快中子照相模拟分析与实验验证

首次系统地推导出快中子照相像素值形成解析式, 建立图像反差不等式, 并利用该不等式首次对图像对比度与源强、照射时间和散射之间的关系进行说明. 并在像素值解析式基础上编制快中子照相模拟程序, 利用该程序对空间分辨率和图像对比度进行模拟, 并与实验对照, 研究结果表明空间分辨率模拟效果好于实验, 图像对比度模拟效果与实验相当. 最后通过对狭缝、方孔以及多材质组成的复杂样品模拟并与实验对照, 结果显示模拟效果与实验照片在反差灵敏度效果上非常一致, 该模拟计算方法可为实验设计和工程应用提供参考.     

Be(d,n)反应中子源能谱测量及应用

 利用中子飞行时间技术和BC501A液体闪烁探测器的粒子分辨特性,测量了0°方向、20 MeV氘束轰击厚金属铍靶反应产生的中子源能谱,测量的中子能谱范围为0.7～25.0 MeV。在60°方向放置芪晶体闪烁探测器,由刻度好的BC501A液体闪烁探测器归一校正后,用于中子源强度监测。利用Be(d, n) 反应中子源,采用单粒子灵敏度标定方法,实验标定了0.75~15.75 MeV能量范围内的薄膜闪烁探测器中子能量响应曲线,实验结果与蒙特卡罗模拟计算结果在8%的不确定度范围内一致。     

氘氚源中子穿过聚乙烯样品泄漏中子谱的测量与模拟

采用飞行时间技术测量了氘氚（D-T）源中子穿过不同厚度板状聚乙烯样品后40°方向的泄漏中子时间到达谱,样品的长和宽均为100 cm, 厚度分别为4.5, 9, 18和27 cm。 本底谱测量采用了无样本底测量和无样堵孔本底测量2种方案, 利用MCNP-4C程序模拟了相同实验条件下的泄漏中子时间到达谱, 模拟过程中考虑了源中子的能谱与角分布、脉冲中子束宽度、 探测器的效率以及样品的有效面积。通过比较发现, 采用无样测量谱作为本底时,计算值/实验值（C/E）值大于1, 并且随着样品厚度的增加而偏离1;而本底谱采用无样堵孔测量谱时, C/E小于1, 并且随着样品厚度的增加而接近1。通过对两套本底谱的分析, 并结合蒙特卡罗模拟, 计算求得了相应样品厚度下比较接近实际的本底谱,采用该模拟计算本底谱后,C/E值有了明显的改善。The neutron leakage spectrum were measured at 40° by time of flight method for polyethylene slabs with the thicknesses of 4.5, 9,18 and 27 cm,respectively. The experimental results were compared with the MCNP-4C simulations, which carefully considered many effects, such as the angle and energy distributions of the source neutrons,the width of the beam pulse,the detection efficiency and the effective measured area. The sample out and collimator filled spectra were measured as the background, and the results showed that C/E values were larger than 1 when using the sample out background spectra,but smaller than 1 when using the collimator filled background spectra. Combine these two different background spectra, a new method was used to calculate the background spectrum,and the results have a better agreement with the simulations.     

Measurement of the neutron spectrum of a Pu-C source with a liquid scintillator

The neutron response function for a BC501A liquid scintillator （LS） has been measured using a series of monoenergetic neutrons produced by the p-T reaction. The proton energies were chosen such as to produce neutrons in the energy range of 1 to 20 MeV. The principles of the technique of unfolding a neutron energy spectrum by using the measured neutron response function and the measured Pulse Height （PH） spectrum is briefly described. The PH spectrum of neutrons from the Pu-C source, which will be used for the calibration of the reactor antineutrino detectors for the Daya Bay neutrino experiment, was measured and analyzed to get the neutron energy spectrum. Simultaneously the neutron energy spectrum of an Am-Be source was measured and compared with other measurements as a check of the result for the Pu-C source. Finally, an error analysis and a discussion of the results are given.     

Measurement of the response function and the detection effciency of an organic liquid scintillator for neutrons between 1 and 30 MeV

The light output function of a φ50.8 mm×50.8 mm BC501A scintillation detector was measured in the neutron energy region of 1 to 30 MeV by fitting the pulse height （PH） spectra for neutrons with the simulations from the NRESP code at the edge range. Using the new light output function, the neutron detection effciency was determined with two Monte-Carlo codes, NEFF and SCINFUL. The calculated effciency was corrected by comparing the simulated PH spectra with the measured ones. The determined effciency was verified at the near threshold region and normalized with a Proton-Recoil-Telescope （PRT） at the 8-14 MeV energy region.     

Measurements of the light output functions of plastic scintillator using 9Be（d,n）10B reaction neutron source

The light output functions for protons of ST-401 and BC-408 plastic scintillators were measured using white neutron source produced by the 9Be（d,n） 10B reaction at the HI-13 Tandem Accelerator at China Institute of Atomic Energy（CIAE）.The LOFs of plastic scintillators for protons in the energy range of 0.5-16.5 MeV were obtained by the time-of-flight（TOF） technique and an iterative procedure.Two parameters（kB and C） were deduced by fitting the experimental data.     

