A Highly Accurate Refractive Index Sensor with Two Operation Modes Based on Photonic Crystal Ring Resonator

A 2D hole‐type hexagonal lattice photonic crystal is utilized, herein, to detect the refractive index change of the material infiltrated into the designed circular sensing area which also resembles a ring resonator. The accuracy of the detection process is enhanced considering the simultaneous shift of the resonance wavelengths and the intensity modulation which occur in two separate spectral regions. The presented structure has the ability to detect liquids, material concentrations in fluids and gases having refractive indices in the range of n = 1–2 with sensitivity and quality factor of 61 nm/RIU and 3000, respectively, for resonance‐wavelength‐shift‐based operation. The detection range of n = 1–1.4 with the sensitivity of S = 0.69 NI/RIU is achieved for the intensity‐based measurement and the results show good linearity in the operating range.     

Polyethylene Glycol Functionalized Graphene Oxide Nanoparticles Loaded with Nigella sativa Extract: A Smart Antibacterial Therapeutic Drug Delivery System

Flaky graphene oxide (GO) nanoparticles (NPs) were synthesized using Hummer’s method and then capped with polyethylene glycol (PEG) by an esterification reaction, then loaded with Nigella sativa (N. sativa) seed extract. Aiming to investigate their potential use as a smart drug delivery system against Staphylococcus aureus and Escherichia coli, the spectral and structural characteristics of GO-PEG NPs were comprehensively analyzed by XRD, AFM, TEM, FTIR, and UV- Vis. XRD patterns revealed that GO-PEG had different crystalline structures and defects, as well as a higher interlayer spacing. AFM results showed GONPs with the main grain size of 24.41 nm, while GONPs–PEG revealed graphene oxide aggregation with the main grain size of 287.04 nm after loading N. sativa seed extract, which was verified by TEM examination. A strong OH bond appeared in FTIR spectra. Furthermore, UV- Vis absorbance peaks at (275, 284, 324, and 327) nm seemed to be correlated with GONPs, GO–PEG, N. sativa seed extract, and GO –PEG- N. sativa extract. The drug delivery system was observed to destroy the bacteria by permeating the bacterial nucleic acid and cytoplasmic membrane, resulting in the loss of cell wall integrity, nucleic acid damage, and increased cell-wall permeability.     

Reversible Supramolecular Surface Attachment of Enzyme–Polymer Conjugates for the Design of Biocatalytic Filtration Membranes

To be used successfully in continuous reactor systems, enzymes must either be retained using filtration membranes or immobilized on a solid component of the reactor. Whereas the first approach requires large amounts of energy, the second approach is limited by the low temporal stability of enzymes under operational conditions. To circumvent these major stumbling blocks, we have developed a strategy that enables the reversible supramolecular immobilization of bioactive enzyme–polymer conjugates at the surface of filtration membranes. The polymer is produced through a reversible addition–fragmentation transfer method; it contains multiple adamantyl moieties that are used to bind the resulting conjugate at the surface of the membrane which has surface‐immobilized cyclodextrin macrocycles. This supramolecular modification is stable under operational conditions and allows for efficient biocatalysis, and can be reversed by competitive host–guest interactions.     

Application of an Itô-based approximation method to random vibration of a pinching hysteretic system

In this paper, an extension of the Cumulant-Neglect closure scheme is utilized for the random vibration analysis of a single degree of freedom system with a general pinching hysteresis restoring force. The hysteresis element used in the system model can simulate commonly observed forms of stiffness, strength and pinching degradations. The second order statistics of the system response to a stationary Gaussian white noise input are derived using an Itô-based approximation technique. The validity of these response statistics are then verified by comparing them to Monte Carlo simulation results. The numerical studies performed for different combinations of degradation parameters and excitation levels show that the response estimates obtained by this solution method are in good agreement with Monte Carlo simulation. These studies also indicate the applicability of this technique for response analysis of complicated forms of non-linearities.     

Shape control of nanostructured TiO2 using a Schiff base ligand via sol–gel hydrothermal method

Employing a Schiff base ligand in a hydrothermal sol–gel method for preparation of TiO₂ nanostructures was studied. The as-prepared products were characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy, Fourier transform infrared spectrum, electron dispersive X-ray spectroscopy and ultraviolet–visible spectroscopy. It is shown that in the controlled reaction conditions, a Schiff base ligand containing hard atoms is capable of driving the growth mechanism in a way that anisotropic shapes of TiO₂ nanostructures are formed. Considering the structure of the Schiff base ligand, the possible growth mechanism of TiO₂ nanostructures is proposed. The optical studied as well as calculated molecular orbital structure of ligand by density functional theory is done.     

A Facile Room Temperature Synthesis of Zinc Oxide Nanostructure and Its Influence on the Flame Retardancy of Poly Vinyl Alcohol

In this work, poly vinyl alcohol–ZnO nanocomposites were synthesized via two different in situ and ex-situ methods. In ex-situ, at first zinc oxide nanostructures were synthesized by one-step precipitation reaction between zinc acetate and sodium hydroxide. The effect of different surfactants such as poly vinyl pyrrolidone, poly vinyl alcohol and poly ethylene glycol on the morphology of ZnO nanostructures was investigated. Nanostructures were characterized by X-ray diffraction, scanning electron microscopy. The influence of ZnO nanostructures on the flame retardancy of the poly vinyl alcohol matrix was studied using underwriter laboratories UL-94 analysis.     

Surface modified SPIONs‐Cr(VI) ions‐immobilized organic‐inorganic hybrid as a magnetically recyclable nanocatalyst for rapid synthesis of polyhydroquinolines under solvent‐free conditions at room temperature

In this work, a magnetic hybrid dichromate nanocomposite with triphenylphosphine surface modified superparamagnetic iron oxide nanoparticles (SPIONs) as a recyclable nanocatalyst was designed, prepared and characterized by Fourier transform infrared spectroscopy (FT‐IR) spectra, X‐ray diffraction (XRD) pattern analysis, vibrating sample magnetometer (VSM) curves, X‐ray fluorescence (XRF) analysis, thermogravimetric analysis (TGA), scanning electron microscopy (SEM) and transmission electron microscopy (TEM) images and dynamic light scattering (DLS) analysis. Then, it was used in a green and efficient procedure for one‐pot multicomponent synthesis of polyhydroquinoline derivatives by the condensation of aldehydes, dimedone or 1,3‐cyclohexadione, ethyl acetoacetate and ammonium acetate. This protocol includes some new and exceptional advantages such as short reaction times, low catalyst loading, high yields, solvent‐free and room temperature conditions, easy separation and reusability of the catalyst.