Effect of Pr-Ca substitution on the transport and magnetic behavior of LaMnO3 perovskite

The effect of simultaneous substitution of a fluctuating cation and a divalent cation in LaMnO₃ perovskite modifies the properties of the material to exhibit large valence colossal magnetoresistance (CMR) effect. A good example of these properties is (La_1−2x Pr _x Ca _x )MnO₃ (LPCMO) type CMR material. In this communication it is reported that, with the increase in x (for x=0.1, 0.15, 0.2), the T _c varies between 100 and 120 K with improvisation in metal-insulator transition. Interestingly, resistance increases with x from few hundred ohms to few kilo ohms with corresponding decrease in the unit cell volume. The results of the studies using X-ray diffraction (XRD), electrical resistivity, magnetoresistance and ac susceptibility measurements on LPCMO samples for understanding the structural, transport and magnetic properties are discussed in detail.     

Meerwein reaction of phosphonium ions with epoxides and thioepoxides in the gas phase

Phosphonium ions are shown to undergo a gas-phase Meerwein reaction in which epoxides (or thioepoxides) undergo three-to-five-membered ring expansion to yield dioxaphospholanium (or oxathiophospholanium) ion products. When the association reaction is followed by collision-induced dissociation (CID), the oxirane (or thiirane) is eliminated, making this ion molecule reaction/CID sequence a good method of net oxygen-by-sulfur replacement in the phosphonium ions. This replacement results in a characteristic mass shift of 16 units and provides evidence for the cyclic nature of the gas-phase Meerwein product ions, while improving selectivity for phosphonium ion detection. This reaction sequence also constitutes a gas-phase route to convert phosphonium ions into their sulfur analogs. Phosphonium and related ions are important targets since they are commonly and readily formed in mass spectrometric analysis upon dissociative electron ionization of organophosphorous esters. The Meerwein reaction should provide a new and very useful method of recognizing compounds that yield these ions, which includes a number of chemical warfare agents. The Meerwein reaction proceeds by phosphonium ion addition to the sulfur or oxygen center, followed by intramolecular nucleophilic attack with ring expansion to yield the 1,3,2-dioxaphospholanium or 1,3,2-oxathiophospholanium ion. Product ion structures were investigated by CID tandem mass spectrometry (MS(2)) experiments and corroborated by DFT/HF calculations.     

Liquid chromatographic determination of urea in water-soluble urea-formaldehyde fertilizer products and in aqueous urea solutions: collaborative study

Water soluble urea-formaldehyde (UF) fertilizers, manufactured by complex reaction of urea and formaldehyde, typically contain varying amounts of unreacted urea. A liquid chromatography method for the analysis of urea in these products, and in aqueous urea solutions, was collaboratively studied. An amine chromatography column was used to separate the unreacted urea from numerous UF reaction products present in these liquid fertilizers. Unreacted urea was determined by using external urea standards with UV detection at 195 nm. The standards and test samples were prepared in the mobile phase of 85% (v/v) acetonitrile in water. Ten laboratories analyzed 5 different UF-based commercial products containing unreacted urea in the range of 6 to 17% by weight, and 5 different concentrations of urea in water equivalent to commercial products of that nature. The aqueous urea solutions contained 2-20% urea (w/w). The range of s(R) values for the 5 UF-based commercial fertilizers was 0.49-1.02 and the %RSD(R) was 1.94-6.14. The s(R) range for the 5 urea solutions was 0.10 to 0.79 and the %RSD(R) range was 2.54 to 4.88. The average recovery of urea from the aqueous urea solutions was 96-103%. Therefore, this method is capable of monitoring urea nitrogen manufacturers' label claims and total nitrogen claims in those cases where urea is the sole source of plant food nitrogen. Based on the collaborative study data, the authors recommend this method be approved for AOAC Official First Action status.     

Cr(VI) Oxidation of Cholesterol—A Kinetic Study Using N-Cetylpicolinium Dichromates,A Class of Novel Phase Transfer Oxidants

Kinetics and Catalysis - Kinetic study of cholesterol oxidation has been studied using a series of N-cetylpicolinium dichromates (CPDC), a class of phase transfer oxidants, in acetic acid medium...     