（n,xnγ）反应截面测量的实验本底改进研究

瞬发γ射线法测量（n,xnγ）反应截面实验中,在线的实验本底对测量结果影响显著,是影响测量结果的关键因素。为了达到降低在线实验本底一个量级的目标,通过蒙特卡罗模拟程序给出了屏蔽体和准直器的改进方案,最终选取的屏蔽方案:在原有屏蔽体上加厚30 cm（C₂H₄）n+9 cmPb,原屏蔽墙加厚54 cm重混凝土,再在屏蔽体和屏蔽墙上共同加厚2 cm厚的铅（Pb）;准直孔开孔形状在圆柱形、圆锥形和对称双锥形这三种方案中准直效果和能量单一性方面对称双锥形准直孔最好。在屏蔽体改造完成后,利用尺寸为φ5.08cm×5.08 cm型液体闪烁体探测器（BC501）测量了改造后距准直孔右方径向距离70 cm处透射出来的中子和γ射线的相对强度,在扣除无束流天然本底后,有束流的中子本底降低了7.75倍,γ本底降低了38.5倍,改造效果达到了测量要求。In the experiment of measuring (n,xnγ) reaction cross section with prompt γ ray method, the experiment background has a significant influence on the result and is the key factor. In order to achieve the goal of reducing a certain amount of the experiment background, the improvement scheme of shield and collimator was given through Monte Carlo method and the shielding scheme was finally selected: add 30 cm(C₂H₄)n+9 cm Pb on the original shield, 54 cm heavy concrete on the original shield wall and then 2 cm thick lead(Pb) on the shield and shield wall. The collimation effect and energy uniformity of symmetrical double cone collimation hole are the best among cylindrical, conical, and symmetrical double cone. After the completion of the transformation of shield, the relative intensities of the transmitted neutron and γ rays from the 70 cm in right radial of the transformed collimation hole were measured with ?5.08 cm×5.08 cm type liquid scintillator detector(BC501). After deducting the natural background of no beam current, the neutron background of the beam current is reduced by 7.75 times and the γ background is reduced by 38.5 times, which meets the requirement.     

中子与9Be和6,7Li反应的次级中子发射谱实验研究

测量了8.17MeV与10.27MeV中子与⁹Be和^6,7Li作用的次级中子双微分截面. 对于10.27MeV, 为了消除从D(d,np)破裂反应来的源破裂中子对双微分截面测量结果的影响, 采用了常规多探测器快中子飞行时间谱仪和非常规多探测器快中子飞行时间谱仪相结合的办法. 用Monte-Carlo方法对实验测量得到的飞行时间谱进行了详细的模拟, 通过测量谱与模拟谱的比较, 得到了实验测量的次级中子双微分截面. 实验测量结果以n-p(常规谱仪)和n-C(非常规谱仪)弹性散射微分截面作为归一. 测量结果与评价数据以及其他测量数据进行了比较. 用一个基于Hauser-Feshbach和激子模型的轻核核反应理论模型对^6,7Li的次级中子双微分截面进行了计算, 理论计算结果与实验结果符合得较好.     

新型丙烯酸共聚物的合成与表征

以生物试剂磷酸烯醇式丙酮酸钾（PEPK）、丙烯酸（AA）为聚合单体,采用Na2S2O8-Na2S2O5氧化还原引发体系进行温和的水溶液聚合反应,通过平行合成得到了a、b、c 3个系列的PEPK-AA共聚物。通过红外光谱（FT-IR）、核磁共振（13C-NMR）以及共聚物分子量的测定,表征了PEPK-AA共聚物的化学结构...     

8.19 MeV中子与9Be作用的次级中子双微分截面测量

用中国原子能科学研究院HI13串列加速器上的多探测器快中子飞行时间谱仪, 测量了8.19 MeV中子与9Be作用时, 从20°到160°区间26个角度的次级中子双微分截面。测量截面以np散射截面作为标准进行归一。实验结果用Monte Carlo方法进行了中子注量率衰减、多次散射和有限几何修正, 并用MCNP4C程序对所用的Monte Carlo程序进行了验证。测量结果与评价数据以及其它实验室的数据进行了比较。The secondary neutron emission double differential cross section of 9Be induced by 8.19 MeV neutron was measured at 26 different angles from 20°to 150°by using the multi detector fast neutron TOF spectrometer at the HI 13 Tandem Accelerator at China Institute of Atomic Energy(CIAE). The results were normalized to np scattering measurement. A special Monte Carlo code which was validated with the MCNP 4C code was employed to analyze the measured data for the corrections of neutron flux attenuation, multiple scattering and finite geometry. The measured results were compared with the evaluated data and the other measurements. 