Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

Structural developments in synthetic rubbers during uniaxial deformation by in situ synchrotron X‐ray diffraction

The molecular orientation and strain‐induced crystallization of synthetic rubbers—polyisoprene rubber, polybutadiene rubber, and butyl rubber [poly(isobutylene isoprene)]—during uniaxial deformation were studied with in situ synchrotron wide‐angle X‐ray diffraction. The high intensity of the synchrotron X‐rays and the new data analysis method made it possible to estimate the mass fractions of the strain‐induced crystals and amorphous chain segments in both the oriented and unoriented states. Contrary to the conventional concept, the majority of the molecules (50–75%) remained in an unoriented amorphous state at high strains. Each synthetic rubber showed a different behavior of strain‐induced crystallization and molecular orientation during extension and retraction. Our results confirmed the occurence of strain‐induced networks in the synthetic rubbers due to the inhomogeneity of the crosslink distribution. The strain‐induced networks containing microfibrillar crystals and oriented amorphous tie chains were responsible for the ultimate mechanical properties. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 956–964, 2004     

Improved detectability with a polymer-based trapping device in rapid HPLC analysis for ultra-low levels of bisphenol A (BPA) in environmental samples.

A new high-performance liquid chromatography (HPLC) method has been developed to detect ultra-low concentrations of bisphenol-A (BPA) (below 1 ng/L (ppt)) using column switching electrochemical detection (ECD). The results were superior to those obtained from manual pretreatment procedure with membrane stationary phase. BPA is inherently ubiquitous in the environment, including tools and solvents used for its analysis; to obtain meaningful results, therefore, the concentration of the overall BPA contamination must be below the detection limit for BPA using the analytical system. Therefore, purified water for preparing the standard BPA solution must be filtered with a hydrophobic membrane to suppress BPA background levels of contamination. In addition, we investigated methods for effectively preserving environmental water containing BPA. The addition of a small amount of ethylenediaminetetraacetic acid (EDTA) provided good recovery even after overnight storage. By employing these precautionary measures and procedures to reduce BPA contamination from the analytical procedure, we could accurately determine l(-10) ppt of BPA in environmental water samples using a column switching HPLC system.     

Influence of nuclear reactor accident at Chernobyl' on the environmental radioactivity in Toyama

The environmental radioactivity caused by the reactor accident at Chernobyl' was investigated from May 7 to May 31 of 1986 in Toyama. Measurement of radioactivities in airborne particles, rain water, drinking water, milk, and mugwort are carried out by gamma-ray spectrometry (pure Ge detector; ORTEC GMX-23195). Ten different nuclides (103Ru, 106Ru, 131I, 132Te-I, 134Cs, 136Cs, 137Cs, 140Ba-La) are identified from samples of airborne particles. In the air samples, a maximum radioactivity concentration of each nuclide is observed on 13th May 1986. The time of the reactor shut-down and the flux of thermal neutron at the reactor were calculated from 131I/132I and 137Cs/134Cs ratio. The exposure dose in Toyama by this accident is given as follows: internal exposure; [thyroid] adult-59 microSv, child-140 microSv, baby-130 microSv, [total body] adult-0.2 microSv, child, baby-0.4 microSv, external exposure; 7 microSv, effective dose equivalent; adult-9 microSv, child-12 Sv, baby-11 microSv.     

Electrical conductance of solutions of lithium nitrate in 1,3-diaminopropane

Electrical conductances and densities of the LiNO₃-1,3-diaminopropane system have been measured as a function of composition and temperature. The results suggest that the solvent molecules may act as bridges between Li⁺ ions at higher concentration of LiNO₃.     

Self-assembled DNA-conjugated polymer for novel DNA chip.

We developed DNA-conjugated polymer for DNA chip fabrication. A 30 mer probe DNA and disulfide bridges were covalently attached to the polymer side chain. The DNA-conjugated polymer can be specifically adsorbed on a gold substrate surface by a self-assembly technique. The interaction between fully matched DNA and DNA-conjugated polymer was investigated by surface plasmon resonance (SPR) technique. The DNA-conjugated polymer-modified gold surface highly recognized fully matched DNA, rather than unmatched DNA. Therefore, DNA-conjugated polymer can be used for novel DNA chip fabrication.     

Synthesis of 5-heteroarylazulenes: first selective electrophilic substitution at the 5-position of azulene

1,3-Di-tert-butylazulene reacted with highly electrophilic trifluoromethanesulfonate of N-containing heterocycles to give 5-(dihydroheteroaryl)azulene derivatives in good yield and treatment of the 5-(dihydroheteroaryl)azulene derivatives with KOH afforded 5-(heteroaryl)azulenes in excellent yield.