Reversed-phase liquid chromatographic determination of riboflavin in feeds

A method for determination of riboflavin in animal feeds using liquid chromatography (LC) was developed for feed samples fortified with riboflavin at 1 mg/lb or greater (up to 10,000 mg/lb). Feed samples were extracted in 0.1 N HCl with heating on a steam bath for 30 min, followed immediately by mechanical shaking for 30 min. Sample extracts were diluted to target volume with 2% acetic acid and filtered; riboflavin was determined by LC on a reversed-phase C18 column with 2% acetic acid-acetonitrile (85 + 15) mobile phase for separation and fluorescence detection with excitation at 460 nm and emission at 530 nm. The extraction was compared with that of the AOAC Official Method for riboflavin in food and feed premixes. The 2 method extractions were not significantly different from each other at the 95% confidence level. The developed method also had good linearity over 4 orders of magnitude, recovery of 95-99% from spiked feed samples, a limit of detection of riboflavin at 0.00034 microg/mL in solution, a limit of quantitation of 0.023 mg/lb in feed, and good ruggedness.     

Single-sided membrane introduction mass spectrometry for on-line determination of semi-volatile organic compounds in air.

Construction, optimization, and testing of a novel single-sided configuration for a semi-permeable [poly(dimethylsiloxane); PDMS] membrane introduction system for mass spectrometry is described. On-line detection of semi-volatile organic compounds of environmental interest is shown, including lindane (a pesticide), hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) (an explosive), butylated hydroxytoluene (BHT) (an antioxidant), 1,2-dichlorobenzene, dimethylmethyl phosphonate (DMMP) (a chemical warfare agent simulant) and naphthalene. The technique has limits of detection in the sub-ppb range. with rise times of 4 to 7 s and fall times of 12 to 36 s and a response that is linear over 4 orders of magnitude (from 0.1 ppb to 1000 ppb for DMMP). The cycle time, from crude air sampling to acquisition of results, is approximately 1 min. No sample preparation is necessary.     

Elastic properties of the Ta–V system: bcc Ta0.33V0.67 and C15 TaV2

Resonant ultrasound spectroscopy was used to measure the elastic constants of bcc Ta_0.33V_0.67 over the temperature range 3.5–300?K; the results were compared to earlier measurements on C15 TaV₂. The temperature dependence of the polycrystalline shear modulus is completely different in the two phases; that of the bcc phase decreases with temperature whereas that of the C15 phases increases in an anomalous fashion. This difference is consistent with a model involving doubly-degenerate levels at the X point of the Brillouin zone in the C15 phase with the Fermi level lying near the doubly degenerate level. This model accounted for the unusual behaviour of the C15 phase. Debye temperatures were determined from the ultrasonic measurements: 295?K for the C15 phase and 315?K for the bcc phase.     

Structural characteristics of different types of nanoparticles synthesised in mesomorphic metal alkanoates

The class of thermotropic ionic liquid crystals (LCs) of the metal alkanoates possesses a number of unique properties, such as intrinsic ionic conductivity, high dissolving ability and ability to form time-stable mesomorphic glasses. These ionic LCs can be used as nanoreactors for the synthesis and stabilisation of different types of nanoparticles (NPs). Thus, some semiconductors, metals and core/shell NPs were chemically synthesised in the thermotropic ionic liquid crystalline phase (smectic A) of the cadmium octanoate (CdC₈) and of the cobalt octanoate (CoC₈). By applying the scanning electron microscopy, the cadmium and cobalt octanoate composites containing CdS, Au, Ag and core/shell Au/CdS NPs have been studied. NPs’ sizes and dispersion distribution of the NPs’ size in the nanocomposites have been obtained.     

Irradiation of a cone by a magnetic dipole

Th electromagnetic field produced by a magnetic dipole in thepresence of a perfectly conducting cone of arbitrary cross-sectionis determined. The solution is used to find out how a currenton the cone travelling towards the apex is reflected. Some valuesof the reflection coefficient are calculated. In particular,it is shown that there is a sort of resonance with the reflectionincreasing significantly as the cone approaches a plane.