Cobalt promoted Ni/MgAl2O4 catalyst in lean methane catalytic oxidation

In the present research, magnesium aluminate spinel was prepared as catalyst support using a novel, facile, and efficient mechanochemical method. The Co-promoted catalysts with 20 wt.% of Ni were fabricated using an impregnation route and the samples were analyzed by the X-ray diffraction (XRD), N₂ adsorption/desorption (BET), temperature-programmed reduction and desorption (H₂-TPR and O₂-TPD), and field emission scanning electron microscopy (FESEM) tests. The results confirmed that all samples have a mesoporous structure with a high specific surface area and the presence of cobalt caused complete CH₄ oxidation at low temperatures, and no side reactions were observed. The results indicated that the 3%Co-20%Ni/MgAl₂O₄ catalyst was the optimal sample among the prepared catalysts, owing to the improvement of reduction features and oxygen mobility. The 50 and 90% of methane conversion was obtained at 530 and 600 °C, respectively. Also, the influence of calcination temperature, GHSV, and feed ratio was determined on the catalytic activity. The obtained outcomes revealed that the calcination temperature has a significant effect on the textural properties and catalytic efficiency. The sample calcined at 700 °C showed the weakest performance, which was related to the sintering of particles at high temperatures. The catalytic stability showed that the 3%Co-20%Ni/MgAl₂O₄ has acceptable stability during 600 min time of reaction.

Graphical abstract

     

Nanostructured Colloidal Solutions of Malachite Green Formulated: Nonlinear Optical Properties and Simulation

Journal of Fluorescence - Malachite green (MG) is a dye that has been presented to use as photosensitizers for photodynamic therapy (PDT). Nonlinear absorption coefficient (β) and nonlinear...     

Novel tacrine-based acetylcholinesterase inhibitors as potential agents for the treatment of Alzheimer’s disease: Quinolotacrine hybrids

A new series of quinolotacrine hybrids including cyclopenta- and cyclohexa-quinolotacrine derivatives were designed, synthesized, and assessed as anti-cholinesterase (ChE) agents. The designed derivatives indicated higher inhibitory effect on the acetylcholinesterase (AChE) with IC₅₀ values of 0.285–100 µM compared to butyrylcholinesterase (BChE) with IC₅₀ values of?>?100 µM. Of these compounds, cyclohexa-quinolotacrine hybrids displayed a little better anti-AChE activity than cyclopenta-quinolotacrine hybrids. Compound 8-amino-7-(3-hydroxyphenyl)-5,7,9,10,11,12-hexahydro-6H-pyrano[2,3-b:5,6-c'] diquinolin-6-one (6m) including 3-hydroxyphenyl and cyclohexane ring moieties exhibited the best AChE inhibitory activity with IC₅₀ value of 0.285 µM. The kinetic and molecular docking studies indicated that compound 6m occupied both the catalytic anionic site (CAS) and peripheral anionic site (PAS) of AChE as a mixed inhibitor. Using neuroprotective assay against H₂O₂-induced cell death in PC12 cells, the compound 6h illustrated significant protection among the assessed compounds. In silico ADME studies estimated good drug-likeness for the designed compounds. As a result, these quinolotacrine hybrids can be very encouraging AChE inhibitors to treat Alzheimer’s disease.

Graphic abstract

A novel series of quinolotacrine hybrids were designed, synthesized, and evaluated against AChE and BChE enzymes as potential agents for the treatment of AD. The hybrids showed good to significant inhibitory activity against AChE (0.285–100 μM) compared to butyrylcholinesterase (BChE) with IC₅₀ values of?>?100 μM. Among them, compound 8-amino-7-(3-hydroxyphenyl)-5,7,9,10,11,12-hexahydro-6H-pyrano[2,3-b:5,6-c′] diquinolin-6-one (6 m) bearing 3-hydroxyphenyl moiety and cyclohexane ring exhibited the highest anti-AChE activity with IC₅₀ value of 0.285 μM. The kinetic and molecular docking studies illustrated that compound 6 m is a mixed inhibitor and binds to both the catalytic anionic site (CAS) and peripheral anionic site (PAS) of AChE.

