Molecular design of ambipolar redox-active molecules II: closed-shell systems

This mini-review highlights key structural features that should be taken into account when creating ambipolar redox-active closed-shell metal-free molecules. This type of compound is strongly required for the fabrication of all-organic ‘poleless’ batteries and semiconductors. The suggested strategies aimed at stabilization of both oxidized (cationic) and reduced (anionic) redox-states are based on the comprehensive analysis of the most successful structures taken from the recent publications.     

Enhancing signal-to-noise ratio and resolution in low-field NMR relaxation measurements using post-acquisition digital filters

The traditional way to enhance signal-to-noise ratio (SNR) of nuclear magnetic resonance (NMR) signals is to increase the number of scans. However, this procedure increases the measuring time that can be prohibitive for some applications. Therefore, we have tested the use of several post-acquisition digital filters to enhance SNR up to one order of magnitude in time domain NMR (TD-NMR) relaxation measurements. The procedures were studied using continuous wave free precession (CWFP-T₁) signals, acquired with very low flip angles that contain six times more noise than the Carr–Purcell–Meiboom–Gill (CPMG) signal of the same sample and experimental time. Linear (LI) and logarithmic (LO) data compression, low-pass infinity impulse response (LP), Savitzky–Golay (SG), and wavelet transform (WA) post-acquisition filters enhanced the SNR of the CWFP-T₁ signals by at least six times. The best filters were LO, SG, and WA that have high enhancement in SNR without significant distortions in the ILT relaxation distribution data. Therefore, it was demonstrated that these post-acquisition digital filters could be a useful way to denoise CWFP-T₁, as well as CPMG noisy signals, and consequently reducing the experimental time. It was also demonstrated that filtered CWFP-T₁ method has the potential to be a rapid and nondestructive method to measure fat content in beef and certainly in other meat samples.     

A Semiconductor Laser of the Visible Range as an Exciting Source of Raman Scattering

A possibility of application of semiconductor lasers of the visible range as exciting sources for Raman spectroscopy is studied. An experimental set-up for measuring Raman spectra of polycrystalline dielectrics and broad-gap semiconductors excited by a semiconductor laser with a wavelength of 640 nm was created. The conditions under which the spectral width of the lasing line of a semiconductor laser was within 10^-3 cm^-1 in the continuous mode with a power of 10 mW are realized. The characteristics of various types of exciting sources used in Raman spectroscopy are compared. The results of studies of the characteristic Raman spectra excited with a semiconductor laser in polycrystalline sulfur are presented.     

Synthesis and characterization of oxidized cellulose

Samples of oxidized cellulose (OC) with various carboxyl contents and degrees of crystallinity were obtained by the oxidation of native and mercerized cellulose with a solution of nitrogen(IV) oxide in CCl₄. A detailed characterization of these OC samples was performed. The effect of oxidation conditions (concentration of N₂O₄ in the solution and oxidation time) and starting cellulose material on OC characteristics (carboxyl, carbonyl and nitrogen content, degree of crystallinity and polymerization, surface area and swelling, and acidic properties) was investigated. Reactivity in the oxidation process was higher in mercerized cellulose than in native cellulose. The action of dilute solutions (10–15%) of N₂O₄ did not affect the degree of crystallinity of cellulose samples. Under these conditions, the oxidation took place mainly in amorphous regions and on the surface of crystallites. Oxidation in a concentrated (40%) N₂O₄ solution led to the destruction of crystallites, which increased the surface area and swelling of cellulose in water. The surface area and the swelling of OC samples increased with a decrease in the index of crystallinity. The acidic properties of OC were shown to increase with an increase of swelling in water. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4785–4791, 2004     

Contributions to the synthesis of some ferrocene-containing antibiotics

This Review discusses the synthesis and characterization by our Group of new antibiotics belonging to the class of penicillins, cephalosporins and rifamycins with ferrocenyl and 1, 1′-ferrocenilene residues in the molecule. As reactants for 6-aminopenicillanic acid (6-APA) and 7-aminocephalosporanic acid (7-ACA) the following were used: 1, 1-bis(chlorocarbonyl)ferrocene, ferrocenyl sulfochloride, 1, 1′-ferrocenylenedisulfochloride and thioglycolic acids S-modified with ferrocene. In the synthesis of rifamycins, the hydrazides of the thioglycolic acids, S-modified with ferrocene, were employed as nucleophilic agents. The synthesized intermediates were characterized by elemental analysis, TLC, IR, UV and ¹H NMR spectra. The characterization of new antibiotics was made by TLC, IR and UV spectral analysis. Biological activity was tested on Gram-negative and Gram-positive bacteria. Good activity is reported towards Gram-positive bacteria in the case of derivatives containing residues of thioglycolic acid S-modified with ferrocene, the antibacterial activity being similar to that of amoxicillin, carbenicillin and cephalothin. All compounds are inactive towards Gram-negative bacteria.     

