Random Copolymers of 1,5-Dioxepan-2-one

ABSTRACT

Copolymers of 1,5-dioxepan-2-one (DXO) and e-caprolactone (?-CL), δ-valerolactone (δ-VL) or L-lactide (LLA) have been synthesized and characterized. High molecular weight copolymers were obtained using stannous-2-ethyl hexanoate as catalyst in bulk. Reactivity ratios for the copolymerization of DXO and δ-VL were determined at 110°C as r_VL=0.5 and r_DXO=2.3. At high conversion, depolymerization of δ-VL occurred, resulting in lower molecular weight and variations in the copolymer composition.

Physical properties, such as crystallinity and melting temperature of the DXO-copolymers proved to be strongly dependent on the choice of comonomer and on the molar composition of the copolymers. DXO appears to be incorporated into the poly-?-caprolactone (PCL) crystals and to some extent into the poly-δ-valerolactone (PVL) crystals, resulting in a more gradual decrease in crystallinity with increasing amount of DXO.     

Secondary ion yields produced by keV atomic and polyatomic ion impacts on a self-assembled monolayer surface

A suite of keV polyatomic or 'cluster' projectiles was used to bombard unoxidized and oxidized self-assembled monolayer surfaces. Negative secondary ion yields, collected at the limit of single ion impacts, were measured and compared for both molecular and fragment ions. In contrast to targets that are orders of magnitude thicker than the penetration range of the primary ions, secondary ion yields from polyatomic projectile impacts on self-assembled monolayers show little to no enhancement when compared with monatomic projectiles at the same velocity. This unusual trend is most likely due to the structural arrangement and bonding characteristics of the monolayer molecules with the Au(111). Copyright 1999 John Wiley & Sons, Ltd.     

Fusion around the barrier for 7Li+12C

Fusion cross-sections for the ⁷Li + ¹²C reaction have been measured at energies above the Coulomb barrier by the direct detection of evaporation residues. The heavy evaporation residues with energies below 3 MeV could not be separated out from the α-particles in the spectrum and hence their contribution was estimated using statistical model calculations. The present work indicates that suppression of fusion cross-sections due to the breakup of ⁷Li may not be significant for ⁷Li + ¹²C reaction at energies around the barrier.     

Kinetics and energetics of phosphate sorption in a multi-component Al(III)-Fe(III) hydr(oxide) sorbent system

Multi-component Al-Fe hydr(oxides) are ubiquituous in soil and aquatic environments, where they exhibit biogeochemical controls on nutrients and contaminants. Although, sorption on single-component Al and Fe hydr(oxides) have been extensively studied, limited studies have been done on their multi-component counterparts. In this study, effects of Al/Fe content on the kinetics and energetics of phosphate sorption in a poorly-crystalline co-precipitated mixed Al-Fe hydr(oxide) system were investigated using a combination of traditional batch techniques and flow adsorption calorimetry. Differences in Al/Fe content was found to influence the structural development and anion exchange capacity of the hydr(oxides) and subsequently their phosphate sorption characteristics. Higher structural development decreased phosphate sorption, while higher AEC was associated with increased phosphate sorption, initial sorption rate, and smaller losses in sorption with increasing pH. Results from flow adsorption calorimetry indicated that at pH 4.8 phosphate sorption: (i) occurred irreversibly on anion exchange sites, with a loss of 1.9 moles of AEC per mole of phosphate sorbed, and (ii) was exothermic, with molar heats of adsorption between -25 and -39 kJmol(-1). Molar heats of adsorption were ten times that for anion exchange and independent of hydr(oxide) composition with the amount of energy evolved being directly proportional to the quantity of phosphate sorbed.     

Real meromorphic functions and linear differential polynomials

We determine all real meromorphic functions f in the plane such that f has finitely many zeros, the poles of f have bounded multiplicities, and f and F have finitely many non-real zeros, where F is a linear differential polynomial given by F = f (k) +Σk-1j=0ajf(j) , in which k≥2 and the coefficients aj are real numbers with a0≠0.     

