Stoichiometric and catalytic oxygen activation by trimesityliridium(III)

Trimesityliridium(III) (mesityl = 2,4,6-trimethylphenyl) reacts with O(2) to form oxotrimesityliridium(V), (mes)(3)Ir=O, in a reaction that is cleanly second order in iridium. In contrast to initial reports by Wilkinson, there is no evidence for substantial accumulation of an intermediate in this reaction. The oxo complex (mes)(3)Ir=O oxidizes triphenylphosphine to triphenylphosphine oxide in a second-order reaction with DeltaH++ = 10.04 +/- 0.16 kcal/mol and DeltaS++ = -21.6 +/- 0.5 cal/(mol.K) in 1,2-dichloroethane. Triphenylarsine is also oxidized, though over an order of magnitude more slowly. Ir(mes)(3) binds PPh(3) reversibly (K(assoc) = 84 +/- 3 M(-1) in toluene at 20 degrees C) to form an unsymmetrical, sawhorse-shaped four-coordinate complex, whose temperature-dependent NMR spectra reveal a variety of dynamic processes. Oxygen atom transfer from (mes)(3)Ir=O and dioxygen activation by (mes)(3)Ir can be combined to allow catalytic aerobic oxidations of triphenylphosphine at room temperature and atmospheric pressure with overall activity (approximately 60 turnovers/h) comparable to the fastest reported catalysts. A kinetic model that uses the rates measured for dioxygen activation, atom transfer, and phosphine binding describes the observed catalytic behavior well. Oxotrimesityliridium does not react with sulfides, sulfoxides, alcohols, or alkenes, apparently for kinetic reasons.     

Palladium-doped polyimides: An X-ray photoelectron study

Five polyimide films prepared from 3,3′,4,4′-benzophenone tetracarboxylic acid'dianhydride (BTDA) and diamines, 4,4′-oxydianiline (ODA), 3,3′-diaminobenzophenone (DABP), or 3,3′-diaminodiphenylcarbinol (DADPC) and doped with Li₂PdCl₄ (LTP) or Pd[(CH₃)₂S]₂Cl₂ (PDS) were selected for a detailed x-ray photoelectron spectroscopic (XPS) study to determine the oxidation state of palladium and the relative distribution of this and other elements in these films, especially as they relate to electrical resistivity. XPS shows that Pd in the films is present as a mixture of zero and +2 valence states. Films that contain lithium as part of the dopant all show that metal is present as Li⁺ and Li₂O, a fact that may have a bearing on film electrical properties. An Auger electron spectroscopic (AES) or XPS profiling was performed on two of the electrically conductive films. A film doped with PDS reveals a majority of palladium at the surface as Pd(0) and much smaller amounts in film bulk as a mixture of Pd(0) and Pd(II). Film behavior is similar to a metal-vapor deposited film. An LTP doped film, by contrast, exhibits a homogeneous composition with a mixture of Pd(0) and Pd(II). These studies support others that use chemical etching on the film surfaces. Scanning electron microscopy (SEM) has been used to provide surface evaluations.     

Quantification of hydroxycarbonyls from OH-isoprene reactions

Hydroxycarbonyls arising from OH-initiated reactions of isoprene have been quantified by the technique of a flow reactor coupled to proton-transfer reaction mass spectrometry (PTR-MS) detection. The yields of C5- and C4-hydroxycarbonyls are (19.3 +/- 6.1)% and (3.3 +/- 1.6)%, respectively, measured at a flow tube pressure of about 100 Torr and at a temperature of 298 +/- 2 K. A yield of (8.4 +/- 2.4)% is obtained for the unsaturated carbonyl C5H8O, confirming that internal OH addition represents the minor channel in the initial OH-isoprene reaction. The results show that those carbonyl compounds account for the most previously unquantified carbon, enabling the isoprene carbon closure. The study also reveals novel aspects of the delta-hydroxyalkoxy radical degradation mechanism, which is essential for modeling tropospheric O3 formation. In addition, this work demonstrates the application of PTR-MS for quantification of products of hydrocarbon reactions, which should have profound impacts on elucidation of the chemistry of atmospheric anthropogenic and biogenic hydrocarbons.     

Über einige Derivate des Isochinolins

Ohne Zusammenfassung     

Über 2-Benzoylfluoren und Über Reten

Ohne ZusammenfassungIch habe in meiner frÜheren Abhandlung Über das Benzoylfluoren die Zählung irrtÜmlicherweise mit dem der Methylengruppe benachbarten Kohlenstoffatom begonnen. Der Irrtum kam dadurch zustande, da\ Beilstein die von Gräbe aus Diphensäure dargestellte, nach der neuen Nomenklatur als Fluorenoncarbonsäure (4) zu bezeichnende Säure mit der Ziffer (5) versieht.Mit dem Studium dieser Frage bin ich gegenwärtig beschäftigt, weshalb ich das Ersuchen stelle, mir fÜr die nächste Zeit das bezÜgliche Arbeitsgebiet zu Überlassen.