Enhancing signal-to-noise ratio and resolution in low-field NMR relaxation measurements using post-acquisition digital filters

The traditional way to enhance signal-to-noise ratio (SNR) of nuclear magnetic resonance (NMR) signals is to increase the number of scans. However, this procedure increases the measuring time that can be prohibitive for some applications. Therefore, we have tested the use of several post-acquisition digital filters to enhance SNR up to one order of magnitude in time domain NMR (TD-NMR) relaxation measurements. The procedures were studied using continuous wave free precession (CWFP-T₁) signals, acquired with very low flip angles that contain six times more noise than the Carr–Purcell–Meiboom–Gill (CPMG) signal of the same sample and experimental time. Linear (LI) and logarithmic (LO) data compression, low-pass infinity impulse response (LP), Savitzky–Golay (SG), and wavelet transform (WA) post-acquisition filters enhanced the SNR of the CWFP-T₁ signals by at least six times. The best filters were LO, SG, and WA that have high enhancement in SNR without significant distortions in the ILT relaxation distribution data. Therefore, it was demonstrated that these post-acquisition digital filters could be a useful way to denoise CWFP-T₁, as well as CPMG noisy signals, and consequently reducing the experimental time. It was also demonstrated that filtered CWFP-T₁ method has the potential to be a rapid and nondestructive method to measure fat content in beef and certainly in other meat samples.     

Singlet versus triplet dynamics of β-carotene studied by quantum control spectroscopy

Biomolecules very often present complex energy deactivation networks with overlapping electronic absorption bands, making their study a difficult task. This can be especially true in transient absorption spectroscopy when signals from bleach, excited state absorption and stimulated emission contribute to the signal. However, quantum control spectroscopy can be used to discriminate specific electronic states of interest by applying specifically designed laser pulses. Recently, we have shown the control of energy flow in bacterial light-harvesting using shaped pump pulses in the visible and the selective population of pathways in carotenoids using an additional depletion pulse in the transient absorption technique. Here, we apply a closed-loop optimization approach to β-carotene using a spatial light modulator to decipher the energy flow network after a multiphoton excitation with a shaped ultrashort pulse in the near-IR. After excitation, two overlapping bands were detected and identified as the S₁ state and the first triplet state T₁. Using the transient absorption signal at a specific probe delay as feedback, the triplet signal could be optimized over the singlet contribution.     

Direction of magnetization and domain wall mobility in (Dy,Y)Fe2

Magnetization measurements in the (Dy _x Y_1−x )Fe₂ intermetallic compounds show evidence of blocking of domain wall motion. This effect is a function of concentrationx. The direction of magnetization is also dependent on the Dy concentration. We have used the Mossbauer spectroscopy of⁵⁷Fe to verify the direction of magnetization in the series as a function ofx and temperature. The results show that this change in easy direction occurs at higher temperatures than those where the blocking is detected through DC magnetization measurements. supported by RHAE/SCT.     

Immobilization of catalase on membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors

The immobilization of catalase on grafted membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors is described. The introduction of carboxylic acid groups onto a hydrophobic support provides a good environment for subsequent enzyme immobilization. This single membrane, hydrogen peroxide sensor showed significant improvement with respect to the double membrane versions. The response is very rapid, the linear range being from 10 μM up to 6 mM, with a detection limit of 4.7 μM, and a lifetime of more than 4 months.     

Extended X-ray absorption fine structure studies of thulium doped GaN epilayers

The local structure of Tm³⁺ ions incorporated into GaN epilayers was studied by means of Extended X-ray Absorption Fine Structure. The samples were doped either in situ during growth by Molecular Beam Epitaxy or by ion implantation of layers grown by Metal Organic Chemical Vapour Deposition. The implantation was done at ion energy of 300 keV and different nominal fluences of 3×10¹⁵, 4×10¹⁵ cm⁻² and 5×10¹⁵ cm⁻². The concentration of Tm in the samples studied was measured by Wavelength Dispersive X-ray analysis. For the in situ doped sample with concentration of 0.5%, and for all of the implanted samples, Tm was found on the Ga site in GaN. The ion implanted sample and an in situ doped sample with a similar concentration of Tm showed the same local structure, which suggests that the lattice site occupied by Tm does not depend on the doping method. When the average Tm concentration for in situ doped samples is increased to 1.2% and 2.0%, Tm is found to occupy the Ga substitutional site and the presence of a substantial number of Tm ions in the second coordination sphere indicates dopant clustering in the films. The formation of pure TmN clusters was found in an in situ doped sample with a dopant concentration of 3.4%.     

Scaling impacted structures

Summary The problem of non-scalability of structures under impact loads caused by strain-rate effects is solved in this article by properly correcting the impact velocity. The technique relies on the use of an alternative dimensionless basis, together with a mathematical model which allows the calculation of a correction factor for the impact velocity. This new velocity, when applied to the model, makes it to assure the satisfaction of the scaling laws. The indirect similitude method detailed here is applied to two strain-rate sensitive structures, a double plate under in-plane impact and a beam subjected to a blast load. The results show a very good agreement so that the model and a prototype made from strain rate sensitive materials behave the same.accepted for publication 3 March 2004     

Compositional Profiles in Silica-Based Sol-Gel Films Doped with Erbium and Silver, by RBS and ERDA

Photosensitive organic-titania hybrid materials have been prepared from metal alkoxides and various organic ester compounds with double bonds. The refractive index of the film increases with the decrease of the concentration of the organic ester compound, and the highest refractive index of 1.62 is obtained when 2-hydroxymethyl acrylate (HOA) is used as the organic ester and the molar ratio of HOA to Ti is 0.5. The material with the highest refractive index is exposed to femtosecond pulse using the multi-beam laser interference technique. After laser irradiation, the irradiated parts of the material are photopolymerized and periodic structures can be obtained by development of the unirradiated parts. In the case of laser irradiation of 120 J total energy for 5 min, the periodic structure obtained corresponds to 2D photonic crystal structure which is composed of two parts; the material with the highest refractive index and the air.     

Pretreatment of sugarcane bagasse hemicellulose hydrolysate for xylitol production byCandida guilliermondii

Applied Biochemistry and Biotechnology - In order to remove or reduce the concentrations of toxic substances present in the sugarcane bagasse hemicellulose hydrolysate for xyloseto-xylitol...