Fast and efficient preparation of Baylis-Hillman-derived (E)-allylic azides and related compounds in aqueous medium

A practical access to alkyl- and aryl-substituted (E)-2-(azidomethyl)alkenoates and related azido compounds from the corresponding allylic bromides in aqueous acetone is described. An alternative method to obtain the starting bromides based on heterogeneous catalysis under mild conditions was also investigated.     

A recursive-faulting model of distributed damage in confined brittle materials

We develop a model of distributed damage in brittle materials deforming in triaxial compression based on the explicit construction of special microstructures obtained by recursive faulting. The model aims to predict the effective or macroscopic behavior of the material from its elastic and fracture properties; and to predict the microstructures underlying the microscopic behavior. The model accounts for the elasticity of the matrix, fault nucleation and the cohesive and frictional behavior of the faults. We analyze the resulting quasistatic boundary value problem and determine the relaxation of the potential energy, which describes the macroscopic material behavior averaged over all possible fine-scale structures. Finally, we present numerical calculations of the dynamic multi-axial compression experiments on sintered aluminum nitride of Chen and Ravichandran [1994. Dynamic compressive behavior of ceramics under lateral confinement. J. Phys. IV 4, 177-182; 1996a. Static and dynamic compressive behavior of aluminum nitride under moderate confinement. J. Am. Soc. Ceramics 79(3), 579-584; 1996b. An experimental technique for imposing dynamic multiaxial compression with mechanical confinement. Exp. Mech. 36(2), 155-158; 2000. Failure mode transition in ceramics under dynamic multiaxial compression. Int. J. Fracture 101, 141-159]. The model correctly predicts the general trends regarding the observed damage patterns; and the brittle-to-ductile transition resulting under increasing confinement.     

A novel strategy to verification of adulteration in alcoholic beverages based on Schlieren effect measurements and chemometric techniques

A novel strategy to evaluation of adulteration in alcoholic beverages based on the measurement of the Schlieren effect using an automated FIA system with photometric detection is proposed. The assay is based on the Schlieren effect produced when beverage samples are injected in a single-line FIA system that uses water as carrier stream and a light-emitting diode-phototransistor photometer controlled by microcomputer as detector. The flow system presents limited mixing conditions which make possible to create gradients of refractive index (Schlieren effect) in the injected sample zone. These gradients are reproducible, characteristic of each alcoholic beverage and undergo specific modifications when adulterations with water or ethanol are imposed. Schlieren effect data of brandies, cachaças, rums, whiskies and vodkas were treated by SIMCA to elaborate class models applied in the evaluation of alcoholic beverages adulteration. Samples of the original matrix of each sort of beverages were adulterated in laboratory by adding water, methanol and ethanol in levels of 5% and 10% (v/v). These samples were used as test set to validate SIMCA class models. The verification of authenticity using Schlieren effect measurements presented good results making possible to identify 100% of the beverages samples adulterated in laboratory and 93% of the actual adulterated alcoholic beverages with confidence levels of 95%. As principal advantage, the automated system does not use reagents to carry out the analysis.     

Convergence analysis of time-point relaxation iterates for linear systems of differential equations

We study convergence properties of time-point relaxation (TR) Runge-Kutta methods for linear systems of ordinary differential equations. TR methods are implemented by decoupling systems in Gauss-Jacobi, Gauss-Seidel and successive overrelaxation modes (continuous-time iterations) and then solving the resulting subsystems by means of continuous extensions of Runge-Kutta (CRK) methods (discretized iterations). By iterating to convergence, these methods tend to the same limit called diagonally split Runge-Kutta (DSRK) method. We prove that TR methods are equivalent to decouple in the same modes the linear algebraic system obtained by applying DSRK limit method. This issue allows us to study the convergence of TR methods by using standard principles of convergence of iterative methods for linear algebraic systems. For a particular problem regions of convergence are plotted.     

