Structural and morphological investigation of ceria-promoted Al(2)O(3) under severe reducing/oxidizing conditions

A series of CeO(2)/Al(2)O(3) samples with different ceria loadings in the range 0-25 wt % (0, 2, 5, 7.5, 15, and 25%) were prepared by incipient wetness and studied using several complementary techniques such as Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD), temperature-programmed reduction (TPR), Raman, high-resolution transmission electron microscopy (HRTEM), and extended X-ray absorption fine structure (EXAFS). The aim of the investigation was to understand the behavior of ceria when deposited on alumina and treated under oxidizing and reducing conditions at high temperature (T >/= 1273 K). It is shown that ceria can partially stabilize alumina toward the formation of low-surface-area phases up to 1373 K under oxidizing conditions, while enhanced stabilization is observed under reducing conditions, being effective up to 1473 K. A detailed quantitative temperature-programmed reduction (TPR) analysis made at different loadings and calcination temperatures allowed us to identify three characteristic regions where the reduction of small and large ceria crystallites occurs with the formation of CeAlO(3) crystallites at high temperature. These are likely responsible for surface-area stabilization. For dispersed ceria samples, reduction takes place almost exclusively at low temperature (<700 K), while a shift to higher temperatures is observed upon increasing the ceria particle size. A fraction of Ce, in samples at low loadings, is stable in the lower oxidation state, even if subjected to strongly oxidizing conditions.     

On the solvability of one boundary value problem for one class of higher-order semilinear hyperbolic systems

Lithuanian Mathematical Journal - In this paper, we consider the boundary value problem for one class of higher-order semilinear hyperbolic systems. We prove the theorems on the existence,...     

Raman Spectroscopic Investigation of the Stress State in Silicon Substrates near Edges of Pt/PZT Microstructures

Hydrostatic stresses in Si substrates near edges of Pt/PZT microstructures used in pyrosensor fabrication have been predicted theoretically by finite element (FE) calculations. Within the absorption limited depth zone from which Raman radiation can be detected the substrate stress varies considerably. The characteristic lateral length scale of the average stress profile perpendicular to the film edges is less than 50 μm resulting from contributions of different depth. These stresses could be measured by spatially resolved Raman spectroscopy with an accuracy of 1‐2 μm.The values of the film stress of Pt and PZT have been estimated by fitting the FE models to the measured curves of the stress distribution in the Si substrate.     

Pump−probe experiments at the TEMPO beamline using the low‐α operation mode of Synchrotron SOLEIL

The SOLEIL synchrotron radiation source is regularly operated in special filling modes dedicated to pump–probe experiments. Among others, the low‐α mode operation is characterized by shorter pulse duration and represents the natural bridge between 50 ps synchrotron pulses and femtosecond experiments. Here, the capabilities in low‐α mode of the experimental set‐ups developed at the TEMPO beamline to perform pump–probe experiments with soft X‐rays based on photoelectron or photon detection are presented. A 282 kHz repetition‐rate femtosecond laser is synchronized with the synchrotron radiation time structure to induce fast electronic and/or magnetic excitations. Detection is performed using a two‐dimensional space resolution plus time resolution detector based on microchannel plates equipped with a delay line. Results of time‐resolved photoelectron spectroscopy, circular dichroism and magnetic scattering experiments are reported, and their respective advantages and limitations in the framework of high‐time‐resolution pump–probe experiments compared and discussed.     

One nonlocal problem in time for a semilinear multidimensional wave equation

We consider a nonlocal problem in time for semilinear multidimensional wave equations and prove theorems on existence, uniqueness, and nonexistence of solutions.     

Universality properties of Walsh–Fourier series

It is shown that Walsh–Fourier series of \(W\) -continuous functions can have maximal sets of limit functions on small subsets of the unit interval.     

Surface-enhanced Raman spectroscopy of blood plasma and serum using Ag and Au nanoparticles: a systematic study

Surface-enhanced Raman spectroscopy (SERS) is a good candidate for the development of fast and easy-to-use diagnostic tools, possibly used on biofluids in point-of-care or screening tests. In particular, label-free SERS spectra of blood serum and plasma, two biofluids widely used in diagnostics, could be used as a metabolic fingerprinting approach for biomarker discovery. This study aims at a systematic evaluation of SERS spectra of blood serum and plasma, using various Ag and Au aqueous colloids, as SERS substrates, in combination with three excitation lasers of different wavelengths, ranging from the visible to the near-infrared. The analysis of the SERS spectra collected from 20 healthy subjects under a variety of experimental conditions revealed that intense and repeatable spectra are quickly obtained only if proteins are filtered out from samples, and an excitation in the near-infrared is used in combination with Ag colloids. Moreover, common plasma anticoagulants such as EDTA and citrate are found to interfere with SERS spectra; accordingly, filtered serum or heparin plasma are the samples of choice, having identical SERS spectra. Most bands observed in SERS spectra of these biofluids are assigned to uric acid, a metabolite whose blood concentration depends on factors such as sex, age, therapeutic treatments, and various pathological conditions, suggesting that, even when the right experimental conditions are chosen, great care must be taken in designing studies with the purpose of developing diagnostic tests.