10-GHz Optical Comb in L-Band Region With Brillouin/Erbium-Doped Fibre Laser

A multiwavelength Brillouin/erbium fibre laser (BEFL) which operates in the long wavelength (L-band) region is demonstrated for potential applications in an L-band wavelength division multiplexing (WDM) communication system. The laser configuration consists of a long erbium-doped fibre to enable L-band amplification where two 3-dB couplers take a portion of the generated BEFL signal and re-inject it into the single mode fibre to seed a cascaded BEFL line in the same direction as the first BEFL line. A stable and strong laser comb of up to five lines with 10-GHz spacing has been obtained with a Brillouin pump (BP) of 9.2 mW and a 980 nm pump of 92 mW. The BEFL has shown a broad tuning range with a tuning characteristic for line #1 which is flat over a range greater than 9.9 nm.     

Differential pulse polarographic determination of some organotin(IV) compounds in dimethyl sulfoxide

The differential pulse polarographic behavior of two series of organotin(IV) compounds having the general formula R_xSnCl_{4 − x} (R = Me, Ph; x = 1, 2, 3, 4) has been investigated in DMSO. The peaks obtained are recommended for the trace determination of these compounds. Linear calibration curves are obtained over the concentration range 10⁻⁴ –10⁻⁶ M.     

Switchable Q-switched and laser operating mode-locked erbium-doped fiber in the L-band region

We demonstrate a switchable Q-switched and mode-locked erbium-doped fiber laser （EDFL） operating in the L-band region using the nonlinear polarization rotation effect. The switching operation is achieved by controlling intensity-dependent loss using a polarization controller. In Q-switching mode, the EDFL produces a pulse train with a repetition rate of 21.1 kHz, pulse width of 7.7 #s, and pulse energy of 13.6 nJ. The EDFL also generates a multi-wavelength comb with a very narrow and constant wavelength spacing of 0.045 nm and optical signal-to-noise ratio of at least l0 dB. During mode locking, the EDFL produces stretched pulses with 3-dB bandwidth of 26.2 nm, pulse width of 350 fs, repetition rate of 2.38 MHz, and pulse energy of 48.56 pJ.     

Novel phenothiazine-based chalcone derivatives with various N-substituted rhodanines induce growth inhibition followed by apoptosis in leukemia cells

Research on Chemical Intermediates - Eight new series of novel phenothiazine-based chalcone derivatives with various N-substituted rhodanines (10a–g to 17a–g) were synthesized by...     

Sol–gel synthesis and characterization of conducting polythiophene/tin phosphate nano tetrapod composite cation-exchanger and its application as Hg(II) selective membrane electrode

Nano tetrapod based on conducting polythiophene (PTh) and tin-phosphate (SnP) were synthesized by in situ chemical oxidative polymerization. The morphology of the resulting polythiophene tinphosphate composite was characterized by elemental analysis, fourier transform infrared spectroscopy, thermogravimetric analysis, powder X-ray diffraction, scanning electron microscopy and transmission electron microscopy. The physico-chemical characterization carried out on the composite showed that SnP was modified by conducting PTh with an enhancement of various properties. On the basis of highest distribution coefficient values for Hg(II), the composite was also used for the preparation of Hg(II) selective membrane electrode. The electrode showed working concentration range of 1 × 10^?1 to 1 × 10^?7 with Nernstian slope of 29.29 mV per decade change in concentration and the electrode may be used for wide working pH range of 4–8 having quick response time about 23 s. The life of electrode is 4 months without any notable drift in potential.     

Anti-atherosclerotic activity of Betulinic acid loaded polyvinyl alcohol/methylacrylate grafted Lignin polymer in high fat diet induced atherosclerosis model rats

Betulinic acid is one such natural pentacyclic triterpenoid compound, holding various pharmacological properties but its poor bioavailability is the only limitation. One of the biological macromolecules such as Lignin is a plant-derived aromatic, eco-friendly and low-cost polymer that certainly self-assembles into nano-sized colloids. Therefore, onto the current investigation, we increased the bioavailability of betulinic acid by coating on to a nanopolymer prepared with poly vinyl alcohol, lignins and methyl acrylate. Betulinic acid loaded polyvinyl alcohol/ethylacrylate grafted Lignin polymer (PVA/Lig-g-MA) nanoformulation was characterized using FTIR, XRD, SEM and TEM analysis and also the drug entrapment, in vitro drug releasing capacity was done to examine the efficiency of the nanoformulation of a drug. The MTT assay was evaluated the cytotoxicity of synthesized nanoformulation against normal endothelial cells HUVEC and HAPEC to confirm the side effects of the drug. The anti-atherosclerotic property of the nanoformulation was ascertained in both in vitro condition (with HUVEC and HPAEC) and in vivo studies (with Wistar rats). As a result, the characterization studies and in vitro studies clearly confirmed the Betulinic acid loaded PVA/Lig-g-MA nanoformulation is an ideal nanopolymer and it doesn’t cause any cytotoxic effect in normal endothelial cells. It also decreased the lipopolysaccharides induced inflammation through the down-regulation of NFκB and MAP/JNK signaling molecule expressions. Following in vivo results confirmed the synthesized nanoformulation effectively decreased the hyperchlostremia, inflammation and vasoconstriction, which induced over high fat diet. The results of histopathological analysis of cardiac tissues also confirmed the cardioprotective role of synthesized nanoformulation. Overall, both the in vitro and in vivo studies authentically proven the Betulinic acid loaded PVA/Lig-g-MA nanoformulation would be a potent cost effective anti-atherosclerotic nanodrug.