Structure of fullerene-containing soot at different formation stages of arc discharge vaporization of graphite

Electron microscopy is used in a study of nanoclusters of the carbon soot deposited on a probe in different areas of arc discharge during graphite vaporization under conditions favorable for fullerene synthesis. It is found that the spatial network of soot nanoclusters consists of alternating regions of higher density or associates of carbon particles. Two types of nanoclusters have been identified with the correlation radii of the associates equal to 0.6–0.8 and 1.6–2.2 nm, respectively. Type I nanoclusters are dominant in the soot microparticles, and their structure shows practically no variations with increasing separation r of the soot collector from the discharge axis over the range of distances studied, r=1–9 cm. The effective radius R ₀ of the “elementary” particles making up the associates in the soot nanoclusters of Type I calculated with the use of scaling relationships is 0.15–0.17 nm and is close to the gas-kinetic radius of carbon atoms. Type II nanoclusters have been identified in soot collected at r>3 cm. Values of R ₀ calculated in this case are 0.6–0.9 nm and decrease with increasing r, which indicates the presence of fullerene molecules in these nanocluster associates.     

Kinetic features of ethylene polymerization over supported catalysts [2,6‐bis(imino)pyridyl iron dichloride/magnesium dichloride] with AlR3 as an activator

The effects of polymerization temperature, polymerization time, ethylene and hydrogen concentration, and effect of comonomers (hexene‐1, propylene) on the activity of supported catalyst of composition LFeCl₂/MgCl₂‐Al(i‐Bu)₃ (L = 2,6‐bis[1‐(2,6‐dimethylphenylimino)ethyl] pyridyl) and polymer characteristics (molecular weight (MW), molecular‐weight distribution (MWD), molecular structure) have been studied. Effective activation energy of ethylene polymerization over LFeCl₂/MgCl₂‐Al(i‐Bu)₃ has a value typical of supported Ziegler–Natta catalysts (11.9 kcal/mol). The polymerization reaction is of the first order with respect to monomer at the ethylene concentration >0.2 mol/L. Addition of small amounts of hydrogen (9–17%) significantly increases the activity; however, further increase in hydrogen concentration decreases the activity. The IRS and DSC analysis of PE indicates that catalyst LFeCl₂/MgCl₂‐Al(i‐Bu)₃ has a very low copolymerizing ability toward propylene and hexene‐1. MW and MWD of PE produced over these catalysts depend on the polymerization time, ethylene and hexene‐1 concentration. The activation effect of hydrogen and other kinetic features of ethylene polymerization over supported catalysts based on the Fe (II) complexes are discussed. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5057–5066, 2007     

Mercury removal from aqueous solution and flue gas by adsorption on activated carbon fibres

The use of two activated carbon fibres, one laboratorial sample prepared from a commercial acrylic textile fibre and one commercial sample of Kynol^®, as prepared/received and modified by reaction with powdered sulfur and H₂S gas in order to increase the sulfur content were studied for the removal of mercury from aqueous solution and from flue gases from a fluidized bed combustor. The sulfur introduced ranged from 1 to 6 wt.% depending on the method used. The most important parameter for the mercury uptake is the type of sulfur introduced rather than the total amount and it was found that the H₂S treatment of ACF leads to samples with the highest mercury uptake, despite the lower sulfur amount introduced. The modified samples by both methods can remove HgCl₂ from aqueous solutions at pH 6 within the range 290-710 mg/g (ACF) which can be favourably compared with other studies already published. The use of a filter made with an activated carbon fibre modified by powdered sulfur totally removed the mercury species present in the flue gases produced by combustion of fossil fuel.     

Renormalization Effects in the Spectrum of a Coherently Driven Exciton–Biexciton System

Starting from the total Hamiltonian of an excited exciton–biexciton system, nonresonant renormalizations in the electronic spectrum of a coherently driven direct semiconductor are considered. Stringent group-theoretical inclusion of the particle spin in the Hamiltonian allows one to account for the dependence of different renormalization effects on polarizations of the incident laser fields. On the example of circularly polarized driving and probing pulses it is shown that the kind of observed renormalization is defined by the pump-and-probe polarization geometry. Thus, the exciton optical Stark effect must appear in the case of co-circular pump-and-probe, whereas a mixing of the polariton and biexciton spectra is possible only in the case of counter-circular pump-and-probe. The polariton--biexciton dispersion renormalization may manifest itself as synchronous splittings of the exciton--polariton and biexciton spectra under resonant pumping at a frequency of the polariton--biexciton transition, or in their shifts in opposite directions under near-resonant pumping. The mechanisms of both kinds of renormalization effects are analyzed, and the dependence of their characteristics on the pump parameters and microscopic parameters of the exciton–biexciton–photon system is established. An evaluation of the characteristics shows that the effect of polariton–biexciton dispersion renormalization dominates in the spectra of semiconductors with stable biexciton formation. Results of the theoretical study provide an adequate explanation of available experimental data.