Capillary electrophoresis analysis of gentamicin sulphate with UV detection after pre-capillary derivatization with 1,2-phthalic dicarboxaldehyde and mercaptoacetic acid

A selective, sensitive, and rapid pre-capillary derivatization method for determination of the multicomponent aminoglycoside antibiotic gentamicin is described. The derivatization reagents 1,2-phthalic dicarboxaldehyde and mercaptoacetic acid were used and the thioisoindole derivative was UV detected at 330 nm. A central composite experimental design was performed to optimize selectivity and derivatization conditions. Baseline separation of gentamicin C1, C1a, C2, C2a, C2b, sisomicin and several minor components was achieved with a background electrolyte containing 30 mM sodium tetraborate, 7.5 mM beta-cyclodextrin and 12.5% (v/v) methanol at pH 10. Quantitative analysis was performed and illustrated the potential use of capillary electrophoresis for the identification and quantitation of gentamicin as an alternative to methods prescribed in the United States Pharmacopeia and European Pharmacopoeia.     

Minimal number of chromatographic test parameters for the characterisation of reversed-phase liquid chromatographic stationary phases

This paper focuses on the classification or differentiation of RP-HPLC columns based on measured chromatographic properties. A chemometric study has been conducted on a published data set consisting of 85 RP-HPLC columns and on a data set consisting of 47 self-tested columns. Principal component analysis enables determination of the number of parameters necessary for a rational differentiation. The results show that reducing the number of parameters for such differentiation still allows classification of the columns just as a higher number did. It is shown that three test parameters produce a classification similar to that obtained with five parameters.     

Liquid chromatography of josamycin on poly(styrene-divinylbenzene)

An isocratic liquid chromatographic method for the assay and purity control of josamycin using wide-pore poly(styrene-divinylbenzene) as the stationary phase is presented. Josamycin has been well separated from all the related leucomycins, present as impurities in commercial samples. Wide-pore PLRP-S 8 m 1000 Å has shown the best selectivity. The separation has been carried out at 65°C with a mobile phase of 2-methyl-2-propanol/0.2 mol/l potassium phosphate buffer pH 10.5/water (24.5: 5: 70.5, V/V) and a flow rate of 1.0 ml/min. UV detection has been performed at 232 nm. The total analysis time has been about 40 min. The method has been used to analyse commercial bulk samples and tablets containing josamycin base.Dedicated to Professor Dr. Dr. h.c. mult. J.F.K. Huber on the occasion of his 70th birthday     

Investigation of unknown related substances in commercial erythromycin samples with liquid chromatography/mass spectrometry

A selective reversed phase liquid chromatography/mass spectrometry (LC/MS(n)) method is described for the identification of erythromycin impurities and related substances in commercial erythromycin samples. Mass spectral data are acquired on a LCQ ion trap mass spectrometer equipped with an electrospray interface operated in positive ion mode. The LCQ is ideally suited for identification of impurities and related substances because it provides on-line LC/MS(n) capability. Compared with UV detection, this hyphenated LC/MS(n) technique provides as a main advantage efficient identification of novel substances without time-consuming isolation and purification procedures. Using this method four novel related substances were identified in commercial samples.     

Analysis of colistin sulfate by capillary zone electrophoresis with cyclodextrins as additive

A method for the quantitative analysis of colistin sulfate by capillary zone electrophoresis is described. Since colistin components have five free amino groups, they tend to adsorb onto the capillary wall and cause peak tailing. It was found that triethanolamine (TEA)-phosphate buffer at pH 2.5 was useful to reduce such adsorption. Methyl-beta-cyclodextrin (M-beta-CD) and 2-propanol (IPA) were found necessary for selectivity enhancement. In order to optimize the separation parameters and predict the method robustness, a central composite design was performed including three variables, namely concentration of M-beta-CD, TEA, and IPA. The effects of capillary length and applied voltage on separation were also investigated. The optimal conditions established were: 140 mM TEA-phosphate buffer containing 5 mM M-beta-CD and 6% v/v IPA, a capillary with 55 cm total length (50 microm inner diameter, 47 cm from inlet to detection window) and 24 kV applied voltage. The method was found to be robust when the variables were changed in the following range: 4-6 mM M-beta-CD, 5-7% v/v IPA, and 130-150 mM TEA. Further, the linearity, limit of detection (LOD), and limit of quantitation (LOQ), as well as repeatability for both colistin A and B were examined and three commercial samples were quantitatively analyzed.     

