部分还原氧化石墨烯的制备、 表征及对人宫颈癌HeLa细胞的体外杀伤作用

以氧化石墨烯(GO)为原料, 利用温和方法制备了3种不同还原程度的部分还原氧化石墨烯pRGO₁, pRGO₂和pRGO₃(pRGO_1—3)； 利用傅里叶变换红外光谱(FTIR)、 拉曼光谱(Raman)、 X 射线光电子能谱(XPS)、 紫外-可见光谱(UV-Vis)、 透射电子显微镜(TEM)和 EDS能谱对其结构和形貌进行了表征. 细胞实验结果表明, 无激光照射下pRGO_1—3本身的细胞毒性较低; 近红外(NIR)激光照射下pRGO_1—3通过光热和光毒性双重作用杀伤肿瘤细胞. 实验结果显示了pRGO 在肿瘤光热疗法和光动力疗法领域的应用潜力.     

Correction to: Practical framework for data-driven RANS modeling with data augmentation

Acta Mechanica Sinica -     

一个R2上含双曲函数核的Hilbert型不等式

通过引入参数，构造了一个全平面上的、含双曲函数的非齐次核函数。利用正切函数的有理分式展开，建立了最佳常数因子与正切函数高阶导数相关联的Hilbert型积分不等式。 作为应用，通过赋予参数不同的值，建立了一些有意义的特殊结果。     

新型4-羟色胺类化合物的合成及生物活性

以4-羟基吲哚为原料,经吲哚环4位乙酰基化、3位亲电取代、酰胺化和还原加氢等反应合成目标化合物7.通过核磁共振氢谱及碳谱对化合物进行结构表征,并对目标化合物进行体外抗氧化生物活性测试.初步生物活性测试结果表明,化合物7a,7b,7c和7d对DPPH·均有很强的清除作用(清除率为85.25%~90.73%),7e,7f,7g,7h作用较差;目标化合物与Vc相比,对·OH的清除作用稍差,最高清除率25.66%(Vc的最高清除率为34.67),但各化合物整体水平相当;在清除O-2·能力上化合物7a,7d,7g,7h最大清除率(分别为19.34,35.35,27.93和31.74)均强于同等浓度的Vc(17.58).     

Recyclable and reusable Pd(OAc)2/PPh3/PEG‐2000 system for homocoupling reaction of arylboronic acids under air without base

A stable and efficient Pd(OAc)₂/PPh₃/PEG‐2000 catalytic system for homocoupling of arylboronic acids has been developed. In the presence of Pd(OAc)₂ and PPh₃, the homocoupling reaction of arylboronic acids was carried out smoothly in PEG‐2000 at 70 °C under air without base to afford a variety of symmetric biaryls in good to excellent yields. The isolation of the products was readily performed by extraction with diethyl ether, and the Pd(OAc)₂/PPh₃/PEG‐2000 system could be easily recycled and reused six times without significant loss of catalytic activity. Copyright © 2014 John Wiley & Sons, Ltd.     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

Investigations in the recrystallization of evolved gases from pyrolysis process of melamine

Journal of Thermal Analysis and Calorimetry - A complete analysis of the thermal process about melamine was presented, in which different methods were applied to determine the characteristic of the...     

Evaluation of Charged Defect Energy in Two-Dimensional Semiconductors for Nanoelectronics: The WLZ Extrapolation Method

Defects play a central role in controlling the electronic properties of two-dimensional (2D) materials and realizing the industrialization of 2D electronics. However, the evaluation of charged defects in 2D materials within first-principles calculation is very challenging and has triggered a recent development of the WLZ (Wang, Li, Zhang) extrapolation method. This method lays the foundation of the theoretical evaluation of energies of charged defects in 2D materials within the first-principles framework. Herein, the vital role of defects for advancing 2D electronics is discussed, followed by an introduction of the fundamentals of the WLZ extrapolation method. The ionization energies (IEs) obtained by this method for defects in various 2D semiconductors are then reviewed and summarized. Finally, the unique defect physics in 2D dimensions including the dielectric environment effects, defect ionization process, and carrier transport mechanism captured with the WLZ extrapolation method are presented. As an efficient and reasonable evaluation of charged defects in 2D materials for nanoelectronics and other emerging applications, this work can be of benefit to the community.