     

Form Factor of Proton Predicted Using the Data of ppbar Elastic Scattering at $$\boldsymbol{\sqrt{s}=1.96}$$ eV

Physics of Atomic Nuclei - Based on the behavior of elastic scattering of proton and anti-proton at $$\sqrt{s}=1.96$$ TeV for squared four-momentum transfer $$0.26<{-}t<1.2($$ GeV...     

Some necessary and sufficient conditions for Hypercyclicity Criterion

We give necessary and sufficient conditions for an operator on a separable Hilbert space to satisfy the hypercyclicity criterion. This paper is a part of the second author’s Doctoral thesis, written at Shiraz University under the direction of the first author.     

以金属硫酸氢盐为催化剂在无溶剂条件下高效合成3,4-二氢嘧啶-2(1H)-酮

以金属硫酸氢盐M(HSO4)n(Ca(HSO4)2,Zn(HSO4)2和过硫酸氢钾制剂oxone○R)为催化剂催化醛、1,3-二羰基化合物和尿素进行缩合反应,在90℃及无溶剂的条件下高收率、一锅法合成了3,4-二氢嘧啶-2(1H)-酮.     

Synthesis and Spectroscopic Study of Some New Phosphoramidates,Crystal Structures of N‐Benzoyl‐N′,N″‐bis(azetidinyl)phosphoric Triamide and N‐Benzoyl‐N′,N″‐bis(hexamethylenyl)phosphoric Triamide

Some new N‐carbonyl, phosphoramidates with formula C₆H₅C(O)N(H)P(O)R₂ (R = NC₃H₆ ( 1 ), NC₆H₁₂ ( 2 ), NHCH₂CH=CH₂ ( 3 ), N(C₃H₇)₂ ( 4 )) and CCl₃C(O)N(H)P(O)R′₂ (R′ = NC₃H₆ ( 5 ), NHCH₂CH=CH₂ ( 6 )) were synthesized and characterized by ¹H, ¹³C, ³¹P NMR and IR spectroscopy and elemental analysis. The structures were determined for compounds 1 and 2 . Compound 1 exists as two crystallographically independent molecules in crystal lattice. Both compounds 1 and 2 produced dimeric aggregates via intermolecular ‐P=O…H‐N‐ hydrogen bonds, which in compound 2 is a centrosymmetric dimer. In compounds with four‐membered ring amine groups, ³J(P,C)>²J(P,C), in agreement with our previous studies about five‐membered ring amine groups. Also, ³J(P,C) values in compounds 1 and 5 are greater than in compounds with five‐, six‐ and seven‐membered ring amine groups.     

On the Synthesis of 3-Acetyl-1-aryl-1,4,5,6-tetrahydro-1 H-1,2,4-triazepin-7-ones by Reaction of Nitrilimines with 3-Aminopropanoic Acid

Nitrilimines were prepared from N-arylhydrazono chlorides and reacted with -alanine yielding the corresponding amidrazones, which were treated with 1,1-carbonyldiimidazole in THF affording the hitherto unknown 3-acetyl-1-aryl-1,4,5,6-tetrahydro-1,2,4-triazepin-7-ones.     

An injectable chitosan-based hydrogel reinforced by oxidized nanocrystalline cellulose and mineral trioxide aggregate designed for tooth engineering applications

The complex anatomy of teeth limits the accessibility and efficacy of regenerative treatments. Therefore, the application of well-known inducers as injectable hydrogels for the regeneration of the dentin-pulp complex is considered a promising approach. In this regard, this study aimed to develop an injectable hydrogel containing mineral trioxide aggregate (MTA). The injectable chitosan/oxidized-nanocrystalline cellulose/MTA (CS/OCNC/MTA) hydrogels were prepared, and the physicochemical properties of these hydrogels were evaluated by TGA, FTIR, Rheological analysis, and SEM. Moreover, the effect of MTA on the swelling and degradability of scaffolds was assessed. The proliferative effects of synthesized hydrogels were also determined on human dental pulp stem cells (hDPSCs) by MTT assay. For induction of differentiation and biomineralization in these cells, the alkaline phosphatase activity and Alizarin Red S staining tests were performed in the presence of fabricated scaffolds. The proliferation of hDPSCs was significantly increased in the presence of these hydrogels. Moreover, the addition of MTA to hydrogel structure dramatically improved the differentiation of hDPSCs. These results suggested that this novel injectable hydrogel provides appropriate physiochemical properties and can be considered a promising scaffold for regenerative endodontic procedures.

Graphical abstract