Analysis of unknown compounds in azithromycin bulk samples with liquid chromatography coupled to ion trap mass spectrometry

A selective reversed-phase liquid chromatography/mass spectrometry (LC/MS(n)) method is described for the identification of azithromycin impurities and related substances in commercial azithromycin samples. Mass spectral data are acquired on an LCQ ion trap mass spectrometer equipped with an atmospheric pressure chemical ionization interface operated in positive ion mode. The LCQ provides on-line LC/MS(n) capability, making it ideally suited for identification purposes. In comparison with UV detection, this hyphenated technique provides as its main advantage efficient identification of novel substances without time-consuming isolation and purification procedures. Using this technique, six novel related substances detected in commercial azithromycin samples have been studied.     

Electrophoretically mediated microanalysis of gentamicin with in-capillary derivatization and UV detection.

This paper describes a system for integration of a one-step-microscale chemical derivatization and analysis by a methodology known as electrophoretically mediated microanalysis (EMMA). Differential electrophoretic mobility between an analyte, reagent, and their product offers EMMA a unique capability to selectively carry out electrophoretic mixing, control product formation, and separation. This system was successfully applied to perform derivatization and separation of the multicomponent aminoglycoside antibiotic gentamicin using 1,2-phthalic dicarboxaldehyde and mercaptoacetic acid as labeling reagents. A multivariate approach based on central composite experimental design was used to optimize the derivative yield. Full automation of the derivatization and analytical procedure, high derivatization efficiency, high sample throughput, and precision are the excellent features of the present method. In addition, this methodology offers short analysis time, as well as selectivity and sensitivity suitable for impurities determination. Separation of gentamicin C1, C1a, C2, C2a, C2b, sisomicin, and several minor components was achieved. For the first time separation and identification of three impurities, namely garamine, 2-deoxystreptamine, and paromamine are described.     

Quantitative Determination of Olaquindox in Animal Feed

JPC – Journal of Planar Chromatography – Modern TLC - A quantitative thin layer chromatographic (TLC) method on silica gel, with ethyl acetate–acetone–alcohol, 62 + 40 + 3...     

Analysis of bacitracin by micellar electrokinetic capillary chromatography with mixed micelle in acidic solution

A method used for quantitative analysis of bacitracin with micellar electrokinetic capillary chromatography (MEKC) is described. As capillary zone electrophoresis gave poor separation selectivity, MEKC was preferable. It was found that a zwitterionic surfactant, 3-(N,N-dimethylhexadecylammonium)-propanesulfonate (PAPS) gave the best selectivity among the several surfactants studied. As the analytes tend to adsorb onto the capillary wall due to their positive charge, an acidic solution composed of Tris-phosphate buffer at pH 2.5 was necessary to diminish such adsorption. The peak tailing caused by relatively strong ion pair interaction between the analyte and PAPS micelle could be reduced by adding nonionic surfactant Brij 35 to the PAPS solution. This phenomenon is possibly explained by a mixed micelle mechanism. In order to obtain the optimal conditions and to test the method robustness, a central composite experimental design was performed. The optimal conditions are as follows: 44 cm length of fused-silica capillary with 50 microm inner diameter, 90 mM Tris-phosphate buffer (pH 2.5) containing 17 mM PAPS and 0.3% w/v-Brij 35, 18 kV applied voltage, UV detection at 192 nm and 25 degrees C column temperature. Under the optimal conditions, more than 50 peaks could be obtained in 30 min. The method had a linearity range from 1 to 0.05 mg/mL (concentration of bacitracin A). The limit of quantitation (LOQ) and limit of detection (LOD) were 0.005 and 0.0012 mg/mL, respectively.