Effect of Interfacial Alcohol Concentrations on Oil Solubilization by Sodium Dodecyl Sulfate Micelles

Alcohol partitioning and its effect on oil solubilization in Winsor Type I microemulsion systems was investigated. The microemulsion systems consisted of sodium dodecyl sulfate (SDS), pentanol, isopropanol (IPA), and dodecane, with either deionized water or an aqueous solution of 50 mM CaCl(2). Alcohol partitioning between aqueous, oil, and interfacial phases of the microemulsion was described using a pseudophase model in which the alcohol was assumed to self-associate in the oil phase. Partitioning in these miroemulsions was consistent with pentanol self-association in the oil phase. IPA did not self-associate but co-associated with pentanol in the oil phase. IPA concentrations as high as 20 g/kg of water had no effect on pentanol partitioning. The partition coefficient for pentanol between aqueous and interfacial phases was about 220 on a mole fraction basis. However, pentanol saturated the interfacial phase at a mole ratio of 3 : 1 pentanol to SDS. Addition of pentanol beyond that sufficient to saturate the interface resulted in large amounts of pentanol partitioning into the oil, reaching concentrations in excess of 25 g dL(-1) of oil phase. Dodecane solubilization increased linearly with pentanol mole fraction in the interface up to the 3 : 1 pentanol-to-SDS saturation level. The fact that dodecane solubilization was unaffected by pentanol at concentrations beyond those necessary for interfacial saturation suggests that pentanol behaves as a cosurfactant and not a cosolvent in these microemulsion systems. Copyright 2000 Academic Press.     

Sorption of inorganic nanoparticles in woven cellulose fabrics

Titanium dioxide was deposited from aqueous suspension onto cellulosic surfaces.Titania was sourced from Degussa (P25TM,70:30 anatase:rutile).Dry uptake of particles was shown to be rapid and dominant with one-third of the deposition occurring in less than 30 s and over one-half in the first minute.Isotherms were recorded to compare the rate of titanium deposition on dry and pre-wetted cotton.In the dry case uptake reached a maximum in 30 min whereas in the pre-wetted case the uptake was seen to continue beyond 180 min.A broad trend of higher deposition occurring at lower pH was seen,corresponding to the region where surface charges were opposite and thus attractive.Dry pickup was less significant at high pH.The response to varying ionic strength was complex and was attributed to the combined effect of charge screening,particle aggregation and consequent particle entrapment or occlusion.Titania deposition into the interstices of woven cotton sheets resulted in the formation of inorganic,nanoparticulate skeletons which could be isolated by controlled combustion of the cellulose and thus cotton was suggested to have potential for the templated synthesis of high surface area semiconductor materials.     

Effect of Pentanol Partitioning on Solubilization of Tetrachloroethylene and Gasoline by Sodium Dodecyl Sulfate Micelles

The effect of interfacial pentanol concentrations on solubilization of tetrachloroethylene (PCE) and gasoline by sodium dodecyl sulfate (SDS) micelles was compared to that for dodecane solubilization, which had been measured in a previous study. The solubilization of PCE and gasoline reached their maximum values at a 1 : 3 SDS-to-pentanol molar ratio in the interface. As pentanol concentrations increased beyond that necessary for interfacial saturation, solubilization of PCE and gasoline decreased. This behavior was similar to that observed when dodecane was the oil phase. Electrical conductivity of aqueous SDS/pentanol solutions followed a trend similar to that for oil solubilization, reaching a maximum value at a 1 : 3 molar ratio of SDS to pentanol in the interface. The results of this and previous studies suggest that pentanol partitioning in SDS micelles can be described by a simple two-region model: Region I is the interface between the water-continuous phase and oil and Region II is the micelle inner core. When the mole fraction of pentanol in the interface is less than 0.75, pentanol partitions strongly into Region I, where it acts as a cosurfactant along with SDS and enhances oil solubilization. Above 0.75 mole fraction in the interface, pentanol partitions strongly into Region II, where it acts as a polar oil and competes with other oils for solubilization. Copyright 2001 Academic Press.     

Syntheses and reactions of some fluorinated dienes,cyclobutenes and furans

There are many reports¹ of the pyrolysis of fluorinated organic compounds, including the defluorination of cyclic fluorocarbons over iron to give aromatic compounds. Extending this technique we have investigated the flow pyrolysis of some readily accessible unsaturated fluorocarbons, such as I, II, and III, and found these to be synthetically

useful routes to fluorinated dienes, cyclobutenes, and furans. Pyrolyses were carried out using a nitrogen flow over platinum, iron or caesium fluoride heated at 430–700°. The various products can all be rationalized in terms of intermediate allylic radicals, and the solid substrate influences which allylic radicals are formed.We are also investigating the chemistry of those now accessible compounds, such as IV, V, and VI, and some of the preliminary results are described.

For example the fluoride ion induced dimerisation of IV gave two major products VII and VIII via a particular interesting mechanism.