Modification of surface properties of electrospun polyamide nanofibers by means of a perfluorinated acridine

Polyamide 6 (PA6) nanofibers were prepared from formic acid solutions by using electrospinning technique. The fibers were smooth, defects free and with diameters smaller than 200 nm. Small amounts of a perfluorinated acridine were added as dopant to the feed solution to modify the wettability of the fibers. The effect of doping on the contact angle values is well apparent. The contact angle values go from 50° of pure PA6 to 120° when 6% of acridine is added. A comparison between fibers and films of pure and doped polyamide 6 was carried out in order to determine the effect of morphology on wettability. Thermal annealing near the T_g of the polymer promoted the segregation of the molecules to the surface, reaching contact angles of 131° with smaller amounts (4%) of acridine. The surface segregation was also promoted by time aging.     

Synthesis of 2-amino-3-hydroxy- and of 2,3-diamino-3H-1,4-benzodiazepines

A new synthesis of 7-chloro-2,3-diamino-5-phenyl-3H-1,4-benzodiazepines is described, which allows for the preparation of compounds bearing the same or different substituents at the 2 and 3 positions, starting from 2-amino-7-chloro-3-hydroxy-5-phenyl-3H-1,4-benzodiazepines.     

FTIR and WAXS analysis of periodate oxycellulose: Evidence for a cluster mechanism of oxidation

Cellulose paper (Whatman no.1, chromatographic grade) was oxidised with 0.1 M sodium metaperiodate at different oxidation levels (0–11 days at room temperature), and analysed with FTIR before and after chemical treatments (reduction, further oxidation, alkaline hydrolysis). The deconvolution of infrared data allowed us to verify that periodate oxidises cellulose in isolated domains, leading to the decrease of crystallinity, in agreement with the results of wide angle X-ray scattering (WAXS). In particular, the alkaline hydrolysis (β-alkoxy fragmentation) followed by mild acid treatment removed the oxidised groups and recovered most of the crystallinity of cellulose, as determined by the FTIR crystallinity index.     

Olive mill wastewater treatment by a pilot-scale subsurface horizontal flow (SSF-h) constructed wetland

Performances of a pilot-scale reed bed for the olive mill wastewater (OMW) treatment were investigated, by monitoring influent and effluent pH, total suspended solids (TSS), chemical oxygen demand (COD), total Kjeldahl nitrogen (TKN), total phosphorus and polyphenols. In order to reduce the suspended matter concentration and to avoid clogging, OMW was pre-treated by adding lime putty, calcium hydroxide and hydraulic lime. The best results were obtained with 2 g/L of hydraulic lime. Pre-treated OMW was dosed in the reed bed at dilution ratios of 1/3 and 1/10 (v/v), pointing up that the latter only did not give rise to reed suffering and allowed to obtain good and durable removal efficiencies, above all for COD (74.1+/-17.6%) and polyphenols (83.4+/-17.8%). Recycling of the effluent was quite effective for the improvement of the wastewater quality, allowing a further removal of 26-70%, depending on the parameter taken into account. A post-dosage study, carried out by feeding the reed bed with the effluent of an activated sludge plant, pointed up a rapid decreasing of the outlet concentrations of the investigated parameters to values compatible with Italian regulations concerning wastewater discharge in surface water. Polyphenols were the exception, being their outlet concentration at the end of post-dosage study around 2 mg/L.     

A new apparatus for the extraction of organic compounds from aqueous solutions

A new apparatus for the extraction of organic compounds from sea water is described. With this apparatus it is possible to extract 54 standard compounds with high recovery percentages from 9 1 of sea water with 3 ml ofn-hexane. The analysis time (about 1 h) is appreciably lower than those of the extraction methods based on RP-18 and Carbopack-B adsorption (about 15 h). Furthermore, it is possible to analyze samples without filtration. An application of this method to the analysis of Tirreno sea water is reported.     

Synthesis of Glycosylrifamycins,a new type of semisynthetic rifamycins

Glycosylrifamycins, a new type of semisynthetic rifamycin derivatives, can be easily obtained by reaction of 3-(2-aminoethylthio)rifamycin SV ( 2 ) with a glycosyl compound carrying a coupling group, such as isothicyanate or carboxy. We prepared O-acetylated and free glucopyranosyl and arabinopyranosyl derivatives of rifamycin S and SV (see 3–10 ). Additionally, derivatives with D -saccharo-1,4-lactone and with shikimic acid were obtained (see 11–15 ). Glycosylrifamycins show an interesting inhibitory power on Gram-positive bacteria (Table).