Sensitive determination of free and plasma protein-bound dipyridamole by high-performance liquid chromatography

For many years dipyridamole (DP) has been used in the treatment of hypertension as a vasodilator, but recently it has been recognised as an anti-platelet aggregation agent and to potentiate anti-metabolite activity. A rapid and sensitive (20 nM) procedure for the determination of free and protein-bound DP in plasma, using reversed-phase high-performance liquid chromatography on an Ultrasphere XL ODS (3 microns) column (70 mm x 4.6 mm I.D.) with ultraviolet detection (280 nm), is reported. Free and bound DP were separated using ultrafiltration. Concentrations of DP between 0.1 and 10 microM were measured in plasma with a relative standard deviation of less than 9.6%. The subsequent determination of DP levels in patients orally administered 450 mg per day showed that DP binding to plasma protein is higher than 90%.     

Polymer-brush stationary phases for open-tubular capillary electrochromatography

Synthesis of poly(2-hydroxyethyl methacrylate) (PHEMA) brushes from the inside of silica capillaries by surface-initiated atom transfer radical polymerization (ATRP) yields unique stationary phases for open-tubular capillary electrochromatography (OT-CEC). Although PHEMA brushes have only a small effect on the separation of a set of phenols and anilines, derivatization of PHEMA with ethylenediamine (en) allows baseline resolution of several anilines that co-elute from bare silica capillaries. Derivatization of PHEMA with octanoyl chloride (C8-PHEMA films) affords even better resolution in the separation of a series of phenols and anilines. Increasing the thickness of C8-PHEMA coatings by a factor of 2 enhances resolution for several solute pairs, presumably because of an increase in the effective stationary phase to mobile phase volume ratio. Thus, this work demonstrates that thick polymer brushes provide a tunable stationary phase with a much larger phase ratio than is available from monolayer wall coatings. Through appropriate choice of derivatizing reagents, these polymer brushes should allow separation of a wide range of neutral molecules as well as compounds with similar electrophoretic mobilities.     

Conformational and spectroscopic investigation of 3-hydroxyflavone-aluminium chelates

3-Hydroxyflavone (3HF), which is the simplest molecule of the flavonol class, possesses chelating properties towards Al(III). Spectrophotometric methods have shown that the 3HF molecule forms an Al(3HF)2 complex in pure methanol. The structure of this complex, obtained by quantum semi-empirical AM1 method, indicated that complexed 3HF adopts a pyronium form. Structural and electronic modifications induced by chelation are illustrated by the important frequency shifts observed between free and complexed 3HF FT-Raman spectra and by the chemical shifts variations in the 13C NMR spectra of the two species. Complexes with the same stoichiometry were formed when AcO- or MeO- are present in the medium. However, in acidic medium the chelate composition is Al2(3HF).     

Electroreductive polymerization of trans-[RuCl 2(vpy) 4] on Nd-Fe-B magnets: electrochemical impedance spectroscopy interpretation, Raman spectroscopy, X-ray photoelectron spectroscopy and scanning electron microscopy analysis

The electropolymerization of trans-[RuCl₂(vpy)₄] (vpy=4-vinylpyridine) monomer on Nd-Fe-B magnets was studied by electrochemical impedance spectroscopy (EIS). Impedance diagrams obtained during the polymerization process were used to monitor film formation. The EIS results gave insight into the electrochemical phenomena occurring at the magnet surface as the polymerization process progressed. The film structure and morphology were also studied by X-ray photoelectron spectroscopy, scanning electron microscopy and Raman spectroscopy. The Raman spectroscopy results showed that the polymerization takes place at the vinyl groups of the monomer and also that the redox polymer structure is very similar to that of the monomer. The ratio of the intensity of the XPS peaks for fluorine (from the electrolyte PF₆ ^–) and ruthenium present in the film showed that the polymer on Nd-Fe-B contained an equal proportion of Ru²⁺ and Ru³⁺, indicating that part of the film is positively charged, i.e. {[RuCl₂(vpy)₄]⁺} _n .