the symmetric group

The properties of the symmetric group are used to deduce matrix elements of one and two-electron operators between molecular states. It is shown that these techniques can be applied to any point group as long as no irreducible representation is more than doubly degenerate.     

Structural and Kinetic Aspects of Blood Plasma Protein Adsorption on the Surface of Hydrophobic Polymers

Abstract

Due to the wide use of polymers in medicine, researchers are required to solve a very important problem–to understand the interaction between materials of nonphysiological origin and the surrounding biological liquids, and tissues, particularly blood.